TITLE

1/f frequency fluctuations in quartz acoustic resonators

AUTHOR(S)
Parker, T. E.
PUB. DATE
February 1985
SOURCE
Applied Physics Letters;2/1/1985, Vol. 46 Issue 3, p246
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
The level of 1/f frequency fluctuations has been measured on numerous quartz surface acoustic wave resonators. When these results are combined with existing data for quartz bulk acoustic wave resonators it becomes clear that the 1/f process is essentially the same in both types of devices. Furthermore, the power spectral density of frequency fluctuations shows a clear power law dependence that is very close to 1/Q[sup 4, sub u], where Q[sub u] is the unloaded Q. However, the observed dependence on loaded Q is weak.
ACCESSION #
9817072

 

Related Articles

  • Pseudo surface acoustic wave two-port synchronous resonator on (--74°) YX cut quartz. Soluch, W. // Electronics Letters;6/24/2004, Vol. 40 Issue 13, p840 

    A pseudo surface acoustic wave (PSAW) two-port synchronous resonator on (-74°)YX cut quartz was designed, fabricated and measured. It was found that for the proper resonator structure at a frequency of 163.3 MHz, insertion loss changes were below 1 dB in the temperature range from -20 to...

  • AlN/ZnO/diamond structure combining isolated and surface acoustic waves. Elmazria, Omar; Zhgoon, Sergei; Le Brizoual, Laurent; Sarry, Frédéric; Tsimbal, Dmitry; Djouadi, Mohammed Abdou // Applied Physics Letters;12/7/2009, Vol. 95 Issue 23, p233503 

    In order to generate surface acoustic waves (SAW) and waveguiding layer acoustic waves (WLAW) simultaneously, a multilayer structure of AlN/ZnO/diamond has been proposed. This structure has been investigated theoretically (two-dimensional finite element method) and experimentally. The nature of...

  • Beam propagation algorithms for frequency response of surface acoustic wave directional couplers. Haruvi-Busnach, I.; Seidman, A.; Croitoru, N. // Journal of Applied Physics;12/15/1996, Vol. 80 Issue 12, p6614 

    Examines the frequency response of directional couplers, with and without a thin strip deposited in the gap between the main channels. Information on the beam propagation method; Applications of surface acoustic wave (SAW) directional couplers; Techniques in calculating the mode profiles in a...

  • Theory of an SAW Filter Operating in Weakly Coupled Resonance Modes. Dmitriev, V.F. // Technical Physics;Feb2003, Vol. 48 Issue 2, p231 

    Modified coupled-mode equations are employed to develop a theory of filters that use waveguide modes of two surface acoustic wave (SAW) resonators weakly coupled in the transverse direction. Results of simulation based on this theory are compared with the earlier experiment.© 2003 MAIK...

  • Development and performance of a semiautomated 200 MHz surface acoustic wave resonator... Townsend IV, E.B.; Ledford, J.S.; Hoffmann, D.B. // Review of Scientific Instruments;Apr95, Vol. 66 Issue 4, p2954 

    Describes the development of a semiautomated pulse injection and data analysis system utilizing surface acoustic wave (SAW) resonators. Description of the sensor system; Development of a sensor test cell; Significance of temperature measurements in the magnitude and time dependency of the SAW...

  • Simplified analysis of surface acoustic wave one-port resonators. Morgan, D.P. // Electronics Letters;9/4/2003, Vol. 39 Issue 18, p1361 

    Many modern surface acoustic wave resonators consist of two grating reflectors with a reflective transducer in between, it is shown that this behaves as a single resonant cavity, in which the transducer reflections give rise to a frequency-dependent variation of the cavity length. A simple...

  • New Approach to SAW Gas Sensors Array Response Measurement. Jasek, K.; Miluski, W.; Pasternak, M. // Acta Physica Polonica, A.;Nov2011, Vol. 120 Issue 5, p639 

    Majority papers concerning surface acoustic wave sensors technology is devoted to the analysis of self-oscillating circuits with surface acoustic wave device and its basic frequency changes in particular. Such circuits are widely used mainly due to their relative simplicity. Unfortunately the...

  • SAW filters and resonators provide cheap and effective frequency control. Tavis, Bill // EDN;10/26/2000, Vol. 45 Issue 22, p103 

    Reports that surface-acoustic-wave (SAW) filters and resonators provide cheap and effective frequency control. Replacement of bulky liquid crystal filters and quartz crystals; Evaluation of filter types; Compensation for SAW filters' insertion loss; Industrial applications.

  • Surface Acoustic Wave Ammonia Sensors Based on ST-cut Quartz under Periodic Al Structure. Cheng-Liang Hsu; Chi-Yen Shen; Rume-Tze Tsai; Ming-Yau Su // Sensors (14248220);2009, Vol. 9 Issue 2, p980 

    Surface acoustic wave (SAW) devices are key components for sensing applications. SAW propagation under a periodic grating was investigated in this work. The theoretical method used here is the space harmonic method. We also applied the results of SAW propagation studied in this work to design a...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics