TITLE

Erratum to: A comparison of the h-, p-, hp-, and rp-version of the FEM for the solution of the 2D Hertzian contact problem

AUTHOR(S)
Franke, David; D�ster, A.; N�bel, V.; Rank, E.
PUB. DATE
May 2010
SOURCE
Computational Mechanics;May2010, Vol. 45 Issue 6, p679
SOURCE TYPE
Academic Journal
DOC. TYPE
Erratum
ABSTRACT
A correction to the article "A Comparison of the h-, p-, hp-, and rp-version of the FEM for the Solution of the 2D Hertzian Contact Problem," that was published online on February 27, 2010 is presented.
ACCESSION #
48450106

 

Related Articles

  • Cracking of densely coated layer adhesively bonded to porous substrates under Hertzian stress. Kee Sung Lee; Sang Kyum Kim; Chul Kim; Tae Woo Kim; Do Kyung Kim // Journal of Materials Science;Nov2007, Vol. 42 Issue 21, p9116 

    A letter to the editor is presented in response to the article about material designing to suppress Hertzian contact stresses that was published in the previous issue.

  • Effects of impact loads on point contact elastohydrodynamic lubrication films. Kaneta, M.; Ozaki, S.; Nishikawa, H.; Guo, F. // Proceedings of the Institution of Mechanical Engineers -- Part J;Apr2007, Vol. 221 Issue 3, p271 

    The behaviours of point contact elastohydrodynamic lubrication (EHL) films under impact loads are investigated by direct observations using the optical interferometry technique. It has been found that when the initial impact gap is large, a central dimple is formed and the maximum film thickness...

  • Effects of assumed pressure distributions on the fundamental relation used in nanoindentation data analysis. Fu, Guanghui // International Journal of Mechanical Engineering Education;Jan2014, Vol. 42 Issue 1, p30 

    This short note shows that contact stiffness under a non-Hertzian pressure distribution is 33% higher than that under a Hertzian pressure distribution. This is due to the fact that there is no physical indenter that gives a non-Hertzian pressure distribution during elastic contact, and the...

  • UPON FRETTING BEHAVIOUR IN A HERTZIAN POINT CONTACT. IRIMESCU, Luminita; CIORNEI, Florina; Berthier, Yves // Annals of the University Dunarea de Jos of Galati: Fascicle: VII;2010, Vol. 16 Issue 2, p76 

    Fretting is known as a wear process occurring in a small amplitude cyclic motion of two solid contacting surfaces and it can affect the fatigue resistance of the material, inducing wear and cracking. The kinematics characteristics of movement yield to an interfacial micro-slip situation...

  • Anisotropy Influence of Cubic Solid on Dynamic Hertzian Contact Stiffness for a Vibrating Rigid Indenter. Jiayong Tian // American Journal of Engineering & Applied Sciences;2010, Vol. 3 Issue 1, p56 

    The article presents a study which investigates the anisotropy influence of cubic solid on Hertzian contact through dynamic contact stiffness of the rigid sphere and the semi-infinite cubic solid. It is observed that dynamic contact stiffness depends on the oscillating frequency and contact...

  • SYNTHESIS OF FLEXIBLE 4-BAR LINKAGE CONSIDERING DEFORMATION. Mishra, Ruby; Naskar, T. K.; Acharya, Sanjib // International Journal of Engineering Science & Technology;Jul2013, Vol. 5 Issue 7, p1345 

    In this paper synthesis of flexible 4-bar linkage with deformation is studied. Due to joint force deformation of the pin connecting the input link and coupler link and the coupler and output link are calculated considering bending and Hertzian contact stress. Deviation of coupler curve due to...

  • Characterizing Frictional Contact Loading via Isochromatics. Surendra, K.; Simha, K. // Experimental Mechanics;Jul2014, Vol. 54 Issue 6, p1011 

    Isochromatic patterns in the vicinity of frictional contacts furnish vital clues for characterizing friction. Though friction effects are evident in a diametrally loaded circular disk, three-point loading provides better results towards highlighting friction. In this paper, a new method of...

  • Heavy-duty bearings raise heavy-duty questions.  // Machine Design;9/11/2008, Vol. 80 Issue 17, p81 

    The article discusses the comment of reader Gary LaFayette that the equation of the contact half-width B between a shaft and its bushing is describes as Hertzian contact. The article's authors Dr. David Krus and Mike Gideon have stated that the equation for contact area has been correctly...

  • Solitary waves in a general class of granular dimer chains. Jayaprakash, K. R.; Vakakis, Alexander F.; Starosvetsky, Yuli // Journal of Applied Physics;Aug2012, Vol. 112 Issue 3, p034908 

    We report on a countable infinity of traveling solitary waves in a class of highly heterogeneous ordered one-dimensional granular media, in particular, granular dimers composed of an infinite number of periodic sets of 'heavy' elastic spherical beads in contact with N 'light' ones; these media...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics