TITLE

Parallel laser microfabrication of large-area asymmetric split ring resonator metamaterials and its structural tuning for terahertz resonance

AUTHOR(S)
Chen, Z. C.; Hong, M. H.; Lim, C. S.; Han, N. R.; Shi, L. P.; Chong, T. C.
PUB. DATE
May 2010
SOURCE
Applied Physics Letters;5/3/2010, Vol. 96 Issue 18, p181101
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Large-area asymmetric split ring resonator (ASRR) arrays are fabricated by femtosecond laser microlens array lithography. The double square ASRR consists of two gaps at the outer edge. The resonance properties of this ASRR under structural symmetry breaking conditions are investigated in the terahertz region by changing gap size at one side. The resonance of the ASRR shows blueshift from 0.85 to 0.98 THz when the one gap size increases from 2 to 14 μm. Numerical simulations reveal that the electric field enhancement at the fixed gap increases from 152 to 206 times as the degree of asymmetry increases.
ACCESSION #
50309217

 

Related Articles

  • Applications of Ultrafast Lasers in Microfabrication. MIELKE, Michael M.; BOOTH, Timothy; GREENBERG, Michael; GAUDIOSI, David M.; MARTINEZ, Carolyn; SAPERS, Steven P.; CLINE, Robert; SRINIVAS, Ramanujapuram A. // Journal of Laser Micro / Nanoengineering;2013, Vol. 8 Issue 2, p115 

    Just as photolithography technology brought about the miniaturization of integrated circuits and drove multiple market opportunities in the electronics sector, a similar inflection point has arrived for ultrafast lasers. While these femtosecond class lasers have long enabled the precise...

  • Direct laser writing of three-dimensional submicron structures using a continuous-wave laser at 532 nm. Thiel, M.; Fischer, J.; von Freymann, G.; Wegener, M. // Applied Physics Letters;11/29/2010, Vol. 97 Issue 22, p221102 

    Three-dimensional direct laser writing is commonly associated with tightly focused femtosecond laser pulses. Although few reports have used continuous-wave lasers instead, it is unclear whether state-of-the-art three-dimensional submicron structures for photonics can be fabricated along these...

  • Evolution of microstructures on silicon induced by femtosecond laser with multiple pulses. YUAN, D. Q.; ZHOU, M.; LU, D. Q.; XU, J. T. // Optica Applicata;2011, Vol. 41 Issue 3, p727 

    The effect of multiple pulses of Ti:sapphire femtosecond laser system on silicon wafer was investigated. Using the pulse energy exceed the threshold of silicon to investigate the evolvement of structures and found that exceed certain fluence no any periodic structure will appearance. For 1.91...

  • Organized metamaterials comprised of gold nanoneedles in a lattice generated on silicon (100) wafer substrates by interfering femtosecond laser processing. Nakata, Yoshiki; Momoo, Kazuma; Miyanaga, Noriaki; Hiromoto, Takuya; Tsuchida, Kunio // Applied Physics A: Materials Science & Processing;Jul2013, Vol. 112 Issue 1, p173 

    Interfering femtosecond (fs) laser processing has been applied to fabricate organized metamaterials on substrates. We have named the unit structures as nanowhiskers, nanoneedles, nanodrops, and nanocrowns. The processes used for formation of these structures are analogous to the motion of a...

  • Nanostructuring of Silicon Surface with Femtosecond-Laser-Induced Near-field. Godai MIYAJI; Kaifeng ZHANG; Junya FUJITA; Kenzo MIYAZAKI // Journal of Laser Micro / Nanoengineering;2012, Vol. 7 Issue 2, p198 

    In the femtosecond laser ablation experiment for silicon in water, we observed formation of two kinds of nanostructure with a fine period of ∼ 150 nm and a coarse one of ∼ 400 nm. It is found that the fine structure can be formed in a restricted range of low fluence of 60 - 70...

  • Measurement Of The Spectral Phase Shift And The Residual Angular Dispersion Of An AOPDF. Börzsönyi, Á.; Mero, M.; Kovács, A. P.; Kalashnikov, M. P.; Osvay, K. // AIP Conference Proceedings;4/16/2010, Vol. 1228 Issue 1, p138 

    The spectral phase shift and both types of angular dispersion introduced by an acousto-optic programmable dispersive filter (AOPDF) into a femtosecond laser beam at 800 nm have been measured with high precision. With the use of spectrally and spatially resolved interferometry we experimentally...

  • Femtosecond laser micromachining: A back-to-basics primer. Lucas, Lonnie; Jim Zhang; Energetics, Applied // Industrial Laser Solutions;Jul/Aug2012, Vol. 27 Issue 4, p29 

    The article discusses the laser sources, basic mechanisms and potential applications of femtosecond or ultrafast lasers for use in micromachining. It defines ultrafast laser micromachining as a process in which ultrafast pulses are being used in the induction of micrometer-sized structures in...

  • A time-gating scintillation detector for the measurement of laser-induced fast neutrons. Sungman Lee; Sangsoon Park; Kwon-hae Yea; Hyungki Cha // Review of Scientific Instruments;Jun2009, Vol. 80 Issue 6, p063303 

    A time-gating scintillation detector, in which a fast high voltage switch is used for gating a channel photomultiplier, was developed for a measurement of laser-induced fast neutrons. The x rays generated from the intense femtosecond laser and the solid target interactions were suppressed...

  • Applying genetic algorithm optimization to a folded geometry acousto-optic modulated spatial pulse shaper. Nag, Amit; Chaphekar, Prasad A.; Goswami, Debabrata // Review of Scientific Instruments;Jan2010, Vol. 81 Issue 1, p013101 

    A folded geometry acousto-optic modulator spatial pulse shaper has been designed for shaping individual pulses from a high power amplified laser. The design preserves the capability of computer programmable amplitude and phase modulation of femtosecond laser pulses. An additional application of...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics