TITLE

Stressed state of cylindrical bodies with multilayer inhomogeneous coatings

AUTHOR(S)
Shevchuk, V.; Kalynyak, B.
PUB. DATE
September 2011
SOURCE
Materials Science;Sep2011, Vol. 46 Issue 6, p747
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
We deduce engineering formulas for the evaluation of stresses in a cylinder with inhomogeneous multi-layer coatings by using the approach based on the application of generalized boundary conditions and the approach based on the reduction of the corresponding boundary-value problem of elasticity to the solution of integral equations. We also compare and analyze the ranges of applicability of each approach.
ACCESSION #
62296585

 

Related Articles

  • A new method for analyzing line-tied kink modes in cylindrical geometry. Evstatiev, E. G.; Delzanno, G. L.; Finn, J. M. // Physics of Plasmas;Jul2006, Vol. 13 Issue 7, p072902 

    A new method for studying linear stability of the m=1 (kink) mode in a cylinder with line-tied boundary conditions is presented. The method is applicable to both resistive and ideal MHD. It is based on expansion in one-dimensional eigenfunctions depending on the radius, satisfying boundary...

  • Interface crack in the inhomogeneous transversely isotropic space. Kryvyi, O. // Materials Science;May2012, Vol. 47 Issue 6, p726 

    We construct the exact solution of the problem of circular interface crack in an inhomogeneous transversely isotropic space under the action of arbitrary loads applied to the crack lips. The formulas for the stress intensity factors on the boundary of the crack and the values of these factors...

  • Accurate stresses in laminated piezoelectric finite length cylinders subjected to electro-thermo-mechanical loadings. Desai, P.; Kant, T. // Current Science (00113891);1/10/2012, Vol. 102 Issue 1, p50 

    A mixed semi-analytical computational model is presented which accounts for the coupled electrical, mechanical and thermal response of layered piezoelectric finitely long hollow circular cylinders. Boundary value problem (BVP) of an axisymmetric cylinder is considered here as a two-dimensional...

  • Local stress singularities in mixed axisymmetric problems of the bending of circular cylinders. Vasil'ev, T.; Shaldyrvan, V. // International Applied Mechanics;Feb2012, Vol. 48 Issue 2, p176 

    A method of analyzing the near-edge stress state in mixed problems of the deformation of an isotropic cylindrical body is proposed. The method is based on the expansion of the solution of three-dimensional problems of elasticity into a series of Lurie-Vorovich homogeneous basis functions. An...

  • Numerical simulations of nonlinear thermally stratified spin-up in a circular cylinder. Smirnov, Sergey A.; Pacheco, J. Rafael; Verzicco, Roberto // Physics of Fluids;Nov2010, Vol. 22 Issue 11, p116602 

    We present a numerical study of incremental spin-up of a thermally stratified fluid enclosed within a right circular cylinder with rigid bottom and side walls and stress-free upper surface. This investigation reveals a feasibility for transition from an axisymmetric initial circulation to...

  • An experimental technique for the evaluation of strain dependent material properties of hard coatings. Reed, Shad A.; Palazotto, Anthony N.; Baker, William P. // Shock & Vibration;2008, Vol. 15 Issue 6, p697 

    A novel vibration experiment consisting of a free-free boundary condition, an electromagnetic excitation source, a vacuum chamber, and a laser vibrometer based surface measurement system has been developed that permits high levels of excitation on highly damped specimens with a minimal amount of...

  • Modeling Dry DLC Coated Piston Skirts Elastic Behavior at Low-Speed Initial Engine Start Up. Zahid-Ur-Rehman; Qasim, S. Adnan; Malik, M. Afzaal // Proceedings of the World Congress on Engineering & Computer Scie;Jul2013, Vol. 1, p1 

    The diamond-like coating (DLC) protects the lubricant-starved dry surface of the piston skirts against wear in a low-load and speed initial engine start-up. Despite a relatively large radial clearance a physical contact between the skirts and the cylinder liner causes an elastic deformation of...

  • Influence of Initial Stress as a Convective Boundary Condition on Natural Frequencies of a Poroelastic Hollow Cylinder. El-Naggar, A. M.; Abbas, Ibrahim A.; Abo-Dahab, S. M.; Elsagheer, M. // International Review of Physics;Oct2011, Vol. 5 Issue 5, p271 

    In this paper, we study the radial vibrations of a poroelastic hollow cylinder with convective boundary conditions. Biot's theory is employed for wave propagation in a porous solid, the frequency equation for radial vibration of a poroelastic cylinder is obtained includes initial stress as a...

  • Image force and stability of a screw dislocation inside a coated cylindrical inhomogeneity with interface stresses. Feng, H.; Fang, Q.; Liu, Y.; Jin, B. // Acta Mechanica;Aug2011, Vol. 220 Issue 1-4, p315 

    The image force and stability of a screw dislocation inside a coated cylindrical inhomogeneity with interface stresses are analyzed. A three-phase composite cylinder model is utilized to study the issues. The stress boundary condition at the interface of the coating layer is modified by...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics