TITLE

Stress-strain response of PBX 9501 below 1 gigapascal from embedded magnetic gauge data using Lagrangian analysis

AUTHOR(S)
Dick, J. J.
PUB. DATE
April 2000
SOURCE
AIP Conference Proceedings;2000, Vol. 505 Issue 1, p683
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Unsteady compressive waves were measured in the plastic-bonded, HMX-based explosive PBX 9501 using multiple, embedded, magnetic gauges that measured particle velocity. Records were obtained for impact stresses near 300 and 570 MPa. These results are analyzed using Lagrangian analysis to obtain stress-time and stress-strain curves at gauge positions.
ACCESSION #
5985428

 

Related Articles

  • High-strain rate testing of HMX-based explosive. John, Henry J.; Alamo, Mike F. // AIP Conference Proceedings;2000, Vol. 505 Issue 1, p679 

    A split Hopkinson pressure bar (SHPB) was used to measure the mechanical behavior of Navy explosive PBXC-129 (a high-solids-loaded explosive material) with strain rates up to ~3500 s[SUP-1]. The PBXC-129's high-strain response is typical of other explosive and propellant behavior. At higher...

  • The Effect of Machining the Gage Section on Biaxial Tension/Shear Plasticity Experiments of DP780 Sheet Steel. Walters, C. // Experimental Mechanics;Nov2013, Vol. 53 Issue 9, p1647 

    An experimental approach for determining the effect of machining the gage section of specimens for quasi-static, biaxial tension/shear testing of sheet steels is described. This method is demonstrated by comparing the results found by an existing testing method with a reduced thickness (Mohr and...

  • Nonlinear Ultrasonic Method to Evaluate Residual Mechanical Properties of Thermally Damaged Concrete. Hong Jae Yim; Sun-Jong Park; Jae Hong Kim; Hyo-Gyoung Kwak // ACI Materials Journal;Jul/Aug2014, Vol. 111 Issue 4, p399 

    An experimental study has been carried out to evaluate the residual mechanical properties of thermally damaged concrete using a nonlinear ultrasonic method. A nonlinearity parameter was measured by the impact-modulation technique, which sensitively reflects the degree of thermal damage in...

  • Influence of temperature and strain rate on the mechanical behavior of PBX 9502 and Kel-F 800â„¢. Blumenthal, W. R.; Gray, G. T.; Idar, D. J.; Holmes, M. D.; Scott, P. D.; Cady, C. M.; Cannon, D. D. // AIP Conference Proceedings;2000, Vol. 505 Issue 1, p671 

    Compression measurements were conducted on plastic-bonded explosive PBX 9502 and its binder, Kel-F 800[SUP™], as a function of temperature from -55°C to +55°C using an improved split Hopkinson pressure bar at high strain rates (≈ 1400 s[SUP-1] ) and at low strain rates (≈...

  • Use of High-Speed Photography to Augment Split Hopkinson Pressure Bar Measurements of Energetic Materials. Lee, Richard J.; Joshi, Vasant S. // AIP Conference Proceedings;2002, Vol. 620 Issue 1, p860 

    The split Hopkinson pressure bar technique has been used successfully to characterize high strain-rate behavior (10[sup 3] to 10[sup 4] s[sup -1] ) of metals and polymeric materials in the past. Similar studies on composite energetic materials are desired to assist in developing a model that...

  • Stress Growth Measurements for the Explosive IRX-4. Sutherland, Gerrit T. // AIP Conference Proceedings;2002, Vol. 620 Issue 1, p1055 

    Embedded gauge experiments were performed to measure the shock reactivity of IRX-4, a plastic-bonded explosive that contains HMX, Al, AP and HTPB binder. The pressure-time profiles obtained are similar to those obtained for similar composite explosives. Hugoniot points obtained are in agreement...

  • Numerical Modeling of Direct Shear Tests on Sandy Clay. Ziaie Moayed, R.; Tamassoki, S.; Izadi, E. // World Academy of Science, Engineering & Technology;2012, Issue 61, p1093 

    Investigation of sandy clay behavior is important since urban development demands mean that sandy clay areas are increasingly encountered, especially for transportation infrastructures. This paper presents the results of the finite element analysis of the direct shear test (under three vertical...

  • Plasticity-based constitutive model for concrete in stress space. R., Raveendra Babu; Benipal, Gurmail S.; Singh, Arbind K. // Latin American Journal of Solids & Structures;Dec2006, Vol. 3 Issue 4, p417 

    The existing constitutive models of concrete elasto-plasticity are generally based on an assumed initial yield surface and on the unrealistic uniaxial stress-strain curves. In this paper, a new expression for the loading surface has been proposed and the model has been calibrated by using well...

  • On poisson's ratio and volumetric strain in concrete. Ferretti, Elena // International Journal of Fracture;Apr2004, Vol. 126 Issue 3, pl49 

    A new procedure is proposed for identifying uniaxial stress-strain relationship and Poisson's ratio in compressed plain concrete. The procedure is based on the assumption of an internal core of intact material always present inside a specimen in uniaxial-compression. This involves a modification...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics