January 2014
Hidraulica;2014, Issue 1, p26
Academic Journal
The theory to the lubrication of diarthrodial joints that contains as well the hip joint was described in the previous articles [4], [5], [6], [7]. In this article, we would like to deal with the simulation and possible simplification of fluid flow in the gap of hip joint.


Related Articles

  • Transient elastohydrodynamic lubrication analysis of ultra-high molecular weight polyethylene hip joint replacements. Jalali-Vahid, D; Jin, Z M // Proceedings of the Institution of Mechanical Engineers -- Part C;Apr2002, Vol. 216 Issue 4, p409 

    The cyclic variation in both the load and speed experienced during walking was considered in an elastohydrodynamic lubrication (EHL) analysis for artificial hip joint replacements in this study. A general numerical procedure was developed to take both the entraining and squeeze-film actions into...

  • EXPERIMENTAL INVESTIGATION ON THE WALL SLIP OF A LOW VISCOSITY SLEEVE BEARING. LI-LI WANG; MIN WANG; XIAO-ZHEN DU; CHUN-JIAN SU // Journal of the Balkan Tribological Association;9/30/2016, Vol. 22 Issue 3-II, p2652 

    The unique structure of spiral oil wedge sleeve bearing causes that the lubricant flows into the bearing through inlet hole and most oil flows out of the bearing through the oil return hole of bearing. Using the flow characteristic of spiral oil wedge sleeve bearing, the wall slip is studied...

  • The Effect of Composition and Temperature on the Rheological Properties of Greases Based on Calcium Soaps. Sterpu, Ancaelena Eliza; Teodorescu, Nicoleta; Prodea, Iuliana Marlena; Neagu, Anişoara; Dumitru, Anca Iuliana // International Review of Chemical Engineering - Rapid Communicati;Jan2010, Vol. 2 Issue 1, p81 

    The knowledge of the rheological properties of the greases based on calcium soaps is important because these properties ensure proper oiling of moving metallic parts of machines at high charges and in a large temperature range. In the present study, four greases has been prepared with different...

  • Shock-wave solutions in two-layer channel flow. II. Linear and nonlinear stability. Mavromoustaki, A.; Matar, O. K.; Craster, R. V. // Physics of Fluids;Nov2011, Vol. 23 Issue 11, p112101 

    We investigate the flow of two immiscible fluids in an inclined channel, building on the work presented in Part I of this study. In this paper, we examine the stability of the flow to spanwise perturbations in both the linear and nonlinear regimes. The evolution equation governing the...

  • Synergetic model of boundary friction taking into account spatial nonuniformity of stresses, strain, and temperature. Lyashenko, I.; Manko, N. // Technical Physics;Dec2014, Vol. 59 Issue 12, p1737 

    Spatial nonuniformity of stresses, strain, and temperature of a lubricating layer is taken into account in the context of the synergetic model. We consider the motion of interacting surfaces in opposite directions with identical velocities as well as the situation when the lower surface is...

  • Nonlinear Drainage of Some Non-Newtonian Free Films. Tabakova, S. // AIP Conference Proceedings;2015, Vol. 1684 Issue 1, p1 

    In the present work we apply the generalized lubrication approach (including inertial, viscous, capillary and van-der- Waals forces) to study the dynamics of a free thin film of a non-Newtonian fluid, whose viscosity is described by the Power law and Carreau models. For planar films with fully...

  • Please describe an incident where used oil analysis averted a potentially serious problem.  // Tribology & Lubrication Technology;Aug2011, Vol. 67 Issue 8, p62 

    The article focuses on specific instances where used oil analysis prevented machine failures and complete breakdowns, saving millions of dollars. It mentions occasions where detection of glycol and fuel in engine oil has avoided premature engine failure. It states that a used oil analysis report...

  • When is CM the objective? Poley, Jack // Tribology & Lubrication Technology;Sep2004, Vol. 60 Issue 9, p63 

    Discusses the properties considered for the inspection of lubricants. Factors that can lower and raise viscosity; Common cause of lubricant darkening; Types of lubricant degradation.

  • Oil/Thickener Interactions and Rheology of Lubricating Greases. Salomonsson, Linda; Stang, Gunnar; Zhmud, Boris // Tribology & Lubrication Technology;Dec2007, Vol. 63 Issue 12, p38 

    The present communication concerns the effect of base oil/thickener interaction on the flow properties of lubricating greases. The flow properties of paraffinic and naphthenic lithium greases in the temperature range from -40°C to 60°C have been characterized by using the traditional flow...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics