TITLE

Minority-carrier mobility anomalies in low-resistivity silicon solar cells

AUTHOR(S)
Weizer, V. G.; DeLombard, R.
PUB. DATE
July 1986
SOURCE
Applied Physics Letters;7/28/1986, Vol. 49 Issue 4, p201
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Measurement of the minority-carrier mobility in the base region of the high-voltage metal-insulator-N-P solar cell, as well as in other 0.1 Ω cm cells, provides direct proof that the high voltages measured for that cell are due not only to improved emitter characteristics but to an improved base region as well. The base characteristics are shown to be quite sensitive to the effects of diffusion induced lattice stress originating in the emitter. The implications of these findings with regard to the fabrication of high efficiency cells are discussed.
ACCESSION #
9820436

 

Related Articles

  • Silicon solar cell of 16.8 mum thickness and 14.7% efficiency. Werner, Jurgen H.; Kolodinski, Sabine; Rau, Uwe; Arch, John K.; Bauser, Elisabeth // Applied Physics Letters;6/7/1993, Vol. 62 Issue 23, p2998 

    Examines the efficiency of silicon solar cells. Growth of solar cells by liquid phase epitaxy; Indication of the internal quantum efficiency measurement analysis; Conversion efficiency rating of the solar cells.

  • Combined impurity gettering and defect passivation in polycrystalline silicon solar cells. Verhoef, L. A.; Michiels, P-P.; Sinke, W. C.; Denisse, C. M. M.; Hendriks, M.; van Zolingen, R. J. C. // Applied Physics Letters;12/17/1990, Vol. 57 Issue 25, p2704 

    Polycrystalline silicon wafers have been subjected to annealing (700 °C, 1 h) and to a hydrogen plasma (350 °C, 30 min) during the processing of solar cells. The annealing treatment enhances the bulk minority-carrier recombination lifetime by 19%, presumably by impurity gettering. The...

  • Spin dependent photocurrents in ribbon solar cells. Seager, C.H.; Venturini, E.L. // Applied Physics Letters;4/6/1992, Vol. 60 Issue 14, p1732 

    Examines the microwave resonance induced variations in the short circuit photocurrent of edge-defined film-fed growth ribbon silicon solar cells. Dependence of spin dependent transport (SDT) on cell illumination levels; Details on the SDT signal-to-noise ratio; Observation on the SDT response.

  • Effect of localized grain boundaries in semicrystalline silicon solar cells. Shimokawa, Ryuichi; Hayashi, Yutaka // Journal of Applied Physics;4/1/1986, Vol. 59 Issue 7, p2571 

    Present a study which measured the spatial variation of minority-carrier diffusion length in the vicinity of a boundary surface in monocrytalline and semicrystalline silicon solar cells. Experiment; Results and discussion; Conclusion.

  • Rear surface passivation of high-efficiency silicon solar cells by a floating junction. Altermatt, Pietro P.; Heiser, Gernot; Dai, Ximing; Jürgens, Jörn; Aberle, Armin G.; Robinson, Steven J.; Young, Trevor; Wenham, Stuart R.; Green, Martin A. // Journal of Applied Physics;9/15/1996, Vol. 80 Issue 6, p3574 

    Provides information on a study which investigated the rear surface passivation of high-efficiency silicon solar cells by a floating junction. Structure of the solar cell; Methodology of the study; Results and discussion.

  • 20% efficiency silicon solar cells. Blakers, A. W.; Green, M. A. // Applied Physics Letters;1/20/1986, Vol. 48 Issue 3, p215 

    Further improvements in crystalline silicon solar cell performance have been obtained by combining the high levels of surface recombination control demonstrated in earlier passivated emitter solar cells with an improved optical approach. This approach involves the use of microgrooved surfaces...

  • Enhancement of open circuit voltage in high efficiency amorphous silicon alloy solar cells. Guha, S.; Yang, J.; Nath, P.; Hack, M. // Applied Physics Letters;7/28/1986, Vol. 49 Issue 4, p218 

    We have developed a microcrystalline fluorinated p+ silicon alloy which has high dark conductivity and low optical loss. Incorporation of this material in single and tandem amorphous silicon alloy based solar cells has resulted in increased open circuit voltage and conversion efficiency.

  • 18% efficient intrinsically passivated laser-processed silicon solar cells. Wood, R. F.; Westbrook, R. D.; Jellison, G. E. // Applied Physics Letters;1/12/1987, Vol. 50 Issue 2, p107 

    It is demonstrated that single-crystal silicon solar cells with efficiencies greater than 18% AM1.5 can be fabricated by glow discharge implantation and pulsed excimer laser annealing. A unique characteristic of these cells is that the surfaces are passivated intrinsically to give open circuit...

  • Glow-discharge-implanted, thermally annealed, oxide-passivated silicon solar cells of 19% efficiency. Westbrook, R. D.; Wood, R. F.; Jellison, G. E. // Applied Physics Letters;2/23/1987, Vol. 50 Issue 8, p469 

    Single-crystal silicon solar cells with efficiencies as high as 19.3% AM1.5 have been fabricated using simple, glow-discharge ion implantation followed by conventional furnace annealing during which an oxide layer was grown for surface passivation. Fine-line (∼5 μm) photolithography was...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics