TITLE

Equation of state and temperature measurements for shocked ammonium perchlorate

AUTHOR(S)
Winey, J. M.; Dreger, Z. A.; Gruzdkov, Y. A.; Jensen, B. J.; Gupta, Y. M.
PUB. DATE
April 2000
SOURCE
AIP Conference Proceedings;2000, Vol. 505 Issue 1, p231
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
A thermodynamically consistent equation of state (EOS) was developed for unreacted, single-crystal ammonium perchlorate (AP) for shock compression along the [210] and [001] directions. The specific heat, c[SUBv], the pressure-temperature coefficient, (&Part;P/&Part;T)[SUBv], and the isothermal bulk modulus, B[SUBT], were determined from Hugoniot and isothermal compression curves, along with available data at atmospheric pressure. The mechanical response of each orientation of the AP crystal was modeled as an isotropic elastic-plastic solid. Above the HEL, the rate dependent yielding of AP was described with a simple overstress model. Time-resolved Raman spectroscopy experiments were carried out to obtain temperatures in the shocked state. These temperature measurements were used to constrain the values of various EOS parameters.
ACCESSION #
5985544

 

Related Articles

  • Specific features of thermal decomposition of ammonium perchlorate subjected to γ radiation. Koptelov, A.; Milekhin, Yu. // Combustion, Explosion, & Shock Waves;Nov2007, Vol. 43 Issue 6, p682 

    Results of studying thermal decomposition of ammonium perchlorate (AP) samples in the original form and after irradiation by γ-quanta of 60Co by methods of differential scanning calorimetry and dynamic thermogravimetry with heating rates b = 0.1–0.3 K/sec are described. Irradiation is...

  • Pulverizes ammonium perchlorate at 150 lb/hr rate  // Chemical Processing (0009-2630);Jul1973, Vol. 36 Issue 7, p18 

    No abstract available.

  • Thermomechanical model and temperature measurements for shocked ammonium perchlorate single crystals. Winey, J. M.; Gruzdkov, Y. A.; Dreger, Z. A.; Jensen, B. J.; Gupta, Y. M. // Journal of Applied Physics;May2002, Vol. 91 Issue 9, p5650 

    A consistent thermomechanical material model was developed for unreacted ammonium perchlorate (AP) single crystals for shock compression normal to the (210) and (001) crystal planes. Building on previous work, the mechanical response for both orientations was described using a single isotropic...

  • Shock wave response of ammonium perchlorate single crystals to 6 GPa. Yuan, G.; Feng[a], R.; Gupta[b], Y. M.; Zimmerman, K. // Journal of Applied Physics;9/1/2000, Vol. 88 Issue 5, p2371 

    Measures the elastic and plastic shock wave velocity histories in the shocked samples ammonium perchlorate using quartz gauge and velocity interferometer techniques. Orientation dependence of the plastic wave ramping in the low stress data; Observation of two wave-structure, indicating an...

  • Initiation threshold of an insensitive underwater high explosive. Arnold, Werner // AIP Conference Proceedings;2000, Vol. 505 Issue 1, p911 

    The initiation threshold of a confined insensitive high explosive (IHE) under shaped charge attack was investigated. The composition of the ammonium perchlorate (AP) containing IHE was AP / RDX / Al / binder, 40 / 24 / 24 / 12 with a density of 1.80 g/cc. This IHE was designed for underwater...

  • Water contaminated in seven states.  // Chemical Market Reporter;09/14/98, Vol. 254 Issue 11, p7 

    Announces Environmental Protection Agency's confirmation that water in seven states in the United States is contaminated with ammonium perchlorate. Perchlorate groundwater contamination in New York, California, Nevada, Utah, Texas, Maryland and Arkansas; Holding of assessment surveys to...

  • US rocketeering may fizzle out. McMillan, Robert // New Scientist;1/4/2003, Vol. 177 Issue 2376, p7 

    Reports on the effect of the U.S. Homeland Security Act which will take effect on May 24, 2003 on amateur rocket enthusiasts. Requirements of the act; Security regulations imposed by the Bureau of Alcohol, Tobacco and Firearms; Debate on the use of ammonium perchlorate composite propellant by...

  • Post-Shock Temperature Measurements of Aluminum. Seifter, A.; Stewart, S. T.; Furlanetto, M. R.; Kennedy, G. B.; Payton, J. R.; Obst, A. W. // AIP Conference Proceedings;2006, Vol. 845 Issue 1, p139 

    Post-shock temperature is an important quantity in shock physics experiments for constraining the dynamic equations of state of materials. A high-speed, infrared, multi-wavelength pyrometer has been developed at Los Alamos National Laboratory (LANL) for measurements in the temperature range from...

  • Temperature measurements and an improved equation of state for shocked liquid benzene. Lacina, D.; Gupta, Y. M. // Journal of Chemical Physics;May2013, Vol. 138 Issue 17, p174506 

    Time-resolved, Raman spectroscopy measurements were used to determine temperatures in multiply shocked liquid benzene to peak pressures of ∼19 GPa. The previously reported equation of state (EOS) for benzene provides temperatures that are lower than the experimental measurements. To achieve...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics