Visualizing and Predicting Solder Paste Flow--In Real Time

Pham-Van-Diep, Gerald; Aravamudhan, Srinivasa; Andres, Frank
February 2003
Circuits Assembly;Feb2003, Vol. 14 Issue 2, p22
Trade Publication
Focuses on real-time visualization technique, a method that eliminates errors associated with typical post-print measurement systems in soldering. Interpretation of the mechanisms governing the release performance of solder pastes for various aperture diameters; Schematic diagram for real-time print dynamics visualization platform; Release performance of stencil for various aperture diameters.


Related Articles

  • Using Solder Fountains. Ferry, Jeff // Circuits Assembly;Nov2001, Vol. 12 Issue 11, p60 

    Focuses on an increase in usage of solder fountains with the introduction of lead-free solders. Pros and cons of solder fountain; Steps to be followed in working with solder fountains; Rework tips to be followed when working with solder fountain.

  • Death of a Battery. Munson, Terry // Circuits Assembly;Nov2001, Vol. 12 Issue 11, p61 

    Focuses on hand soldering process. Causes of faults in the soldered product; Usage of weal organic acids as fluxes; Appropriate amount of flux to be used in soldering.

  • Concerned About Stencil Life? Hymes, Les // Circuits Assembly;Jan2003, Vol. 14 Issue 1, p20 

    Presents guidelines for determining the estimated lifetime of solder paste stencils. Causes of damage of the stencils; Tips on cleaning of the stencils.

  • A Manufacturable Lead-Free Surface-Mount Process? Bath, Jasbir // Circuits Assembly;Jan2003, Vol. 14 Issue 1, p26 

    Focuses on Lead-Free Assembly Project launched by the National Electronics Manufacturing Initiative. Possible demonstration of the manufacturing process with soldering; Reliability of the lead-free solder paste; Techniques used in evaluation of the manufacturing process.

  • Solder Sphere Size. HUNT, CHRIS // Printed Circuit Design & Fab: Circuits Assembly;Mar2012, Vol. 29 Issue 3, p39 

    The article stresses the importance of running simple trials on the solder paste product used or under evaluation in order to maintain solder consistency and avoid improperly sized spherical particles that cause print defects.

  • Peeling Back Graping. HUNT, CHRIS // Printed Circuit Design & Fab: Circuits Assembly;Sep2014, Vol. 31 Issue 9, p51 

    The article discusses the usefulness of viewing parts of a solder paste deposit after placement to check reflow profile for defects.

  • Solder Paste Powder: When to Downsize. O'NEILL, TIM; SEELIG, KARL // Printed Circuit Design & Fab: Circuits Assembly;Jun2015, Vol. 32 Issue 6, p37 

    The article offers step-by-step instructions on when and how to downsize solder paste powder use in the solder powder manufacturing process.

  • Reflow Atmospheres in the Lead-Free Era. Mackie, Andy C. // Circuits Assembly;Mar2003, Vol. 14 Issue 3, p26 

    Examines effects of several process variables on lead free solder pastes. Need for a consistent joint quality across a printed circuit board (PCB) in implementation of lead-free assembly; Four variables that were tested in the examination of damage sensitivity; Two factors that limit maximum...

  • Hot and Cold. HUNT, CHRIS // Printed Circuit Design & Fab: Circuits Assembly;Jan2012, Vol. 29 Issue 1, p49 

    The author reflects on the factors that can cause solder paste slump in electronic machines and suggests tips on how to resolve the problem.


Read the Article


Sign out of this library

Other Topics