TITLE

High input impedance DC servo loop circuit

AUTHOR(S)
Spinelli, E.
PUB. DATE
November 2014
SOURCE
Electronics Letters;11/20/2014, Vol. 50 Issue 24, p1808
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
DC suppression is a common instrumentation signal processing technique, used to reject spurious DC components and thus allow centring of the signal between the power supply rails and exploitation of all the available voltage range. A generic DC servo loop that presents high input impedance and can work as a front-end is proposed. It is designed to be implemented with standard operational amplifiers, to offer solutions for 'board level' analogue instrumentation design. The main features of the circuit are analysed, and analytical expressions are provided for its adaptation for solving different instrumentation problems.
ACCESSION #
99701262

 

Related Articles

  • Broadband peaking techniques for HEMT-based monolithic transimpedance amplifiers. Giannini, Franco; Limiti, Ernesto; Orengo, Giancarlo; Saggio, Giovanni // Microwave & Optical Technology Letters;2/5/2000, Vol. 24 Issue 3, p147 

    This paper describes the design and performances of a multigigabit optical front-end circuit. A new inductor-peaking technique has been applied to a GaAs MMIC transimpedance preamplifier realized in pseudomorphic HEMT technology. The peaking circuit is capable of resonating the total input...

  • Grounded capacitor current mode single resistance-controlled oscillator using single modified current differencing transconductance amplifier. Biolek, D.; Keskin, A. Ü.; Biolkova, V. // IET Circuits, Devices & Systems;Nov2010, Vol. 4 Issue 6, p496 

    This study proposes a current mode canonical single resistance-controlled oscillator (SRCO) circuit based on a single modified current differencing transconductance amplifier. The circuit employs grounded capacitors and provides a current output with high output impedance. The proposed circuit...

  • DOUBLE ZERO-POLE CANCELLATION FOR BANDWIDTH EXTENSION OF TRANSIMPEDANCE AMPLIFIERS. GHASEMI, OMIDREZA // Journal of Circuits, Systems & Computers;May2012, Vol. 21 Issue 3, p1250021-1 

    In this paper, double zero-pole cancellation for BandWidth (BW) extension of Transimpedance Amplifiers has been introduced. The effect of parasitic capacitances of the MOS transistor has been reduced using the mentioned approach. The process of zero-pole cancellation to extend the BW of the...

  • Dual op amp takes absolute difference. St Angel, Lindo // EDN;6/7/2012, Vol. 57 Issue 11, p52 

    The article presents a design that implements the absolute-difference function of a dual operational amplifier (op amp). The design circuit employs two single-supply ground-referenced op amps for direct current (dc) or low-speed operation. The other components of the design circuit include...

  • Audio-test accessory isolated and matches loads.  // EDN;3/16/2006, Vol. 51 Issue 6, p77 

    The article provides information on connecting a 600Ω audio circuit to a 50 or 75Ω circuit or test instrument which requires an impedance-matching circuit or, a transformer, when isolation of the circuits is necessary. A conventional transformer can match impedance with low typical losses...

  • CALCULATING PDS IMPEDANCE. Brooks, Doug G. // SMT: Surface Mount Technology;Sep2010, Vol. 25 Issue 5, p28 

    The article discusses how to calculate the impedance of a power distribution system (PDS). A PDS system distributes power from the power source to various chips and devices that need power. It is stated that for an ideal power distribution system, high impedance is needed at direct current (DC),...

  • New coupled-line dual-band dc-block transformer for arbitrary complex frequency-dependent load impedance. Wu, Yongle; Liu, Yuanan; Li, Shulan; Yu, Cuiping // Microwave & Optical Technology Letters;Jan2012, Vol. 54 Issue 1, p139 

    A novel impedance transformer is constructed by interpolating coupled line in this article. This proposed coupled-line transformer not only has arbitrary dual-band operation for arbitrary complex frequency-dependent load impedance but also features inherent DC-block function. The design of its...

  • A NOVEL HIGH-POWER AMPLIFIER USING A GENERALIZED COUPLED-LINE TRANSFORMER WITH INHERENT DC-BLOCK FUNCTION. Wu, Y.; Liu, Y.; Li, S. // Progress in Electromagnetics Research;Oct2011, Vol. 119, p171 

    The purpose of this paper is to propose a novel generalized single-band transformer for two arbitrary complex load and source impedances and a novel high-power amplifier using this new transformer. By adding two reactive parts at across terminals, the coupled line with flexible electrical length...

  • Anatomy of current-feedback op amp. Mancini, Ron // EDN;12/5/2005, Vol. 50 Issue 25, p40 

    The article describes the performance analysis of a current-feedback op amp (CFOA). When the apparatus is connected to the input of a voltage buffer, it will have a high impedance. Because the signals are accoupled or small or they contain no information in the direct current content, few...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics