TITLE

High pressure response of a high-purity iron

AUTHOR(S)
Veeser, L. R.; Gray, G. T.; Vorthman, J. E.; Rodriguez, P. J.; Hixson, R. S.; Hayes, D. B.
PUB. DATE
April 2000
SOURCE
AIP Conference Proceedings;2000, Vol. 505 Issue 1, p73
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
A series of time-resolved experiments has been done using a 50-mm-diameter light gas gun to characterize the shock uniaxial strain and high-strain-rate response of a high purity iron. The high-strain-rate uniaxial stress response of the iron was characterized using a Split-Hopkinson Pressure Bar. Shock wave experiments were done both with and without windows with a VISAR diagnostic to obtain time-resolved particle velocity data. The shock experiments with windows yield information on elastic/plastic response, transformation kinetics, sound speed, and quasi-elastic release. Experiments were conducted without windows both below and above the α-to-ε phase transformation to study the effect of phase-change kinetics and the release transition on the spallation response in iron. Results of the shock and Hopkinson bar experiments are compared and contrasted to previous research on iron.
ACCESSION #
5985413

 

Related Articles

  • The α→∈ phase transition in iron at strain rates up to ∼109 s-1. Crowhurst, Jonathan C.; Reed, Bryan W.; Armstrong, Michael R.; Radousky, Harry B.; Carter, Jeffrey A.; Swift, Damian C.; Zaug, Joseph M.; Minich, Roger W.; Teslich, Nick E.; Kumar, Mukul // Journal of Applied Physics;2014, Vol. 115 Issue 11, p113506-1 

    We have used a table-top scale laser to dynamically compress iron at strain rates in excess of 109 s-1. Using an embedded ultrafast interferometer, we have measured corresponding free surface histories with a time resolution of approximately 10 ps. We have analyzed the surface histories using a...

  • Direct measurements of the α-ε transition stress and kinetics for shocked iron. Jensen, B. J.; Gray, G. T.; Hixson, R. S. // Journal of Applied Physics;May2009, Vol. 105 Issue 10, p103502 

    Iron undergoes a polymorphic phase transformation from the ¿-phase (bcc) to the ¿-phase (hcp) when compressed to stresses exceeding 13 GPa. Because the epsilon phase is denser than the alpha phase, a single shock wave is unstable and breaks up into an elastic wave, a plastic wave, and a...

  • Effect of the atomic radius of alloying elements on formation of strain martensite in bainitic ductile iron. Akca, Cem; Kinikoglu, Nihat // Metal Science & Heat Treatment;Jan2011, Vol. 52 Issue 9/10, p420 

    The effect of the atomic radius of the alloying elements (Ni, Cu, and Mo) on the rate of formation of strain-induced martensite is investigated. Since the final aim of the study is production of railway-wheel bainitic iron, a special device simulating the operation of material in a railway wheel...

  • Laser-Driven Ramp Compression to Investigate and Model Dynamic Response of Iron at High Strain Rates. Amadou, Nourou; Brambrink, Erik; de Rességuier, Thibaut; Manga, Adamou Ousmane; Aboubacar, Almoustapha; Borm, Björn; Molineri, Anaïs // Metals (2075-4701);Dec2016, Vol. 6 Issue 12, p1 

    Efficient laser shock processing of materials requires a good characterization of their dynamic response to pulsed compression, and predictive numerical models to simulate the thermomechanical processes governing this response. Due to the extremely high strain rates involved, the kinetics of...

  • Pressure induced phase transition in ceramic materials during indentation. Milman, Yu. V.; Gooch, W.; Timofeeva, I. I.; Chugunova, S. I.; Gridneva, I. V. // AIP Conference Proceedings;2000, Vol. 505 Issue 1, p251 

    It was shown by authors that if there exists pressure-induced phase transition of ceramic material at the critical stress Pc so that Pc

  • Theory of elastic phase transitions in metals at high pressures. Application to vanadium. Krasil'nikov, O.; Vekilov, Yu.; Isaev, E.; Bondarenko, N. // Journal of Experimental & Theoretical Physics;Feb2011, Vol. 112 Issue 2, p240 

    Structural transformations in elementary metals under high pressures are considered using the Landau theory of phase transitions, in which the finite strain tensor components play the role of the order parameter. As an example, the phase transition in vanadium observed at a pressure of 69 GPa is...

  • Stress State of Toroidal Transitions Under Internal Pressure. Kabanova, O.; Olenev, A.; Pimshtein, P. // Chemical & Petroleum Engineering;Jul2014, Vol. 50 Issue 3/4, p213 

    New approximate relationships are proposed for evaluation of the stress state of thin-wall transitions under internal pressure. Accuracies of the suggested relationships are analyzed by comparison with numerical results obtained from the NX -7 program, and presented graphically.

  • HCP to omega martensitic phase transformation pathway in pure Zr. Ghosh, Partha S.; Arya, A.; Dey, G. K. // AIP Conference Proceedings;Feb2013, Vol. 1512 Issue 1, p48 

    We investigate a direct transformation mechanism for the pressure driven α→ω martensitic transformation in pure Zr as described by Silcock [2]. A systematic study of coupled atomic shuffles and strains evaluates α→ω transformation energy-landscape. The calculated...

  • Accommodation of transformation strains in transverse multiferroic nanostructures CoFe2O4–PbTiO3. Levin, Igor; Slutsker, Julia; Li, Jianhua; Tan, Zhuopeng; Roytburd, Alexander L. // Applied Physics Letters;8/6/2007, Vol. 91 Issue 6, p062912 

    Variable-temperature x-ray diffraction was used to investigate the internal strains that arise from a ferroelectric phase transition in self-assembled multiferroic nanostructures CoFe2O4–PbTiO3 on (001) SrTiO3. The constraints from CoFe2O4 suppressed the c/a ratio in tetragonal PbTiO3...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics