TITLE

An X-ray diffraction and transmission electron microscopy study of Pt–Ru fuel cell catalysts before and after operation

AUTHOR(S)
Roth, C.; Martz, N.; Fuess, H.
PUB. DATE
March 2004
SOURCE
Journal of Applied Electrochemistry;Mar2004, Vol. 34 Issue 3, p345
SOURCE TYPE
Academic Journal
DOC. TYPE
Other
ABSTRACT
Reports on the results of an x-ray diffraction and transmission electron microscopy study of Plutonium-Ruthenium fuel cell catalysts before and after operation. Catalyst characterization; Influence of catalyst structure on catalytic activity.
ACCESSION #
15102841

 

Related Articles

  • Low-cost alternative for precious fuel cell catalysts.  // Professional Engineering;10/18/2006, Vol. 19 Issue 19, p42 

    The article reports on the development of hydrogen fuel cell catalysts that were made of low-cost instead of precious metals by the Los Almos National Laboratory researchers in the U.S. The low-cost catalyts are composed of cobalt, polymer and carbon and is framed in a heteroatomic-polymer...

  • PROCESS TECHNOLOGY.  // Advanced Materials & Processes;Jan2011, Vol. 169 Issue 1, p12 

    The article offers news briefs related to the steel industry. It mentions the move of researchers from the University of Copenhagen to test a catalyst that does the actual work in fuel cells. It notes the move of Electrochem Technologies & Materials to develop an electrochemical technology that...

  • Investigation of the Electrochemical Behavior of Heat-Treated Carbon Blacks and Pt/C Catalysts. Huang, C. D.; Xiong, Z. T.; Lin, J. Y.; Tan, K. L. // Surface Review & Letters;Jun/Aug2002, Vol. 9 Issue 3/4, p1443 

    In this paper we report the electrochemical behavior of heat-treated carbon blacks and Pt/C catalysts. Cyclic voltammetry indicates that the heat-treated carbon black as catalyst support does not improve the Pt/C catalyst's activity for methanol oxidation. An XPS study of a Pt-loaded carbon...

  • Performance of dimethyl ether fuel cells using a Pt-Ru catalyst. Haraguchi, Tadao; Tsutsumi, Yasuyuki; Takagi, Hiroyuki; Tamegai, Naoaki; Yamashita, Susumu // Electrical Engineering in Japan;2/1/2005, Vol. 150 Issue 3, p19 

    Phenomena are presented whereby the performance of a dimethyl ether fuel cell (DDFC) at 80°C is much lower when a Pt-Ru catalyst is used on the anode than when a Pt catalyst is used, in contrast to the higher performance achieved using a Pt-Ru catalyst over a Pt catalyst in direct methanol...

  • UK university fuel cell produces electricity from hydrogen in air. Yeates, Harry // Electronics Weekly;10/26/2005, Issue 2215, p3 

    The article reports that the prospect of running small devices on electricity generated from a simple fuel cell running on atmospheric hydrogen and oxygen has been raised by research at the University of Oxford. Professor Fraser Armstrong used an enzyme rather than an expensive platinum catalyst...

  • Recovery and Reuse of Platinum catalyst from used fuel cells. Young-Ae Kim; Nansuk You; Ok-Sun Kim; Sung Jun Moon; Kyoung-Joon Oh; In-Seob Kwak; Jang-Sik Shin // International Journal of Chemical & Environmental Engineering;Apr2014, Vol. 5 Issue 2, p69 

    The demand for hard disks and fuel cell are increasing. Electrochemical reactions of polymer electrolyte fuel cell consist of at the anode and cathode of the oxidation-reduction reaction. Two electrodes, cathode and anode, are separated by a polymer electrolyte membrane. Oxidation and reduction...

  • NiCoFe/C cathode electrocatalysts for direct ethanol fuel cells. Park, Namsin; Shiraishi, Takeyuki; Kamisugi, Kazuyoshi; Hara, Yoshitaka; Iizuka, Keita; Kado, Takashi; Hayase, Shuzi // Journal of Applied Electrochemistry;Mar2008, Vol. 38 Issue 3, p371 

    A direct ethanol fuel cell (DEFC), which is less prone to ethanol crossover, is reported. The cell consists of PtRu/C catalyst as the anode, Nafion® 117 membrane, and Ni–Co–Fe (NCF) composite catalyst as the cathode. The NCF catalyst was synthesized by mixing Ni, Co, and Fe...

  • Preparing a catalyst layer in magnetic field to improve the performance of proton exchange membrane fuel cells. Sun, Xin; Xu, Hongfeng; Lu, Lu; Xing, Wangyan; Zhao, Hong // Journal of Applied Electrochemistry;Nov2014, Vol. 44 Issue 11, p1179 

    Electro catalyst Pt-Co/multi-walled C nanotubes were synthesized by using the modified polyol method with glycol as reducer. The magnetic-field-assisted fabrication of membrane electrode assemblies (MEAs) for proton exchange membrane fuel cells (PEMFCs) was proposed, to orient catalyst layers...

  • Alkaline Anion Exchange Membranes for Fuel Cells- A Patent Review. Zeng, Rong; Varcoe, John R. // Recent Patents on Chemical Engineering;Aug2011, Vol. 4 Issue 2, p93 

    Recently, Alkaline Polymer Electrolyte Membrane Fuel Cells (APEMFCs) have been attracting worldwide attention mainly due to the prospect of using non-platinum-group metal catalysts. In addition, there is growing evidence that these fuel cells can operate with the presence of carbonate. This mini...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics