TITLE

Measurement of grid heat loading in a negative ion source for producing intense H[sup -] ion beams by aperture displacement focusing technique

AUTHOR(S)
Takayanagi, T.; Ikehata, T.; Okumura, Y.; Watanabe, K.; Hanada, M.; Amemiya, T.
PUB. DATE
October 2001
SOURCE
Review of Scientific Instruments;Oct2001, Vol. 72 Issue 10, p3829
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Heat loading of acceleration grids has been investigated using a JAERI 400 keV negative hydrogen ion source, which has a three-stage multiaperture accelerator. To investigate the effect of beamlet steering on the heat loading, the apertures in the grounded grid were displaced up to 5 mm. The steering angle increased linearly with the displacement distance of the grid. The obtained steering angle was 7.5 mrad at the displacement distance of 5 mm. It was confirmed that the steering angle agrees well with the thin lens theory. Degradation of beam optics due to the steering was not observed. The heat load of the grounded grid was scarcely changed up to the displacement distance of 2 mm and then increased from 2.5% to 8% of the total input power when the grid was displaced from 2.5 to 5 mm. Heat loads of the other unsteered grids were not changed. © 2001 American Institute of Physics.
ACCESSION #
5234582

 

Related Articles

  • Design of accelerator for negative ion beams by computer simulation. Park, T. S.; Lee, W. S.; Be, S. H. // Journal of Applied Physics;8/15/1985, Vol. 58 Issue 4, p1701 

    Describes the computer simulation concerning the acceleration of negative hydrogen ion beams. Method used to compute spatial distribution and ion trajectory in the multiple stage ionizer; Condition used in the computation.

  • Surface plasma source to generate high-brightness H[sup -] beams for ion projection lithography... Dudnikov, V.G.; Derevyankin, G.E.; Kovalevsky, D.V.; Savkin, V.Ya.; Sokolovsky, E.A.; Guharay, S.K. // Review of Scientific Instruments;Mar96, Vol. 67 Issue 3, p927 

    Reports on the development of a surface plasma source with Penning-type electrodes to generate negative ion beams for ion projection lithography applications. Pulse width; Repetition rate; Maximum negative hydrogen beams at the emission surface.

  • The formation of a negative hydrogen ion beam by surface conversion of a positive ion beam on cesiated tungsten surfaces. van Bommel, P. J. M.; Bonnie, J. H. M.; Granneman, E. H. A.; Massmann, P.; Hopman, H. J. // Journal of Applied Physics;10/1/1985, Vol. 58 Issue 7, p2492 

    Presents a study that measured the generation of negative hydrogen ion beams via the conversion of a positive ion beam on cesiated tungsten surface. Measurement of the negative ion beam current; Analysis of the negative ion currents obtained with a single monolayer of cesium; Examination of the...

  • Intense negative ion beams and their diagnostics. Papadichev, V. A.; Shelkovenko, T. A. // Review of Scientific Instruments;Jan1990, Vol. 61 Issue 1, p395 

    Using negative ions for accelerators and CTR has some peculiarities. High-power beams of fast atoms obtained by charge exchange of negative ions can have advantages over positive ion beams for ICE since they do not experience any deviation, instabilities, and scattering. H[sup -] current up to 7...

  • Volume source of hydrogen negative ions based on reflexive discharge: Theory and experiment... Goretsky, V.P.; Ryabtsev, A.V.; Soloshenko, I.A.; Tarasenko, A.F.; Schedrin, A.I. // Review of Scientific Instruments;Mar96, Vol. 67 Issue 3, p1060 

    Reports on the results of theoretical and experimental studies of the stationary volume source of hydrogen negative ions based on reflexive discharge. Parameters of the extracted ion beam; Calculation of the dependencies of the current density of hydrogen negative ions.

  • Basic processes of negative hydrogen ion production and destruction in sources and beams (invited). Bacal, M.; Michaut, C.; Elizarov, L.I.; El Balghiti, F. // Review of Scientific Instruments;Mar96, Vol. 67 Issue 3, p1138 

    Presents an update on the basic processes of negative hydrogen ion production and destruction in ion sources and beams. Dissociation rates in H[sub 2]; Negative ion stripping in beams; Electron detachment in collision with positive ions; Effect of cesium seeding in negative hydrogen ion sources.

  • Matrix of small-radius radio-frequency discharges as a volume-production based source of negative hydrogen ions. Lishev, St.; Paunska, Ts.; Shivarova, A.; Tarnev, Kh. // Review of Scientific Instruments;Feb2012, Vol. 83 Issue 2, p02A702 

    Based on experience from a work-both theoretical and experimental one-on negative hydrogen ion beam sources studied regarding fusion applications, a novel design of a rf source with volume production of the ions is proposed. The suggestion is for a source constructed as a matrix of small-radius...

  • An electronic pepper pot. Peters, J. // Review of Scientific Instruments;Apr94, Vol. 65 Issue 4, p1459 

    An electronic pepper pot has been developed at DESY for analyzing the H[sup -] beam. It consists of a number of slits in front of a harp with a high wire density: Multiplexing of the harp signals is done in the vacuum. The number of slits and the distance between the harp and the slits can be...

  • A novel ion beam monitor using Kapton foils Guharay, S.K.; Guharay, S. K.; Hamabe, M.; Kuroda, T. // Review of Scientific Instruments;May98, Vol. 69 Issue 5, p2182 

    Examines the use of Kapton foils as ion beam monitor. Analysis of film 'burn' pattern caused by ion beam irradiation; Determination of beam power density distribution; Relation of ion current density distribution to ion beam distribution; Use of hydrogen ion beam to study ion beam-Kapton foil...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics