TITLE

Phase separation in Nd[sub 60-x]Y[sub x]Fe[sub 30]Al[sub 10] melt-spun ribbons

AUTHOR(S)
Sun, Z. G.; Lo¨ser, W.; Eckert, J.; Mu¨ller, K.-H.; Schultz, L.
PUB. DATE
February 2002
SOURCE
Applied Physics Letters;2/4/2002, Vol. 80 Issue 5, p772
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
The structure of melt-spun Nd[sub 60-x]Y[sub x]Fe[sub 30]Al[sub 10] (x=0, 10, and 30) ribbons has been investigated by x-ray diffraction, isochronal differential scanning calorimetry (DSC), isothermal DSC, and thermomagnetic measurements. Precipitation of nanocrystalline Nd embedded in an amorphous matrix is found upon quenching. The amorphous phase further separates into Fe-rich regions and Fe-depleted regions. The growth of Nd nanocrystals upon annealing was identified by the characteristic isothermal calorimetric signal. The Fe-depleted amorphous phase crystallizes at 580 K, while the Fe-rich amorphous phase crystallizes at about 740, 779, and 750 K for x=0, 10, and 30, respectively. Phase separation in the amorphous matrix is also revealed by the thermomagnetic measurements, which show ferromagnetic transitions at about 60 and 480 K. © 2002 American Institute of Physics.
ACCESSION #
5985805

 

Related Articles

  • Crystallization Processes of R4.5Fe77B18.5 (R = Pr, Nd) Amorphous Alloys. MUSIAŁ, A.; ŚNIADECKI, Z.; PAGNANI, D.; IDZIKOWSKI, B. // Acta Physica Polonica, A.;Jul2014, Vol. 126 Issue 1, p316 

    The amorphous alloys R4:5Fe77B18:5 (R=Pr, Nd) were prepared by melt-spinning technique under argon atmosphere on a cooper wheel rotating with surface velocity of 25 m∙s-1. The ribbons have been investigated by means of X-ray diffraction (XRD) and differential scanning calorimetry (DSC)....

  • Magnetic properties, phase evolution, and structure of melt spun SmCo7-xNbx (x=0–0.6) ribbons. Guo, Z. H.; Chang, H. W.; Chang, C. W.; Hsieh, C. C.; Sun, A. C.; Chang, W. C.; Pan, W.; Li, W. // Journal of Applied Physics;Apr2009, Vol. 105 Issue 7, p07A731 

    The phase evolution, microstructure, and magnetic properties of melt spun SmCo7-xNbx (x=0–0.6) ribbons have been investigated using powder x-ray diffraction, transmission electron microscopy, and vibrating sample magnetometer, respectively. SmCo7-xNbx ribbons could crystallize in...

  • High coercivity Sm–Fe melt-spun ribbon. Saito, Tetsuji; Furutani, Tomokazu // Journal of Applied Physics;Apr2009, Vol. 105 Issue 7, p07A716 

    The results of an investigation of the synthesis of the Sm5Fe17 phase and its magnetic properties are presented. It was found that the Sm5Fe17 phase can be produced by the annealing of a Sm–Fe melt-spun ribbon with a Sm content of 15–27.5 at. %. The coercivity of the annealed...

  • AN X-RAY DIFFRACTION STUDY FOR ISOTACTIC POLYPROPYLENE FIBRES PRODUCED WITH TAKE-UP SPEEDS OF 2500-4250 M/MIN. Karacan, İsmail; Benlİ, Hüseyin // Journal of Textile & Apparel / Tekstil ve Konfeksiyon;2011, Vol. 21 Issue 3, p201 

    X-ray diffraction and differential scanning calorimetry (DSC) studies of isotactic polypropylene fibres, produced by melt spinning with take-up speeds of 2500-4250 m/min, showed the presence of polymorphism where the α-monoclinic and the smectic phases coexist together with an amorphous...

  • Chalcogenide Glasses as Prospective Thermoelectric Materials. Gonçalves, A.; Delaizir, G.; Lopes, E.; Ferreira, L.; Rouleau, O.; Godart, C. // Journal of Electronic Materials;May2011, Vol. 40 Issue 5, p1015 

    Despite the fact that glasses have interesting characteristics for thermoelectric (TE) applications, their potential as TE materials has only recently been tested. In a recent article, we focused on glasses based on the GeTe composition, which has a high Seebeck coefficient, S, showing that in...

  • Influence of Melt-Spinning Parameters on the Structure and Soft Magnetic Properties of (Fe0.65Co0.35)88Zr7B4Cu1 Alloy. Arvindha Babu, D.; Srivastava, A. P.; Majumdar, B.; Srivastava, D.; Akhtar, D. // Metallurgical & Materials Transactions. Part A;May2010, Vol. 41 Issue 5, p1313 

    Melt-spun ribbons of (Fe0.65Co0.35)88Zr7B4Cu1 alloy have been prepared at different wheel speeds, namely, 47, 39, 34, and 17 m/s, and subsequently annealed at 773 K (500 °C) under controlled atmosphere. Structural and soft magnetic properties have been evaluated using X-ray diffraction,...

  • Properties and potential applications of melt-spun amorphous filaments. Leal, Angel Andrés; Mohanty, Gaurav; Reifler, Felix A.; Michler, Johann; Hufenus, Rudolf // Chemical Fibers International;Sep2015, Vol. 65, p20 

    Most synthetic fibers commercially available are spun from polymers that develop a semi-crystalline structure upon fiber drawing. Fibers with a substantial degree of crystallinity are typically preferred, since amorphous fibers usually show limited tensile properties. Nevertheless, amorphous...

  • Formation of Nd(Fe1-yCoy)2 in rapidly quenched Nd13.75(Fe1-xCox)80.25B6 (x=0-0.5) alloys. Girt, Er.; Koknaeva, M.; Altounian, Z. // Journal of Applied Physics;4/15/1996, Vol. 79 Issue 8, p4833 

    Presents a study that investigated overquenched Nd[sub13.75](Fe[sub1-x]Co[subx])[sub80.25]B[sub6] (x=0-0.5) ribbons using quantitative x-ray structural analysis. Implication of the x-ray diffraction patterns of the ribbons; Role of differential scanning calorimetry; Use of the rapid...

  • Structural and magnetic study of bulk glassy Fe72 − x Co x B20Si4Nb4 alloys. Kane, S. N.; Fleury, E.; Kwon, O. J.; Khinchi, S. S.; Gupta, A. // Hyperfine Interactions;2008, Vol. 183 Issue 1-3, p129 

    The influence of the partial replacement of Fe by Co on the structural and magnetic properties of bulk-type glassy Fe72 − x Co x B20Si4Nb4 (x = 0, 5, 10, 15, 20, 25, 30, 35) alloys has been studied using differential scanning calorimetry (DSC), X-ray diffraction (XRD) magnetic...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics