TITLE

Femtosecond laser-induced periodic surface structure on diamond film

AUTHOR(S)
Wu, Qihong; Ma, Yurong; Fang, Rongchuan; Liao, Yuan; Yu, Qingxuan; Chen, Xiangli; Wang, Kelvin
PUB. DATE
March 2003
SOURCE
Applied Physics Letters;3/17/2003, Vol. 82 Issue 11, p1703
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
We report the laser-induced periodic surface structure (LIPSS) with periodicity about a quarter of the laser wavelength on unpolished diamond film treated by a P-polarized femtosecond laser. The short period LIPSS is parallel to the laser polarization and independent on the incidence angle. The LIPSS perpendicular to the laser polarization with periodicity shorter than a third of the laser wavelength slightly dependent on the incidence angle is also observed as well as the LIPSS perpendicular to the laser polarization with periodicity dependent on the incidence angle. The results are explained by interference of the incident laser and surface scattered wave related to the excited electrons during laser interactions with diamond, being in excellent agreement with a previously developed theory.
ACCESSION #
9275582

 

Related Articles

  • Room-temperature operation of InGaAs/AlInAs quantum cascade lasers grown by metalorganic vapor phase epitaxy. Green, R.P.; Krysa, A.; Roberts, J.S.; Revin, D.G.; Wilson, L.R.; Zibik, E.A.; Ng, W.H.; Cockburn, J.W. // Applied Physics Letters;9/8/2003, Vol. 83 Issue 10, p1921 

    We report the room-temperature operation of λ≈8.5 μm InGaAs/AlInAs quantum cascade lasers, grown by low-pressure metalorganic vapor phase epitaxy. The necessary control of interfacial abruptness and layer thicknesses was achieved by the use of individually purged vent/run valves and...

  • Internal thermal stress distribution in InGaAsP/InP lasers. Liu, J. M.; Chen, Y. C.; Wayne, S. F. // Applied Physics Letters;10/6/1986, Vol. 49 Issue 14, p895 

    The two-dimensional distribution of the internal thermal stress in the active layer of a buried heterostructure InGaAsP/InP laser is calculated with the finite-element method for active regions of both rectangular and crescent shapes. The shape and the finite width of the stripe cause nonuniform...

  • Laser direct writing of single-crystal III-V compounds on GaAs. Karam, N. H.; El-Masry, N. A.; Bedair, S. M. // Applied Physics Letters;10/6/1986, Vol. 49 Issue 14, p880 

    Laser selective chemical vapor deposition and direct writing of GaAs and its ternary alloys with P have been achieved on GaAs substrates. An Ar+ laser is used to locally heat areas where selective deposition is desired on a substrate which is uniformly biased to a temperature in the range of...

  • Structure and superconducting properties of Y1Ba2Cu3O7-δ films prepared by transversely excited atmospheric pressure CO2 pulsed laser evaporation. Miura, S.; Yoshitake, T.; Satoh, T.; Miyasaka, Y.; Shohata, N. // Applied Physics Letters;3/21/1988, Vol. 52 Issue 12, p1008 

    Superconducting Y1Ba2Cu3O7-δ films were prepared by TEA-CO2 pulsed laser evaporation. On SrTiO3(100) the a axis was oriented perpendicular to the substrate surface, while the <110> axis was oriented perpendicular to the substrate surface on SrTiO3(110). Sharp resistive superconducting...

  • Infrared detection of gaseous species during the filament-assisted growth of diamond. Celii, F. G.; Pehrsson, P. E.; Wang, H.-t.; Butler, J. E. // Applied Physics Letters;6/13/1988, Vol. 52 Issue 24, p2043 

    Infrared diode laser absorption spectroscopy is employed as an in situ method to examine gas phase species present during filament-assisted deposition of diamond films. From a reactant mixture of 0.5% methane in hydrogen, methyl radical (CH3 ), acetylene (C2H2), and ethylene (C2H4 ) are detected...

  • Spectroscopic and ion probe measurements of KrF laser ablated Y-Ba-Cu-O bulk samples. Dyer, P. E.; Greenough, R. D.; Issa, A.; Key, P. H. // Applied Physics Letters;8/8/1988, Vol. 53 Issue 6, p534 

    The KrF laser ablation of Y-Ba-Cu-O bulk samples has been studied using visible UV spectroscopy and ion probes. Principal luminescent species, expansion velocities, and the extent of ionization in the ablation plume have been determined in this way, providing information on the interaction of...

  • Thin-film deposition by a new laser ablation and plasma hybrid technique. Krishnaswamy, J.; Rengan, A.; Narayan, J.; Vedam, K.; McHargue, C. J. // Applied Physics Letters;6/12/1989, Vol. 54 Issue 24, p2455 

    We have developed a new laser ablation and plasma hybrid technique for depositing thin diamond-like carbon (DLC) films on Si<100> substrates at room temperature and at 110 °C with improved optical and mechanical properties. The technique involves coupling of laser energy (λ=0.308 μm,...

  • Spatially resolved spectroscopic strain measurements on high-power laser diode bars. Tomm, J. W.; Gerhardt, A.; Müller, R.; Malyarchuk, V.; Sainte-Marie, Y.; Galtier, P.; Nagle, J.; Landesman, J.-P. // Journal of Applied Physics;2/1/2003, Vol. 93 Issue 3, p1354 

    We compare a number of strain-sensitive spectroscopic techniques, namely, micro-Raman, micro-photoluminescence, photocurrent, and electroluminescence by applying them to two AlGaAs/ GaAs high-power diode laser arrays, so-called "cm-bars." Both devices are fabricated from the same bar batch and...

  • Laser patterned arrays of interfaces in magnetoresistive La[sub 2/3]/Sr[sub 1/3]MnO[sub 3] thin... Bibes, M.; Martinez, B. // Applied Physics Letters;10/4/1999, Vol. 75 Issue 14, p2120 

    Reports on the fabrication of laser patterned arrays of interfaces on epitaxial thin films with the aim of developing versatile and low-cost technologies for interface engineering in manganites. Interfaces in the films induced by laser patterning of monocrystalline substrates; Growth of...

  • Microwave properties of compositionally graded (Ba, Sr)TiO[sub 3] thin films according to the direction of the composition gradient for tunable microwave applications. Lee, Su-Jae; Moon, Seung Eon; Ryu, Han-Cheol; Kwak, Min-Hwan; Kim, Young-Tae; Han, Seok-Kil // Applied Physics Letters;3/31/2003, Vol. 82 Issue 13, p2133 

    Compositionally graded (Ba[SUBx], Sr[SUB1-x]TiO[SUB3] (BST) thin films were deposited on MgO substrates by pulsed laser ablation. The microwave properties of the graded BST thin films were investigated at microwave frequencies with coplanar waveguide (CPW) meander-line phase shifters as a...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics