TITLE

The flexible Ca-test: An improved performance in a gas permeability measurement system

AUTHOR(S)
Song, Eun Ho; Park, Young Wook; Choi, Jin Hwan; Park, Tae Hyun; Jeong, Jin Wook; Choi, Hyun Ju; Ju, Byeong Kwon
PUB. DATE
May 2011
SOURCE
Review of Scientific Instruments;May2011, Vol. 82 Issue 5, p054702
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
A flexible performance permeability measuring test for flexible organic light-emitting diodes is described in this paper. A single thin film layer of gas barriers is constructed on polyethersulfone (PES). The barrier coats the upper and lower surfaces of the PES layer. Two PES samples, one coated with Al2O3 on both surfaces and the other coated on a single surface, were made for comparison. According to this test, the time-dependent transmission curve of the one sided barrier sample had a linear slope which measured 1.65 g/m2/day at room temperature at a 50% relative humidity. This result shows that the measurement time is about 182% faster than has been achieved with the conventional test structure that uses a glass substrate. In addition, this measurement structure not only reduces the inevitable electrical noise which occurs during measurement but also increases the water vapor permeation signal. These effects improve the sensing reliability of the test. In addition, this structure is flexible, so one can instantly detect barrier performance changes when applying external stress.
ACCESSION #
62010798

 

Related Articles

  • Improvement in Device Performance and Reliability of Organic Light-Emitting Diodes through Deposition Rate Control. Shun-Wei Liu; Chih-Chien Lee; Yu-Ting Chung; Jiun-Haw Lee; Chin-Ti Chen; Juen-Kai Wang // International Journal of Photoenergy;2014, p1 

    We demonstrated a fabrication technique to reduce the driving voltage, increase the current efficiency, and extend the operating lifetime of an organic light-emitting diode (OLED) by simply controlling the deposition rate of bis(10-hydroxybenzo[h]qinolinato) beryllium (Bebq2) used as the...

  • Evaluation of gas permeation barrier properties using electrical measurements of calcium degradation. Choi, Jin Hwan; Kim, Young Min; Park, Young Wook; Huh, Jin Woo; Ju, Byeong Kwon; Kim, In Sun; Hwang, Hee Nam // Review of Scientific Instruments;Jun2007, Vol. 78 Issue 6, p064701 

    In this work, we developed a thin calcium degradation method introducing sensitive electrical resistance monitoring. We have demonstrated structural models of the inorganic/organic thin films to evaluate barrier properties against water and oxygen permeation. The time-dependent transmission...

  • How can the nanostructure affect the charge transport in PLED? M. M. D. Ramos; H. M. C. Barbosa // European Physical Journal - Applied Physics;Mar2009, Vol. 46 Issue 4, p0 

    In polymer light emitting diodes (PLEDs) each semiconducting polymer chain consists of a large number of conjugated segments linked by kinks or twists and each one of them behaves like a separated straight strand. The length and orientation of the conjugated strands relative to the electrodes...

  • Inverted hybrid organic light-emitting device with polyethylene dioxythiophene-polystyrene sulfonate as an anode buffer layer. Dobbertin, T.; Werner, O.; Meyer, J.; Kammoun, A.; Schneider, D.; Riedl, T.; Becker, E.; Johannes, H.-H.; Kowalsky, W. // Applied Physics Letters;12/15/2003, Vol. 83 Issue 24, p5071 

    In this study we demonstrate inverted organic light-emitting diodes (OLEDs) utilizing highly conductive polyethylene dioxythiophene–polystyrene sulfonate as a buffer layer to a radio-frequency sputter-deposited indium–tin–oxide as the anode. In comparison to an entirely...

  • Fireflies inspire LED coating.  // Canadian Chemical News;Mar/Apr2013, Vol. 65 Issue 2, p23 

    The article focuses on the study by the researchers in Belgium on the creation of new light emitting diode (LED) coating derived from the abdomen of firefly.

  • PROCESSING STEPS.  // Electronics World;Apr2014, Vol. 120 Issue 1936, p7 

    The article presents information on a new processing technique developed by researcher Stewart Wilkins which makes light emitting diodes (LEDs) brighter and more resilient by coating the semiconductor material gallium nitride (GaN) with a layer of phosphorus-derived acid.

  • UV-LED Curing Efficiency of Wood Coatings. Landry, Véronic; Blanchet, Pierre; Boivin, Gabrielle; Bouffard, Jean-François; Vlad, Mirela // Coatings (2079-6412);2015, Vol. 5 Issue 4, p1019 

    Ultraviolet light emitting diodes (UV-LEDs) have attracted great interest in recent years. They can be used to polymerize coatings, such as those used for prefinished wood flooring. In this project, two lamps were compared for their suitability to be used on a wood flooring finishing line: a...

  • Degradation of nonencapsulated polymer-based light-emitting diodes: Noise and morphology. Savvate'ev, Vadim N.; Yakimov, Aharon V. // Applied Physics Letters;12/8/1997, Vol. 71 Issue 23, p3344 

    Examines the degradation of nonencapsulated polymer-based light-emitting diode (LED). Correlation between degradation process and noise; Appearance of film resistance fluctuations in LED degradation; Effects of carbonized area on LED; Measurement of the electroluminescence intensity and voltage...

  • Erratum: Defect mechanisms in degradation of InGaAsP long wavelength edge-emitting light-emitting diodes [J. Appl. Phys. 69, 6974 (1991)]. Chu, S. N. G.; Nakahara, S.; Luther, L. C.; Krautter, H. W. // Journal of Applied Physics;8/15/1991, Vol. 70 Issue 4, p2479 

    Presents a correction to the article 'Defect Mechanisms in Degradation of InGaAsP Long Wavelength Edge-Emitting Light-Emitting Diodes,' which appeared in a 1991 issue of the 'Journal of Applied Physics.'

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics