TITLE

A Thermodynamic and Experimental Study of Low-Alloy Steels After Carbonitriding in a Low-Pressure Atmosphere

AUTHOR(S)
Marray, T.; Jacquet, P.; Mansori, M.; Fabre, A.; Barrallier, L.
PUB. DATE
November 2014
SOURCE
Metal Science & Heat Treatment;Nov2014, Vol. 56 Issue 7/8, p434
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
The effect of the composition of two steels ( B and 6MnCr5) on precipitation of undesirable phases (carbides, nitrides and carbonitrides) under thermochemical treatment (low-pressure or vacuum carbonitriding) is investigated. Metallographic and x-ray diffraction studies and thermodynamic computations are performed.
ACCESSION #
99962728

 

Related Articles

  • Investigations of residual stress distributions in retained austenite and martensite after carbonitriding of a low alloy steel. Katemi, Richard J.; Epp, Jérémy; Hoffmann, Franz; Steinbacher, Matthias // Advanced Materials Research;2014, Vol. 996, p550 

    Specimens of low alloy steel were carbonitrided under different conditions to attain varying levels of carbon and nitrogen contents. The residual stress depth distribution was evaluated in martensite and retained austenite by X-ray diffraction. Beside standard evaluations, triaxial residual...

  • An Atom Probe Study of Kappa Carbide Precipitation and the Effect of Silicon Addition. Bartlett, Laura; Aken, David; Medvedeva, Julia; Isheim, Dieter; Medvedeva, Nadezhda; Song, Kai // Metallurgical & Materials Transactions. Part A;May2014, Vol. 45 Issue 5, p2421 

    The influence of silicon on κ-carbide precipitation in lightweight austenitic Fe-30Mn-9Al-(0.59-1.56)Si-0.9C-0.5Mo cast steels was investigated utilizing transmission electron microscopy, 3D atom-probe tomography, X-ray diffraction, ab initio calculations, and thermodynamic modeling....

  • X-RAY DIFFRACTION ANALYSIS OF A CARBONITRIDED LAYER OF ARMCO-IRON. ZUMBILEV, Ilia A. // Annals of the Faculty of Engineering Hunedoara - International J;Nov2015, Vol. 13 Issue 4, p131 

    Nitriding and carbonitriding are basic processes for surface hardening of details and tools made of iron-carbon alloys, during which either nitrogen only or both carbon and nitrogen are simultaneously introduced into the surface layer. In case of conducting these two processes in conventional...

  • Effect of Ni on Corrosion Resistance of Weathering Steels in wet/dry Environments. Rui Liu; Xiaoping Chen; Qingnan Shi // Advanced Materials Research;7/24/2014, Vol. 989-994, p420 

    Corrosion behavior of a low alloy steel A with 3% nickel content was studied by a wet/dry cyclic test. A commercial weathering steel Q450NR1 was used for comparison. The classical weight loss method was used to evaluate the weatherability of weathering steel, while the iron rust layers formed on...

  • N-bromohexamethyldisilazane: Investigation of properties and thermodynamic simulation of precipitation of thin-layer structures from the vapor phase. Rakhlin, V. I.; Nikulina, L. D.; Sysoev, S. V.; Chernyavskii, L. I.; Kosinova, M. L.; Titov, A. A.; Podgorbunskaya, T. A.; Voronkov, M. G. // Glass Physics & Chemistry;Feb2011, Vol. 37 Issue 1, p60 

    N-Bromohexamethyldisilazane has been characterized using an elemental analysis and IR, UV, H NMR, C NMR, and Si NMR spectroscopy. The spectral characteristics of the compound have been determined and the saturated vapor pressure has been measured. The thermodynamic simulation of the chemical...

  • Biologically induced precipitation in urine-collecting systems. K.M. Udert; T.A. Larsen; W. Gujer // Water Science & Technology: Water Supply;2003, Vol. 3 Issue 3, p71 

    Precipitation in urine-separating toilets (NoMix toilets), waterless urinals, and conventional urinals causes severe maintenance problems. Additionally, the partial fixation of nutrients in precipitates may affect the later use and treatment of source-separated urine. The goal of this study was...

  • Effect of Cr-doping on the structural and optical properties of CdS nanoparticles prepared by chemical precipitation method. Thambidurai, M.; Muthukumarasamy, N.; Velauthapillai, Dhayalan; Murugan, N.; Chaudhuri, Jharna; Parameswaran, Siva; Marathe, Archis; Agilan, S.; Balasundaraprabhu, R. // Journal of Materials Science: Materials in Electronics;Feb2012, Vol. 23 Issue 2, p618 

    Undoped and Cr doped CdS nanoparticles have been prepared by chemical precipitation method. X-ray diffraction analysis reveals that the undoped and Cr doped CdS nanoparticles exhibit hexagonal structure and the average particle size of the nanoparticles is in the range of 2.2-3.8 nm. The HRTEM...

  • Adsorbents Derived from Mg-Al Hydrotalcite-Like Compounds for High-Temperature Hydrogen Storage. Ibrahim, R.; Lwin, Y. // Journal of Applied Sciences;2010, Vol. 10 Issue 12, p1128 

    The coprecipitation method was used to prepare Mg-Al Hydrotalcite-like compounds (HTlcs). The precipitated and calcined Mg-Al HTlcs were characterized using powder X-Ray Diffraction (XRD) and Fourier transform infrared (FTIR) spectroscopy. The XRD patterns for the materials indicated the...

  • Purification of Empty Fruit Bunch (EFB) and Kenaf Soda Lignin with Acidified Water. Syed Hashim, Sharifah Nurul Ain; Zakaria, Sarani; Syed Jaafar, Sharifah Nabihah; Chia Chin Hua // AIP Conference Proceedings;2014, Vol. 1614, p129 

    In this current study, the soda lignins from empty fruit bunch (EFB) and kenaf core were recovered by two step precipitation method. The objective of this research is to study the purity of lignin by washing the lignins with acidified water. The purified lignins were undergone characterization...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics