590. Detection of Internal Defects of Material on the Basis of Performance Spectral Density Analysis

December 2010
Journal of Vibroengineering;Dec2010, Vol. 12 Issue 4, p541
Academic Journal
No abstract available.


Related Articles

  • Energy Density in an Image Point on a Square Area Element. Il’inskiı, R. E. // Optics & Spectroscopy;Feb2003, Vol. 94 Issue 2, p286 

    The algorithm and results of calculations of the relative energy density in an image point on a square area element are described. The energy distribution in the image point is calculated for aberration-free optical systems with circular and annular pupils in the Fraunhofer diffraction...

  • A Real Valued Neural Network Based Autoregressive Energy Detector for Cognitive Radio Application. Onumanyi, A. J.; Onwuka, E. N.; Aibinu, A. M.; Ugweje, O. C.; Salami, M. J. E. // ISRN Otolaryngology;2014, p1 

    A real valued neural network (RVNN) based energy detector (ED) is proposed and analyzed for cognitive radio (CR) application. This was developed using a known two-layered RVNN model to estimate the model coefficients of an autoregressive (AR) system. By using appropriate modules and a...

  • EFFECT OF FEATURE EXTRACTION ON AUTOMATIC SLEEP STAGE CLASSIFICATION BY ARTIFICIAL NEURAL NETWORK. Prucnal, Monika; Polak, Adam G. // Metrology & Measurement Systems;Jun2017, Vol. 24 Issue 2, p229 

    EEG signal-based sleep stage classification facilitates an initial diagnosis of sleep disorders. The aim of this study was to compare the efficiency of three methods for feature extraction: power spectral density (PSD), discrete wavelet transform (DWT) and empirical mode decomposition (EMD) in...

  • Measurement of the Boundary Frequency of the Inertial Interval of Capillary Wave Turbulence at the Surface of Liquid Hydrogen. Brazhnikov, M. Yu.; Kolmakov, G. V.; Levchenko, A. A.; Mezhov-Deglin, L. P. // JETP Letters;12/25/2001, Vol. 74 Issue 12, p583 

    The boundary frequency was experimentally measured for the upper edge of an inertial interval corresponding to the Kolmogorov spectrum for energy distribution over the oscillation frequencies at the surface of liquid hydrogen. It is shown that the dependence of boundary frequency ω[sub b] on...

  • Restoration of dual-frequency signals with nonlinear propagation in fibers with positive group.... Mamyshev, P.V.; Wigley, P.G. // Applied Physics Letters;6/20/1994, Vol. 64 Issue 25, p3374 

    Investigates the propagation of a dual-frequency signal through a single-mode fiber in the positive group velocity dispersion spectral region. Evolution of the dual-frequency signal; Comparison of the two spectral components of the restored signal with the input spectral components; Cause for...

  • Fusion Neutronic Source deuterium-tritium neutron spectrum measurements using natural diamond... Krasilnikov, A.V.; Kaneko, J.; Isobe, M.; Maekawa, F.; Nishitani, T. // Review of Scientific Instruments;Apr97, Vol. 68 Issue 4, p1720 

    Describes the use of two natural diamond detectors (NDD) operating at room temperature for Fusion Neutronics Source deuterium-tritium (DT) neutron spectra measurements at different points around the tritium target and for different deuteron beam energies. Energy resolution of the NDD;...

  • Shot noise in macroscopic CdTe resistors: experimental evidence and analytical study. I. Asaad // European Physical Journal - Applied Physics;Jan2009, Vol. 45 Issue 1, p10303 

    In this work, we present experimental evidence and analytical studies of dark current noise spectral density in CdTe detectors for a low and mid frequency range. The measured noise level in CdTe detectors indicates shot noise suppression at 10 KHz; this suppression can occur in CdTe detectors...

  • Dual current-perpendicular-to-plane giant magnetoresistive sensors for magnetic recording heads with reduced sensitivity to spin-torque-induced noise. Childress, J. R.; Carey, M. J.; Kiselev, S. I.; Katine, J. A.; Maat, S.; Smith, N. // Journal of Applied Physics;4/15/2006, Vol. 99 Issue 8, p08S305 

    Dual IrMn-pinned current-perpendicular-to-plane giant magnetoresistive sensor structures have been investigated, and their signal and noise characteristics are compared to similar standard single sensors, using test structures with sizes down to 50 nm. The intrinsic signal ΔRA product is...

  • Tool Condition Monitoring using Acoustic Emission and Vibration Signature in Turning. Bhuiyan, M. S. H.; Choudhury, I. A.; Nukman, Y. // Proceedings of the World Congress on Engineering 2012 Volume III;2012, p1 

    The various sensors used to monitor tool condition usually sense the cutting tool state in terms of electric/magnetic/optical signal by responding to the change of process dynamics during machining. The redistribution of energy that is released from the localized sources, i.e. stress and strain...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics