TITLE

POSITIONING OF ANTENNA TO LOCATE PD IN POWER TRANSFORMER

AUTHOR(S)
Soomro, Irfan Ali; Baharom, M. N. R.
PUB. DATE
July 2014
SOURCE
Journal of Engineering & Applied Sciences;Jul2014, Vol. 9 Issue 7, p1042
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Partial discharge (PD) online monitoring is an effective tool of examining the conditions of insulation and detecting faults in power transformers. From literature it is acknowledged that, the PD detection is not adequate to take a decision about intervening, so the location of fault is necessary to evaluate the hazard to corrective actions. The aim of this experiment is to determine the location of antenna to obtain the strong PD signal. The method used is an experimental work in the laboratory. A sample of two antenna model is made, one antenna is considered as a PD source (transmitting antenna) and other is used as a receiver. The height of transmitting antenna is kept at 25cm. Measurements have been taken by changing the distance between antennas from 15cm and 30cm and also varying height of receiving antenna from 3cm to 45cm. After analyzing the results, it is found that the strong signal has been received when receiving antenna's height is same as transmitting antenna. Otherwise receiving antenna catches weak signal if the height of receiving antenna is lower or higher than 25cm. It means that the receiving antenna only received strong signal when both antennas are face to face with each other. It is concluded that many antennas must be used for locating the PD source. So that PD location can easily be found and can perform necessary actions on it.
ACCESSION #
97273152

 

Related Articles

  • Moisture Migration in an Oil-Paper Insulation System in Relation to Online Partial Discharge Monitoring of Power Transformers. Sikorski, Wojciech; Walczak, Krzysztof; Przybylek, Piotr // Energies (19961073);Dec2016, Vol. 9 Issue 12, p1082 

    Most power transformers operating in a power system possess oil-paper insulation. A serious defect of this type of insulation, which is associated with long operation time, is an increase in the moisture content. Moisture introduces a number of threats to proper operation of the transformer,...

  • Feasibility study for partial discharge detection and defective region identification in power transformers by using distributed sensors. Mohammadi, Hasan; Haghjoo, Farhad // IET Generation, Transmission & Distribution;2016, Vol. 10 Issue 16, p4006 

    Monitoring of partial discharge (PD) and its progress as the main cause of the insulation deterioration process in power transformers can encompass valuable information about the related insulation condition and reveals degradation mechanisms. In this study, some simple sensors, which are made...

  • Online monitoring of transformer through stream clustering of partial discharge signals. Firuzi, Keyvan; Vakilian, Mehdi; Phung, B. Toan; Blackburn, Trevor // IET Science, Measurement & Technology;2019, Vol. 13 Issue 3, p409 

    The general method for identifying the partial discharge type in a power transformer is based on their fingerprints in the form of phase-resolved discharge patterns. In the case of multiple defects, traditional clustering methods can be applied for separation of active sources. However, such an...

  • Validations of simulation of UHF electromagnetic wave propagation in an oil-filled tank by time-domain measurements. Takahiro Umemoto; Tenbohlen, Stefan // IET Generation, Transmission & Distribution;2019, Vol. 13 Issue 9, p1646 

    Degradation of the electrical insulation within power transformers by partial discharge (PD) may lead to catastrophic failure of the apparatus, hence PD should be detected at an early stage. Ultra-high frequency (UHF) measurement method, i.e. detecting electromagnetic (EM) waves in the UHF range...

  • Insulation condition assessment of high-voltage rotating machines using hybrid techniques. Gopinath, Singaram; Sathiyasekar, Kumarasamy; Padmanaban, Sanjeevikumar; Chokkalingam, Bharatiraja // IET Generation, Transmission & Distribution;2019, Vol. 13 Issue 2, p171 

    The enduring life span of the machine insulation will be decided based on degradation level in motor and generator stator windings. The non-destructive diagnostic tools like dielectric loss and capacitance test and partial discharge (PD) analysis, recognized to access the deterioration in the...

  • Quick Fault Localization in Power Transformers.  // Transmission & Distribution World Exclusive Insight;9/4/2012, p2 

    The article presents step-by-step instructions to locate insulation weak spots in power transformers.

  • Partial Discharge Characterisation of Nichrome Particle in a Gas Filled Duct. Kamath, B. Rajesh; Rajan, J. Sundara; Krishnamurthy, K. A.; Kurian, M. Z. // Proceedings of the World Congress on Engineering & Computer Scie;2013, p1 

    Conducting particles on the insulator surfaces or splinters at the conductor in the proximity of an insulator can produce surface charges due to partial discharge activities. These surface charges accumulate on the insulator and can be considered as a type of contamination. This paper deals with...

  • Utilization of Wavelet Transform to Detect the Internal Incipient Faults of Power Transformers. Naderi, Mehdi Salay; Beiza, J.; Taghizadegan, N.; Dadjouyan, A. A.; Rabbaani, J. // International Review of Electrical Engineering;Jul/Aug2011 Part A, Vol. 6 Issue 4, p1590 

    In the case of a fault occurrence, the pattern of the fault currents obtained by the standard impulse tests contains a typical signature of the nature and the location of the insulation failure involved. This paper presents a new approach to classify the pattern of the arc discharge location as...

  • Robust probabilistic optimal voltage sag monitoring in presence of uncertainties. Nasiri, Saeed; Seifi, Hossein // IET Generation, Transmission & Distribution;2016, Vol. 10 Issue 16, p4240 

    This study presents an optimisation model to achieve an optimal voltage sag monitoring programme. To cover the main uncertainty associated with fault impedance, a novel approach termed as probabilistic monitor reach area (PMRA) is developed. Moreover, PMRA is employed to consider reliability of...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics