TITLE

High Tc superconducting films of Y-Ba-Cu oxide prepared by low-pressure plasma spraying

AUTHOR(S)
Tachikawa, K.; Watanabe, I.; Kosuge, S.; Kabasawa, M.; Suzuki, T.; Matsuda, Y.; Shinbo, Y.
PUB. DATE
March 1988
SOURCE
Applied Physics Letters;3/21/1988, Vol. 52 Issue 12, p1011
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
A low-pressure plasma spraying technique for depositing high Tc Y-Ba-Cu-O thick films has been developed. Films with a thickness range of 20–100 μm have been prepared by using Y0.3Ba0.7CuOx powders. After post-annealing in oxygen for 1 h at 950 °C, the films, which were deposited on a nimonic alloy substrate heated at 650 °C during spraying, exhibited a zero resistance temperature of 90.6 K with a transition width (90%–10%) of 2 K and a critical current density (77 K, 0 T) of 690 A/cm2.
ACCESSION #
9826284

 

Related Articles

  • Low-resistivity, YBa2Cu3O7-to-silver electrical contacts by plasma spraying. Katz, J. D.; Willis, J. O.; Maley, M. P.; Castro, R. G. // Journal of Applied Physics;2/15/1989, Vol. 65 Issue 4, p1792 

    Presents a study which developed a simple cost-effective method for the fabrication of low-resistivity contacts for high-temperature superconducting ceramics. Measurement of surface resistivities; Electrical properties of the contacts fabricated in the study; Description of plasma spraying...

  • Superconducting coatings in the system Bi-Ca-Sr-Cu-O prepared by plasma spraying. Asthana, A.; Han, P. D.; Falter, L. M.; Payne, D. A.; Hilton, G. C.; Van Harlingen, D. J. // Applied Physics Letters;8/29/1988, Vol. 53 Issue 9, p799 

    Superconducting coatings in the system Bi-Ca-Sr-Cu-O were deposited on alumina substrates by plasma spray methods. The coatings were superconducting in the ‘‘as-sprayed’’ condition and improved with heat treatment. The best results were for coatings with resistivity...

  • Texture growth processing of plasma-sprayed Y-Ba-Cu-O superconducting deposits. Wang, H.; Herman, H.; Wiesmann, H. J.; Zhu, Y.; Xu, Youwen; Sabatini, R. L.; Suenaga, M. // Applied Physics Letters;12/3/1990, Vol. 57 Issue 23, p2495 

    A partial melt/texture growth process has been applied to plasma-sprayed YBa2Cu3O7-x deposits. The length of the aligned grains is in the range 300–500 μm. Small-angle grain boundaries with a misorientation between 3° and 5° are commonly observed. The critical current density,...

  • Reduced moisture-induced degradation of YBaCuO superconducting films by silver and high deposition temperatures. Chang, Chin-An // Applied Physics Letters;9/19/1988, Vol. 53 Issue 12, p1113 

    Moisture-induced degradation of the YBaCuO superconducting films is studied using layer structures deposited at low temperatures with and without a silver covering layer, and using films deposited at high temperatures with a silver barrier layer. For the former, Ag/Cu/BaO/Y2O3/YSZ and...

  • Formation of p-n junction by plasma spraying technique to enhance the photocatalytic activity of TiO2. Ye, F.; Ohmori, A.; Li, Changjiu // Journal of Materials Science;Jan2004, Vol. 39 Issue 1, p353 

    Examines the formation of micro p-n junction by plasma spraying to enhance the photocatalytic activity of titanium dioxide semiconductor films. Composition of sprayed coatings; Photocatalytic activity of the sprayed coatings; Photocurrent density of the films.

  • The Stability of Wide High-Temperature Superconducting Films with Varying Transport Current. Buznikov, N. A.; Pukhov, A. A.; Rakhmanov, A. L. // Technical Physics;Mar2000, Vol. 45 Issue 3, p362 

    The current-carrying capacity of a wide high-temperature superconducting film under conditions of rapid injection of current is investigated theoretically. An analytic expression is derived for the rate of current injection into the film at which a marked degradation of the current-carrying...

  • Band-pass microstripe filters using high-temperature superconducting films. Vendik, I. B.; Kondrat�ev, V. V.; Svishchev, A. A.; Leppyavuori, S.; Yakku, �. // Technical Physics Letters;Dec98, Vol. 24 Issue 12, p968 

    Results are presented of a simulation and experimental investigation of band-pass filters consisting of coupled microstripe resonators fabricated using high-temperature superconducting films. It was shown that by using reliable models of high-temperature superconducting filter elements and...

  • Preparation of superconducting Ba[sub 2]YCu[sub 3]O[sub 7-y]-Ag composite films on sapphire by.... Manabe, T.; Kondo, W. // Applied Physics Letters;6/29/1992, Vol. 60 Issue 26, p3301 

    Examines the preparation of superconducting Ba[sub 2]YCu[sub 3]O[sub 7-y]-Ag composite films on sapphire substrates. Absence of a buffer layers; Application of the dipping pyrolysis process; Determination of superconducting transition temperatures.

  • Ion beam thinning and polishing of YBa2Cu3O7 films. Hebard, A. F.; Fleming, R. M.; Short, K. T.; White, A. E.; Rice, C. E.; Levi, A. F. J.; Eick, R. H. // Applied Physics Letters;10/30/1989, Vol. 55 Issue 18, p1915 

    Successive ion beam milling at grazing angles of a 2400-Ã…-thick, c-axis-oriented YBa2Cu3O7 film is shown to give smooth films which superconduct at thicknesses on the order of tens of angstroms. The thinning and polishing process is characterized at successive milling stages using resistance...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics