TITLE

Epitaxial growth of (100)CdTe on (100)GaAs induced by pulsed laser evaporation

AUTHOR(S)
Dubowski, J. J.; Williams, D. F.; Sewell, P. B.; Norman, P.
PUB. DATE
June 1985
SOURCE
Applied Physics Letters;6/1/1985, Vol. 46 Issue 11, p1081
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Epitaxial (100) CdTe films were grown on the (100) GaAs surface by pulsed laser evaporation. The growth was achieved on substrates held at 260 °C and under a pressure of about 8×10-8 Torr. High-energy electron diffraction, x-ray diffraction, and UV reflectivity studies have shown that epilayers of high crystalline quality were obtained. The surface morphology of films thicker than about 0.4 μm approached atomic smoothness. No incorporated impurities, including oxygen and carbon, were found by Auger electron spectroscopy in the films studied.
ACCESSION #
9817630

 

Related Articles

  • SrCuO[sub 2]/(Sr,Ca)CuO[sub 2] superlattice growth by pulsed-laser deposition. Norton, D.P.; Budai, J.D. // Applied Physics Letters;11/28/1994, Vol. 65 Issue 22, p2869 

    Demonstrates the growth of strontium copper dioxide/(strontium, calcium) copper dioxide superlattices structures in the tetragonal, infinite layer crystal structure using conventional pulsed-laser deposition. Observation of superlattice chemical modulation; Indication of x-ray diffraction...

  • Superlattices of Y-Ba-Cu-O/Yy-Pr1-y-Ba-Cu-O grown by pulsed laser deposition. Wu, X. D.; Xi, X. X.; Li, Q.; Inam, A.; Dutta, B.; DiDomenico, L.; Weiss, C.; Martinez, J. A.; Wilkens, B. J.; Schwarz, S. A.; Barner, J. B.; Chang, C. C.; Nazar, L.; Venkatesan, T. // Applied Physics Letters;1/22/1990, Vol. 56 Issue 4, p400 

    Superlattices of YBa2Cu3O7-x/YyPr1-yBa2Cu3O7-x(y=0.8 and 0.0) have been successfully grown in situ on MgO and LaAlO3 by using a multitarget pulsed laser deposition system. Satellite peaks have been observed in x-ray diffraction for the superlattices with modulation wavelengths from about few...

  • Structural ordering and chemical configuration of Ba-based infinite-layer superlattices. Del Vecchio, A.; Mirenghi, L.; De Caro, L.; Tapfer, L.; Aruta, C.; Petrocelli, G.; Balestrino, G. // Journal of Applied Physics;12/1/1997, Vol. 82 Issue 11, p5465 

    Presents a structural and microanalytical study of BaCuO2/CaCuO2 superlattices grown on (001) SrTiO3 substrates by pulsed laser deposition technique. Growth procedure and characterization techniques; Change in the dc resistance of superlattice samples with the increase of time; Fabrication of...

  • Enhanced stability of rocksalt-type AIN phase in AIN/TiN superlattices synthesized by room-temperature pulsed laser deposition. Pankov, V.; Evstigneev, M.; Prince, R. H. // Journal of Applied Physics;10/15/2002, Vol. 92 Issue 8, p4255 

    AlN/TiN superlattice coatings with bilayer thickness, Λ, of 1-20 nm were synthesized by pulsed laser deposition (PLD) at room temperature. Below a critical value of bilayer thickness, Λ[SUBc] ≈ 3 nm, the coatings formed a single-phase NaCl-type structure due to pseudomorphic...

  • Facet degradation of GaN heterostructure laser diodes. Schoedl, Thomas; Schwarz, Ulrich T.; Kümmler, Volker; Furitsch, Michael; Leber, Andreas; Miler, Andreas; Lell, Alfred; Härle, Volker // Journal of Applied Physics;6/15/2005, Vol. 97 Issue 12, p123102 

    We investigated the degradation of cleaved facets of (Al,In)GaN laser diodes in different atmospheres. We found that operation in water-free atmospheres with sufficient oxygen shows a slow degradation. Operation in atmospheres with water vapor causes a fast degradation and an oxidation on the...

  • Development of microstructure in Cr and Cr/CoCrPt films made by pulsed laser deposition. Shima, M.; Ross, C. A. // Journal of Applied Physics;1/15/2003, Vol. 93 Issue 2, p945 

    Cr films and Cr/CoCrPt bilayer films have been grown using ion-beam-assisted pulsed laser deposition (PLD). High mobility conditions such as a substrate temperature above 350 °C, a low deposition rate, and a high laser energy promote the formation of a {100} bcc crystallographic preferred...

  • Void formation in pulsed laser induced via/contact hole filling. Marella, Paul F.; Tuckerman, David B.; Pease, R. Fabian // Applied Physics Letters;6/25/1990, Vol. 56 Issue 26, p2625 

    Metal (Au, Cu, and Al-1% Cu) layers sputter deposited over vias and contact holes of varying diameter and aspect ratio are melted and planarized by irradiation with either a 600 ns pulse duration flashlamp-pumped dye laser or a 35 ns pulse duration excimer laser. High aspect ratio (>=1) vias and...

  • Exchange anisotropy in epitaxial Fe3O4/CoO and Fe3O4/CoxFe3-xO4 bilayers grown by... Kleint, C.A.; Krause, M.K. // Journal of Applied Physics;11/1/1998, Vol. 84 Issue 9, p5097 

    Presents a study focusing on the magnetic exchange anistropy within the epitaxial Fe3O4 based bilayers which were grown by pulsed laser deposition on MgO substrates. Performance of the measurements of the exchange biasing of the Fe3O4 magnetization curves; Observation of a unidirectional...

  • Tailored superlattices containing distinct oxide and oxycarbonate blocks grown by pulsed laser.... Prellier, W.; Mercey, B. // Applied Physics Letters;8/11/1997, Vol. 71 Issue 6, p782 

    Examines the use of pulsed laser deposition technique in the synthesis of copper oxycarbonate superlattices. Components of the infinite layer structure; Accounts on the preparation of the structures; Physical properties of distinct members; Details on the specific deposition parameters; Texture...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics