TITLE

On the inelastic response of Al[sub 2]O[sub 3] under shock loading

AUTHOR(S)
Marom, H.; Sherman, D.; Rosenberg, Z.
PUB. DATE
April 2000
SOURCE
AIP Conference Proceedings;2000, Vol. 505 Issue 1, p597
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
The dynamic response of alumina under shock compression was studied using planar impact experiments with different tile thicknesses. Results show steady spreading of the inelastic shock profile with increasing tile width. Further analysis indicates an expected change in failure mechanism in pressures of about twice the Hugoniot Elastic Limit (HEL). HEL decay phenomenon in alumina is probably a measurement artifact, resulting from the relatively slow response times of manganin gauges.
ACCESSION #
5985450

 

Related Articles

  • Aluminum oxynitride at pressures up to 180 GPa. Sekine, Toshimori; Xijun Li, Toshimori; Kobayashi, Takamichi; Yamashita, Yasuyuki; Patel, Parimal; McCauley, James W. // Journal of Applied Physics;10/15/2003, Vol. 94 Issue 8, p4803 

    Hugoniot equation-of-state data of shock compressed aluminum oxynitride (AlON), consisting of 64.1 mol% Al[sub 2]O[sub 3]·35.9 mol% AlN with a density of ∼3.68 g/cm[sup 3], have been determined to 180 GPa. The relationship between shock velocity (U[sub s]) and particle velocity (U[sub...

  • Study of Compressive Failure of Alumina in Impact Experiments with Divergent Flow. Paris, V. E.; Zaretsky, E. B. // AIP Conference Proceedings;2006, Vol. 845 Issue 1, p880 

    Axisymmetric divergent flow characterized by increasing (with propagation distance) difference between longitudinal and radial stress was produced in the plane-parallel alumina samples by impact of spherical (R=200–600 mm) copper impactors having velocities 210 to 260 m/s. The velocity of...

  • Confined Alumina Bar-on-Bar Impact Experiments. Brar, N. S.; Rajendran, A. M. // AIP Conference Proceedings;2006, Vol. 845 Issue 1, p843 

    In an earlier study on unconfined alumina bar-on-bar impact measured velocity history (using VISAR) data at an impact velocity of 100 m/s showed that the material response is elastic. At higher impact velocities of 220 m/s and 300 m/s, the data suggested the material behavior is inelastic. This...

  • Lateral Stress Measurements and Shear Strength of an Alumina-Filled Epoxy. Kos, K.; Millett, J. C. F.; Bourne, N. K.; Deas, D. // AIP Conference Proceedings;2006, Vol. 845 Issue 1, p813 

    The variation of shear strength with impact stress in an alumina-filled epoxy has been measured with lateral stress gauges. At lower stresses, a degree of hardening behind the shock front has been observed, which diminishes as shock stress increases. It is believed that this is due to a...

  • Compositional Effects on the Shock Compression and Release Properties of Alumina-Filled Epoxy. Anderson, M. U.; Cox, D. E.; Montgomery, S. T.; Setchell, R. E. // AIP Conference Proceedings;2006, Vol. 845 Issue 1, p789 

    Alumina-filled epoxy is used for encapsulation in explosively driven pulsed power devices. Its shock compression and release properties have a strong influence on device performance. Previous studies using a material containing 43% by volume alumina showed a complex behavior characterized by...

  • Mesoscale Modelling of the Response of Aluminas. Bourne, N. K. // AIP Conference Proceedings;2006, Vol. 845 Issue 1, p299 

    The response of polycrystalline alumina to shock is not well addressed. There are several operating mechanisms that only hypothesized which results in models which are empirical. A similar state of affairs in reactive flow modelling led to the development of mesoscale representations of the flow...

  • INITIAL TEMPERATURE EFFECTS ON THE SHOCK COMPRESSION AND RELEASE PROPERTIES OF DIFFERENT ALUMINA-FILLED EPOXY COMPOSITIONS. Anderson, M. U.; Cox, D. E.; Montgomery, S. T.; Setchell, R. E. // AIP Conference Proceedings;12/12/2007, Vol. 955 Issue 1, p683 

    Alumina-filled epoxies are composites having constituents with highly dissimilar mechanical properties, resulting in complex behavior during shock compression and release. Two distinguishing characteristics are amplitude-dependent wave structures and high release wave velocities. Recent studies...

  • MORE ON THE RESPONSE OF CERAMICS TO SHOCK WAVES. Bar-on, E. // AIP Conference Proceedings;12/12/2007, Vol. 955 Issue 1, p223 

    The strength properties of Coors AD995 alumina is investigated in the stress range starting from the HEL (5 to 7 GPa) and up to much higher stresses. Simulating the experimental work done by Grady and Moody, we try to explain the structure of loading, unloading, reloading and cyclic loading...

  • SHOCK EQUATION OF STATE OF SINGLE CONSTITUENT AND MULTI-CONSTITUENT EPOXY-BASED PARTICULATE COMPOSITES. Jordan, Jennifer L.; Dattelbaum, Dana; Ferranti, Louis; Sutherland, Gerrit; Baer, Mel; Richards, Wayne; Sheffield, Stephen; Dick, Richard D.; Thadhani, Naresh N. // AIP Conference Proceedings;12/28/2009, Vol. 1195 Issue 1, p1253 

    There are several studies in the literature regarding the equation of state of alumina-epoxy composites. Although this single component system interacts in a complex manner with shock waves, the addition of a second metal or ceramic particulate can result in even more complex interactions. This...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics