TITLE

Creep deformation and stress-induced structural disorder near T[sub g] in a Zr[sub 55]Al[sub 10]Ni[sub 5]Cu[sub 30] glassy alloy

AUTHOR(S)
Kato, H.; Inoue, A.; Chen, H. S.
PUB. DATE
December 2001
SOURCE
Applied Physics Letters;12/31/2001, Vol. 79 Issue 27, p4515
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Creep deformation under a constant applied load in a Zr[sub 55]Al[sub 10]Ni[sub 5]Cu[sub 30] glassy alloy at the glass transition region is investigated. At an initial stress, σ[sub 0], less than a critical stress, σ[sub c]=80 MPa, the glass shows a Newtonian flow. When σ[sub 0]>=σ[sub c], the flow viscosity, η, initially decreases and attains a minimum. It then increases as the true stress, σ, decreases with further deformation. The initial decrease in η and the attendance of viscosity minimum are due to the stress-induced structural disorder and the structural equilibration with the applied stress, respectively. For stress, σ, less than the viscosity minimum stress, the stress dependence of viscosity, η(σ), curves all tend to merge together, and is fitted well with a master curve, η(σ), established previously for the steady-state flow under constant strain-rate experiments. These results render further support to the hypothesis of stress-induced structural disorder and the concept of fictive stress. © 2001 American Institute of Physics.
ACCESSION #
5742098

 

Related Articles

  • Creep kinetics of linearly heated metallic glasses. Mikhailov, V. A.; Khonik, V. A. // Physics of the Solid State;Dec97, Vol. 39 Issue 12, p1953 

    A quantitative theory of creep in linearly heated metallic glasses is developed in terms of new ideas on the kinetics of irreversible structural relaxation under external mechanical stress. The validity of the resulting flow equation has been confirmed by a specially devised experiment. It is...

  • Nonisothermal creep of bulk Zr[sub 52.5]Ti[sub 5]Cu[sub 17.9]Ni[sub 14.6]Al[sub 10] metallic glass. Berlev, A. E.; Bobrov, O. P.; Csach, K.; Kaverin, V. L.; Khonik, V. A.; Kitagawa, K.; Misˇkuf, J.; Yurikova, A. // Journal of Applied Physics;11/15/2002, Vol. 92 Issue 10, p5898 

    The article presents the results of nonisothermal creep measurements of the Zr[SUB52.5]Ti[SUB5]Cu[SUB17.9]Ni[SUB14.6]Al[SUB10] bulk metallic glass in a wide range of heating rates well below and in the vicinity of the glass transition temperature T[SUBg]. It is shown that the shear viscosity ...

  • High-temperature oxidation and the prediction of creep life for 0.5Cr—0.5Mo—0.25V steel. Evans, M // Journal of Strain Analysis for Engineering Design (Professional ;2001, Vol. 36 Issue 4, p421 

    Creep life assessment of thick-sectioned components such as steam pipes and headers have traditionally been made from uniaxial creep tests conducted in air on specimens of relatively small diameter. As a consequence of oxidation, such creep life assessments although safe are likely to...

  • Room-temperature creep of tantalum tritides. Schober, T.; Trinkaus, H. // Journal of Applied Physics;6/15/1990, Vol. 67 Issue 12, p7587 

    Investigates the room-temperature creep of tantalum tritides. Helium effects on metallic tritides; Details on the experiment; Discussion on the experimental results.

  • Nonmonotonic creep in LiF crystals containing Mg. Shpeızman, V. V.; Peschanskaya, N. N.; Smirnov, B. I. // Physics of the Solid State;Apr98, Vol. 40 Issue 4, p634 

    Precision measurements of the creep rate using interferometric recording of the process in LiF crystals containing 0.002 to 0.03 wt % Mg using interferometric recording of the process show that nonmonotonic episodes in the form of alternating segments with relatively high and low creep rates...

  • Wing win situation. Hibbert, Lee // Professional Engineering;3/10/2004, Vol. 17 Issue 5, p28 

    Reports of Airbus's Broughton plant in North Wales, which is manufacturing the wings of superjumbo A380. Investment by Airbus in Broughton; Benefits of close coupled manufacturing by stringer facility; Largest British built autoclave in creep forming unit; Logistical exercise for ensuring the...

  • Cyclic Plasticity, Creep and Fracture in a Nimonic Alloy. Rees, D W // Journal of Strain Analysis for Engineering Design (Professional ;1998, Vol. 33 Issue 6, p419 

    Deformation and fracture are examined for a cyclic loading condition in which a 24 h period of forward creep in IN 597 at 850 °C is reversed (a) by a similar period of creep and (b) by fast monotonic strain-limited plasticity with and without a subsequent 1 h period of relaxation. When...

  • Glass stronger than metal. Wilson, Jim; Brill, Louis; Coledan, Stefano; Dunn, Brad; Dunne, Jim; Fillon, Mike; Gleaves, Kathleen; Gourley, Soctt; Gromer, Cliff; Juran, Ken; Rhodes, Bill; Rosenberg, Barry // Popular Mechanics;Jul98, Vol. 175 Issue 7, p28 

    Provides information on the metallic glass alloy developed by scientists at the Johns Hopkins University in Maryland. Applications of the material; Advantages of the metallic glass over metals.

  • Structural changes of the metallic glass Zr65Al7.5Cu27.5 during glass transition and in the... Schumacher, H.; Herr, U. // Journal of Applied Physics;7/1/1997, Vol. 82 Issue 1, p155 

    Studies the structural changes of the metallic glass Zr65Al7.5Cu27.5 at the glass transition and in the undercooled liquid region by x-ray diffraction and x-ray absorption spectroscopy (XAS). Evaluation of the x-ray structure factor; Calculation of the number of nearest neighbors.

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics