TITLE

Don't let noise ruin instrumentation-amplifier performance

AUTHOR(S)
Mancini, Ron
PUB. DATE
October 2002
SOURCE
EDN;10/31/2002, Vol. 47 Issue 24, p20
SOURCE TYPE
Trade Publication
DOC. TYPE
Article
ABSTRACT
Discusses the reduction of noise sources in circuit designs for improving instrumentation-amplifier performance. Use of small power and ground impedances to minimize external noise in amplifiers; Level of internal noise generated by amplifiers; Use of low-voltage-noise amplifiers for lowering internal noise.
ACCESSION #
7707828

 

Related Articles

  • SYNCHRONOUS BUS CONVERTER SUPPLYING CLASS D AMPLIFIER VIRTUALLY ELIMINATES BUS PUMPING. Koohan, Mehrzad // Electronic Design;2/10/2011, Vol. 59 Issue 2, p83 

    The article focuses on how to solve bus pumping which degrades Class D amplifiers. It says that interest in Class D amplifiers has increased due to its efficiency, reduced power loss, and solution cost advantages. It mentions that synchronous secondary-switch-mode power supply using 50% duty...

  • A low-noise wide-band transimpedance amplifier for current noise spectra measurements. De Geronimo, G.; Bertuccio, G.; Longoni, A. // Review of Scientific Instruments;Jul96, Vol. 67 Issue 7, p2643 

    Presents a low-noise wide-band transimpedance amplifier designed to measure the spectral noise densities of currents in submicroamplere range. Design of the feedback transimpedance amplifier; Description of the design criteria and experimental tests.

  • Modeling a voltage-locked Josephson junction array amplifier: Gain, input impedance, and bandwidth. McDonald, D. G. // Journal of Applied Physics;11/1/1986, Vol. 60 Issue 9, p3247 

    Presents a model of a voltage-locked Josephson junction array amplifier. Determination of the effective circuit; Model for input impedance and available power gain of the amplifier; Results using the slowly varying amplitudes method.

  • Impedance projection based transconductance amplifier. Barthélemy, H. // Electronics Letters;7/10/2003, Vol. 39 Issue 14, p1027 

    A current feedback technique is proposed to realise the transposition of grounded impedance to a floating impedance or transconductance. This technique, that can be viewed as an impedance projection, also allows to implement a new current conveyor topology and to extend applications based on...

  • A simple and fast transimpedance amplifier for microchannel plate detectors. Schwartze, P.; Baumga¨rtel, H.; Eisenhardt, C. G. // Review of Scientific Instruments;Jul2001, Vol. 72 Issue 7, p3125 

    A simple and fast transimpedance amplifier to couple a microchannel plate detector with an oscilloscope with a low impedance input has been developed. The amplifier protects the connected electronic equipment from destructive high voltage bursts. Examples of the detection of electrons are shown....

  • Seven Steps to Amp Sim Goodness. Anderton, Craig // Guitar Player;Feb2013, Vol. 47 Issue 2, p130 

    The article focuses on the seven steps for guitar amplifier (amp) simulations (sim) including one on audio interface or amp-sim input, one on transient control, and concerning high-impedance input.

  • Reduce noise in distributed communications systems. Swinney, Bob // Mobile Radio Technology;Oct2000, Vol. 18 Issue 10, p32 

    Explains how tower-mounted amplifiers can improve overall system noise figure in distributed communications systems. Types of noise; Key points related to system noise; Amplifiers in cascade.

  • Learn How To Maximize Dynamic Range in Spectroscopy Systems.  // Sensors;8/8/2014, p24 

    This article discusses the benefits and challenges of implementing a single-stage programmable-gain transimpedance amplifiers to reduce noise while maintaining high bandwidth and high accuracy.

  • A SiGe HBT variable gain low noise amplifier with on-chip active balun design. Ping-Chun Yeh; Tsung-Yu Yang; Wei-Cheng Liu; Hwann-Kaeo Chiou // Microwave & Optical Technology Letters;Jan2007, Vol. 49 Issue 1, p42 

    A variable gain low noise amplifier (VGLNA) using a 0.35 μm SiGe HBT process is described. A VGLNA with linear gain control and high linearity has been developed for 2.4 GHz ISM band applications. The gain control circuit is achieved without degrading either the input or the output VSWR. This...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics