TITLE

Hydrogen absorption and desorption in Nd2Fe14B

AUTHOR(S)
Cadogan, J. M.; Coey, J. M. D.
PUB. DATE
February 1986
SOURCE
Applied Physics Letters;2/10/1986, Vol. 48 Issue 6, p442
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Absorption and desorption of hydrogen by the permanent magnet material Nd2Fe14B have been studied using a microcomputer-controlled, thermomanometric analyzer with an initial hydrogen pressure of approximately 1 bar. Primary absorption occurs in the range 200–300 °C and results in the formation of a stable hydride with increased lattice parameters and Curie temperature. Subsequent hydrogen desorption, which is virtually complete by 650 °C, leaves the sample in an intermediate state. A second absorption step at about 720 °C corresponds to disproportionation of the Nd2Fe14B phase into α-Fe, Fe2B, and NdH2. Desorption of hydrogen from a hydrogenated sample heated in vacuum is maximum at 300 °C.
ACCESSION #
9819064

 

Related Articles

  • Accelerated method of choosing selective absorbents for extraction of hydrogen sulfide from hydrocarbon gases. Ganizheva, L.; Ponomarenko, D.; Borisova, T. // Chemical & Petroleum Engineering;Nov2010, Vol. 46 Issue 11/12, p722 

    a rule, selective properties of promising absorbents are studied in pilot plants in film, packed, or plate absorbers. Such an approach makes it possible to determine the influence exerted on the efficiency of the process by the nature of the absorbent, the structural characteristics of the...

  • Adsorption of uranium(VI) from aqueous solutions using cross-linked magnetic chitosan beads. Huang, Guolin; Zou, Lixia; Su, Yu; Lv, Tingting; Wang, Lele // Journal of Radioanalytical & Nuclear Chemistry;Feb2016, Vol. 307 Issue 2, p1135 

    The performance of a cross-linked magnetic chitosan has been investigated for the adsorption of U(VI) from aqueous solutions. The influences of the pH of solution, the initial concentration of U(VI) ions and the contact time on the adsorption amounts have been discussed, and the appropriate...

  • Formation and microwave absorption of barium and strontium ferrite prepared by sol-gel technique. Surig, C.; Hempel, K.A. // Applied Physics Letters;11/15/1993, Vol. 63 Issue 20, p2836 

    Examines the formation and microwave absorption of barium and strontium ferrite prepared by sol-gel technique. Determination of magnetization, coercive and anisotropy field strengths; Investigation of the formation process of the hexaferrite phase during heat treatment; Indication of...

  • Electromagnetic and absorption properties of some microwave absorbers. Yusoff, A. N.; Abdullah, M. H.; Ahmad, S. H.; Jusoh, S. F.; Mansor, A. A.; Hamid, S. A. A. // Journal of Applied Physics;7/15/2002, Vol. 92 Issue 2, p876 

    Electromagnetic properties of a thermoplastic natural rubber (TPNR), a lithium-nickel-zinc (LiNi-Zn) ferrite and a TPNR-ferrite composite subjected to transverse electromagnetic (TEM) wave propagation were investigated. The incorporation of the ferrite into the matrix of the TPNR was found to...

  • Complex permittivity, permeability, and X-band microwave absorption of CaCoTi ferrite composites. Singh, Praveen; Babbar, V. K.; Razdan, Archana; Puri, R. K.; Goel, T. C. // Journal of Applied Physics;5/1/2000, Vol. 87 Issue 9, p4362 

    The effect of Co[sup 2+]Ti[sup 4+] substitution on complex permeability, permittivity, and microwave absorption has been studied for [Ca(CoTi)[sub x]Fe[sub 12-2x]O[sub 19]][sub 96.0][La[sub 2]O[sub 3]][sub 4.0] ferrite-epoxy composites, wherein x varies from 0 to 1.0 in steps of 0.2, in the...

  • Influence Of BaTiO3 Powder Additions On The Electromagnetic Wave Absorption Of Fe-Based Nanocrystalline P/M Sheets. Cho, E. K.; Woo, S. J.; Cho, H. J.; Kim, M.; Sohn, K. Y.; Park, W. W. // AIP Conference Proceedings;4/24/2008, Vol. 1003 Issue 1, p88 

    The magnetic properties of the amorphous Fe73Si16B7Nb3Cu1 (at%) powder were controlled by the optimization of crystallization treatment. The Fe-based nanocrystalline soft magnetic powders were tape-casted and dried to form the EM wave absorption sheets after mixing with a polymeric binder and a...

  • Corrosion-electrochemical properties of α-Fe + FeC + TiC nanocomposites in acidic sulfate solutions. Syugaev, A.; Lomaeva, S.; Lyalina, N.; Reshetnikov, S. // Protection of Metals & Physical Chemistry of Surfaces;May2011, Vol. 47 Issue 3, p320 

    Corrosion-electrochemical properties of model α-Fe + FeC + TiC three-phase nanocrystalline composites in acidic sulfate solutions are studied. Anodic processes on α-Fe + FeC + TiC composites are determined chiefly by the oxidation of ferrite and cementite components. The passivation of...

  • Role of Microstructure in Susceptibility to Hydrogen Embrittlement of X70 Microalloyed Steel. Hejazi, Daniel; Saleh, Ahmed; Haq, Ayesha; Dunne, Druce; Calka, Andrzej; Gazder, Azdiar A.; Pereloma, Elena V. // Materials Science Forum;2014, Vol. 783-786, p961 

    The effect of phases and steel processing on hydrogen uptake (diffusible and residual), surface and internal damage were evaluated using optical and scanning electron microscopy. The results have shown the fastest formation of blisters in ferrite-pearlite microstructure of strip, followed by...

  • A model of the Temkin isotherm behavior for hydrogen adsorption at Pd-SiO2 interfaces. Eriksson, M.; Lundstrom, I. // Journal of Applied Physics;9/15/1997, Vol. 82 Issue 6, p3143 

    Presents a simple electrostatic model of the adsorbate-adsorbate interaction of hydrogen atoms at a Pd-SiO2 interface. Prediction of a hydrogen adsorption isotherm of the Temkin type; Description of the hydrogen sensitive Pd-MOS structure; Measurement of atmospheric pressures.

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics