TITLE

Radar Systems Now Rely On Data Converters

AUTHOR(S)
BROWNE, JACK
PUB. DATE
October 2013
SOURCE
Microwaves & RF;Oct2013, Vol. 52 Issue 10, pS7
SOURCE TYPE
Trade Publication
DOC. TYPE
Editorial
ABSTRACT
The article reflects that the radar systems are important in modern warfare strategies and also in commercial applications. It is said that radar technology is used in a wide array of military applications, but also in any number of non-defense-related ones. It is also said that analog-to-digital converters (ADCs) and digital-to-analog converters (DACs) are taking on more of the signal generation and analysis in radar systems.
ACCESSION #
91753174

 

Related Articles

  • 1 -Wire network controls remote SPI peripherals. Petersen, Michael // EDN Europe;Oct2008, Vol. 55 Issue 10, p70 

    The article focuses on the effectiveness of 1-Wire network to control remote Serial Peripheral Interface (SPI). Several 1-Wire compatible peripherals are available, but for those that lack the 1-Wire capability illustrates one way to implement it. This circuit allows a 1 Wire network to control...

  • Using Dither to Address Incongruence in Analog to Digital Converters. Lillington, John // Wireless Design & Development;Mar2004, Vol. 12 Issue 3, p28 

    Discusses the possible methods to reduce quantization spurs in Analog to Digital converters. Addition of Wideband Dither and Narrow Band dither; Results of not adding dither; Example of the calculation for the wideband dither case.

  • Infinera has photonics in the chips.  // CED;Mar2005, Vol. 31 Issue 3, p12 

    This article reports that Infinera Networks Corp. has developed a photonics platform that condenses and integrates multiple optical elements-Including lasers, modulators and receivers-onto one chip. Infinera, which was founded in 2001 and developed the silicon in-house, is using that technology...

  • Digital Converters.  // Mix;Dec2007, Vol. 31 Issue 12, p34 

    The article reports that analog-to-digital (A/D) and digital-to analog (D/A) converters are gateway processors, the superaccurate portals that pros rely on in digital audio production. According to the author, high-quality conversion is necessary whenever a master recording is being created or...

  • Over sample to the Extreme. Titus, Jon // Design News;11/3/2008, Vol. 63 Issue 16, p28 

    The article offers information on how a delta-sigma converter uses oversampling to produce results as many as 32 bits. The modulator portion of a delta-sigma converter acts like a low-pass filter for the unknown signal and as a high-pass filter for quantization noise. Because a delta-sigma...

  • A 12-Bit High-Speed Column-Parallel Two-Step Single-Slope Analog-to-Digital Converter (ADC) for CMOS Image Sensors. Tao Lyu; Suying Yao; Kaiming Nie; Jiangtao Xu // Sensors (14248220);2014, Vol. 14 Issue 11, p21603 

    A 12-bit high-speed column-parallel two-step single-slope (SS) analog-to-digital converter (ADC) for CMOS image sensors is proposed. The proposed ADC employs a single ramp voltage and multiple reference voltages, and the conversion is divided into coarse phase and fine phase to improve the...

  • Low-power DAC with charge redistribution sampling method for SAR ADCs. Yazdani, B.; Khorami, A.; Sharifkhani, M. // Electronics Letters;2/4/2016, Vol. 52 Issue 3, p187 

    A sampling and switching method for a binary weighted digital-to-analogue converter (DAC) in successive approximation register (SAR) analogue-to-digital converters (ADCs) is presented. This sampling method is proposed to reduce the switching energy. Thanks to the proposed switching method, only...

  • Improved dual-capacitive arrays DAC architecture for SAR ADC. Dong Li; Qiao Meng; Fei Li // Electronics Letters;6/9/2016, Vol. 52 Issue 12, p1013 

    An improved dual-capacitive arrays DAC (IDCA-DAC) architecture for successive approximation register ADC is presented. By using a switching-back switching scheme and a third reference voltage for the last bit conversion, the proposed IDCA-DAC architecture achieves 42% savings in average...

  • Whatever happened to my dynamic range? GREEN, STEVE // EDN;3/19/2009, Vol. 54 Issue 6, p47 

    The article considers the parameters when comparing measured results with analog-to-digital converters (ADC) and digital-to-analog converters (DAC). It reviews the relationship between signal-to-noise ratio, measurement bandwidth, and sample rate for audio ADCs, the inclusion of a weighting...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics