TITLE

Millimeter-wave generation via frequency multiplication in graphene

AUTHOR(S)
Dragoman, M.; Neculoiu, D.; Deligeorgis, G.; Konstantinidis, G.; Dragoman, D.; Cismaru, A.; Muller, A. A.; Plana, R.
PUB. DATE
August 2010
SOURCE
Applied Physics Letters;8/30/2010, Vol. 97 Issue 9, p093101
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
In this letter, we demonstrate that a graphene monolayer, over which three metallic electrodes forming a coplanar waveguide are patterned, acts as a frequency multiplier and generates frequencies at least up to 40 GHz. These results show that monolayer graphene is a natural frequency multiplier.
ACCESSION #
53421682

 

Related Articles

  • Simple fabrication scheme for sub-10 nm electrode gaps using electron-beam lithography. Liu, K.; Avouris, Ph.; Bucchignano, J.; Martel, R.; Sun, S.; Michl, J. // Applied Physics Letters;2/4/2002, Vol. 80 Issue 5, p865 

    An innovative and simple method, based on electron-beam (e-beam) overlapping and overexposure techniques, is developed to fabricate sub-10 nm electrode gaps with very good electrical properties. Gaps with 4 to 10 nm spacing can be fabricated using a proper e-beam dose and pattern-developing...

  • Fabrication of metallic electrodes with nanometer separation by electromigration. Park, Hongkun; Lim, Andrew K.L. // Applied Physics Letters;7/12/1999, Vol. 75 Issue 2, p301 

    Presents a method for fabrication of metallic electrodes with nanometer separation. Background on the fabrication achieved by passing a large electrical current through a gold nanowire defined by electron-beam lithography and shadow evaporation.

  • Amplified spontaneous emission in active channel waveguides produced by electron-beam lithography in LiF crystals. Montereali, R. M.; Piccinini, M.; Burattini, E. // Applied Physics Letters;6/25/2001, Vol. 78 Issue 26, p4082 

    In this letter we report the observation of amplified spontaneous emission of the red light from LiF:F[sub 2] centers in active channel waveguides realized by electron-beam lithography in lithium fluoride crystals. Low pumping power densities have been used in quasi-continuous-wave regime at...

  • Nanometer-spaced electrodes with calibrated separation. Kervennic, Y. V.; Van der Zant, H. S. J.; Morpurgo, A. F.; Gurevich, L.; Kouwenhoven, L. P. // Applied Physics Letters;1/14/2002, Vol. 80 Issue 2, p321 

    We have fabricated pairs of platinum electrodes with separation between 20 and 3.5 nm. Our technique combines electron beam lithography and chemical electrodeposition. We show that the measurement of the conductance between the two electrodes through the electrolyte provides an accurate and...

  • Experimental analysis of the high-order harmonic components generation in few-layer graphene. Hadarig, Andreea; Vázquez, Carlos; Fernández, Miguel; Ver Hoeye, Samuel; Hotopan, George; Camblor, René; Las Heras, Fernando // Applied Physics A: Materials Science & Processing;Jan2015, Vol. 118 Issue 1, p83 

    In this work, the nonlinear electromagnetic response of a few-layer graphene sheet is experimentally analyzed. The few-layer graphene sheet is obtained through mechanical exfoliation from highly ordered pyrolytic graphite and embedded in a rectangular waveguide structure which is used to guide...

  • Investigation of switching effects between the drains of an electron Y-branch switch. Worschech, L.; Weidner, B.; Reitzenstein, S.; Forchel, A. // Applied Physics Letters;5/21/2001, Vol. 78 Issue 21, p3325 

    By using high-resolution electron beam lithography and wet etching, Y-branched electron waveguides with lengths down to 70 nm have been fabricated on modulation-doped GaAs/AlGaAs heterostructures. Small positive bias applied between the source and the two drain electron reservoirs leads to...

  • InP photonic crystal membrane structures: Fabrication accuracy and optical performance. Xing, Aimin; Darvanco, Marcelo; Blumenthal, Daniel J.; Hu, Evelyn L. // Applied Physics Letters;7/26/2004, Vol. 85 Issue 4, p522 

    Two-dimensional photonic crystal membranes with coupled ridge waveguides were fabricated in InP/InGaAsP by using e-beam lithography and reactive ion etching. The optical transmission characteristics were measured and a photonic band gap with better than 20 dB extinction ratio was observed. The...

  • In situ synthesizing molecular materials between coplanar gold microgap electrodes for the fabrication of molecular devices. Liu, Yaling; Ji, Zhuoyu; Li, Hongxiang; Hu, Wenping; Zhu, Daoben // Applied Physics Letters;1/14/2008, Vol. 92 Issue 2, p023505 

    In this paper, a way to integrate the synthesis of molecular materials and the fabrication of molecular devices was demonstrated by using copper tetracyanoquinodimethane (CuTCNQ). Coplanar gold microgap electrodes were prepared by photolithography or electrobeam lithography. CuTCNQ was in situ...

  • Erratum: 'Even-odd symmetry and the conversion efficiency of ideal and practical graphene transistor frequency multipliers' [Appl. Phys. Lett. 99, 223512 (2011)]. Parrish, Kristen N.; Akinwande, Deji // Applied Physics Letters;4/29/2013, Vol. 102 Issue 17, p179902 

    No abstract available.

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics