TITLE

Self-assembled heterojunction between electrodeposited PbS nanoparticles and indium tin oxide substrate

AUTHOR(S)
Nanda, K. K.; Sahu, S. N.
PUB. DATE
October 2001
SOURCE
Applied Physics Letters;10/22/2001, Vol. 79 Issue 17, p2743
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Self-assembled heterojunction was fabricated by means of an electrochemical deposition of PbS nanoparticles on indium tin oxide substrate. The current–voltage and capacitance–voltage studies confirmed the formation of a heterojunction. A large current and large capacitance were observed in the case of a device from particle of smaller size which is believed to be due to the large surface area contact. The rectifying behavior of the heterojunction was found to be weak as compared to the usual p–n junction. © 2001 American Institute of Physics.
ACCESSION #
5356359

 

Related Articles

  • Mechanisms of Photocurrent Generation in In[sub 2]O[sub 3]�InSe Heterojunctions. Makhniy, V. P.; Yanchuk, O.I. // Semiconductors;Dec2003, Vol. 37 Issue 12, p1387 

    Spectral and integral characteristics of In[sub 2]O[sub 3]�InSe heterojunctions fabricated by oxidation of indium monoselenide substrates were studied. It was established that the photocurrent is determined by photogeneration of carriers in the space charge region of the structure via...

  • High-pressure thermal oxidation of InP in steam. Gann, R. G.; Geib, K. M.; Wilmsen, C. W.; Costello, J.; Hrychowain, G.; Zeto, R. J. // Journal of Applied Physics;1/15/1988, Vol. 63 Issue 2, p506 

    Studies the high-pressure thermal oxidation of indium phosphide (InP) in steam. Composition of thermally grown oxides on InP; Methodology of the study; Discussion on the results of the experiment.

  • Effect of microstructures on nanocrystallite nucleation and growth in hydrogenated amorphous indium–tin–oxide films. Ando, Masahiko; Nishimura, Etsuko; Onisawa, Ken-ichi; Minemura, Tetsuroh // Journal of Applied Physics;1/15/2003, Vol. 93 Issue 2, p1032 

    Hydrogenated amorphous indium-tin-oxide (ITO) films were prepared by a sputtering method at room temperature with H[sub 2]O addition. The initial stage of thermal crystallization of the amorphous films was investigated after annealing at 150 °C, just below the crystallization temperature....

  • Evolution of the In oxide/Si(111) interface: Analysis by electron spectroscopies. Öfner, H.; Shapira, Y.; Netzer, F. P. // Journal of Applied Physics;7/15/1994, Vol. 76 Issue 2, p1196 

    Reports on the early stages of indium oxide growth on silicon(111) by reactive evaporation at room temperature (RT) and elevated temperatures. Data on RT deposition; Oxidation at elevated temperatures.

  • Tape casting of ITO for electroluminescent devices.  // American Ceramic Society Bulletin;Dec2011, Vol. 90 Issue 9, p24 

    The article focuses on the study conducted by researchers at the University of Erlangen-Nuremberg in Germany which examines the use of tape casting technique in fabricating indium oxide or indium tin oxide (ITO) for electroluminescent devices.

  • Oxidation of indium in gold-indium alloys. Pasquevich, A. F.; Hoffmann, A.; Vianden, R.; Wrede, U. // Journal of Applied Physics;10/15/1985, Vol. 58 Issue 8, p3200 

    Presents a study which investigated the oxidation of indium in gold-indium alloys. Overview of previous studies on the oxidation of impurities in nominally pure gold; Approaches to the oxidation of gold-indium alloys; Details of experimental procedures.

  • (Photo)electrochemical characterization of tin-doped indium oxide. van den Meerakker, J. E. A. M.; Meulenkamp, E. A.; Scholten, M. // Journal of Applied Physics;9/1/1993, Vol. 74 Issue 5, p3282 

    Presents a study which characterized tin-doped indium oxide films by (photo)electrochemical measurements in aqueous H[sub2]SO[sub4] solutions. Experimental details; Results; Conclusion.

  • Long wavelength (λ∼1.5 μm) native-oxide-defined InAlAs-InP-InGaAsP quantum well heterostructure laser diodes. Caracci, S. J.; Krames, M. R.; Holonyak, N.; Ludowise, M. J.; Fischer-Colbrie, A. // Journal of Applied Physics;3/1/1994, Vol. 75 Issue 5, p2706 

    Studies the native oxidation of indium compound employed to fabricate long wavelength indium compound quantum well heterostructure laser diodes. Applications of native oxide process; Preparation of the sample; Discussion on the results of the study.

  • A method of highly efficient hydrolization oxidation of III-V semiconductor lattice matched to... Koley, B.; Johnson, F. G.; King, O.; Saini, S.S.; Dagenais, M. // Applied Physics Letters;8/30/1999, Vol. 75 Issue 9, p1264 

    Demonstrates a method of efficient wet oxidation process for devices grown on indium phosphide (InP). Fabrication of an edge-emitting laser; Oxidation of a strain that compensated indium arsenide (InAs)/aluminum arsenide (AlAs) short-period superlattice grown on InP; Long wavelength vertical...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics