TITLE

Effects of sample storage time, temperature and syringe type on blood gas tensions in samples with high oxygen partial pressures

AUTHOR(S)
Pretto, J J; Rochford, P D
PUB. DATE
June 1994
SOURCE
Thorax;Jun1994, Vol. 49 Issue 6, p610
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
No abstract available.
ACCESSION #
66082533

 

Related Articles

  • Effect of syringe type, storage temperature and time delay on venous blood gas values in newborn calves. Bleul, U.; Götz, E. // Comparative Clinical Pathology;Jan2015, Vol. 24 Issue 1, p117 

    The effects of storage temperature, storage duration and the type of syringe on blood gas and acid-base values in blood of newborn calves were investigated using commercial blood gas syringes coated with heparin (Monovette blood gas syringe, Mono) or heparinised injection syringes (HS). The pH,...

  • TIME, TEMPERATURE, TRANSPORT, AND TYPE OF SYRINGE. Granger, Wesley // Focus Journal;Summer2012, p8 

    The article addresses issues in the time delay, temperature, transport and syringe used for blood gas samples. It cites several studies that show that blood gas samples at room temperature are accepted for up to 20 minutes without bubbles present. It examines a 1991 study on oxygen measurements...

  • TIME, TEMPERATURE, TRANSPORT, AND TYPE OF SYRINGE: A Review and Recommendations. Granger, Wesley // Focus Journal;Fall2012, p16 

    The article addresses issues in the time delay, temperature, transport and syringe used for blood gas samples. It cites several studies that show that blood gas samples at room temperature are accepted for up to 20 minutes without bubbles present. It examines a 1991 study on oxygen measurements...

  • Too much heparin: possible source of error in blood gas analysis. Hutchison, A.S.; Ralston, S.H.; Dryburgh, F.J.; Small, M.; Fogelman, I. // British Medical Journal (Clinical Research Edition);10/15/1983, Vol. 287 Issue 6399, p1131 

    Examines the effects of sodium heparin solution in blood gas analysis. Reduction of carbon dioxide pressure, bicarbonate and base excess; disturbance of blood gas measurements in sampling syringes; Implication of heparin as anticoagulants in laboratory samples.

  • Effects of sample temperature and storage time on arterial blood gases values. Aydogan, Mustafa Said; Yucel, Aytac; Erdogan, Mehmet Ali; Sanli, Mukadder; Konur, Huseyin; Ozgul, Ulku; Togal, Turkan; Durmus, Mahmut // HealthMed;2012, Vol. 6 Issue 12, p3952 

    Background: Arterial blood gas analysis is vital during diagnosis and treatment monitorization of mechanically ventilated patients. Work overload delays blood gas analysis lead to false results. Therefore syringes and the blood samples is recommended to kept cool or cold environment. The aim of...

  • Optimierung von Blutgasanalysen auf der Intensivstation. Kieninger, M.; Zech, N.; Mulzer, Y.; Bele, S.; Seemann, M.; Künzig, H.; Schneiker, A.; Gruber, M. // Anaesthesist;May2015, Vol. 64 Issue 5, p365 

    Background: Point of care testing with blood gas analysis (BGA) is an important factor for intensive care medicine. Continuous efforts to optimize workflow, improve safety for the staff and avoid preanalytical mistakes are important and should reflect quality management standards. Aim: In a...

  • Clinical evaluation of an instrument to measure carbon dioxide tension at the oxygenator gas outlet in cardiopulmonary bypass. Kristiansen, Frode; Høgetveit, Jan Olav; Pedersen, Thore H // Perfusion;Jan2006, Vol. 21 Issue 1, p21 

    This paper presents the clinical testing of a new capnograph designed to measure the carbon dioxide tension at the oxygenator exhaust outlet in cardiopulmonary bypass (CPB). During CPB, there is a need for reliable, accurate and instant estimates of the arterial blood CO2 tension (PaCO2) in the...

  • Morphology and oxygen vacancy investigation of strontium titanate-based photo electrochemical cells. Hertkorn, D.; Benkler, M.; Gleißner, U.; Büker, F.; Megnin, C.; Müller, C.; Hanemann, T.; Reinecke, H. // Journal of Materials Science;Jan2015, Vol. 50 Issue 1, p40 

    In this paper single band gap photo electrochemical cells (PECs) are presented, which consist of strontium titanate (SrTiO3) photo anodes on nickel cathodes in potassium hydroxide electrolyte. SrTiO3 powders are deposited on nickel substrates by electrophoresis before sintering with varying...

  • Oxygen partial pressure dependence of surface tension and its temperature coefficient for metallic melts: a discussion from the viewpoint of solubility and adsorption of oxygen. Hibiya, T.; Morohoshi, K.; Ozawa, S. // Journal of Materials Science;Apr2010, Vol. 45 Issue 8, p1986 

    Surface tension of molten Si, Ag, and Fe–18Cr–8Ni alloy (Type-304 stainless steel) were measured as a function of the temperature and oxygen partial pressure of an ambient atmosphere by an oscillating drop method using electromagnetic levitation, which assures measurement over a...

  • Effects of thermal annealing on charge density and N chemical states in HfSiON films. Tanimura, T.; Kamada, H.; Toyoda, S.; Kumigashira, H.; Oshima, M.; Liu, G. L.; Liu, Z.; Ikeda, K. // Applied Physics Letters;2/23/2009, Vol. 94 Issue 8, p082903 

    We have investigated the charge density and N chemical states in HfSiON films annealed at various oxygen gas pressures by time-dependent photoemission spectroscopy. The Si 2p core-level spectra and the sample current reveal that annealing these films at low oxygen partial pressures affects the...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sign out of this library

Other Topics