TITLE

Piezoelectric energy harvesting using shear mode 0.71Pb(Mg1/3Nb2/3)O3–0.29PbTiO3 single crystal cantilever

AUTHOR(S)
Bo Ren; Siu Wing Or; Yaoyao Zhang; Qinhui Zhang; Xiaobing Li; Jie Jiao; Wang, Wei; Da'an Liu; Xiangyong Zhao; Haosu Luo
PUB. DATE
February 2010
SOURCE
Applied Physics Letters;Feb2010, Vol. 96 Issue 8, p083502
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
In this letter we presented a cantilever beam used for vibration energy harvesting based on shear mode 0.71Pb(Mg1/3Nb2/3)O3–0.29PbTiO3 single crystal. The working principle of the device was inferred and the factors influencing the output were obtained using an analytical method. The electrical properties under different conditions were studied systematically. Under a cyclic force of 0.05 N (peak value), a peak voltage of 91.23 V, maximum power of 4.16 mW were measured at 60 Hz with a proof mass of 0.5 g. The results demonstrate the potential of the device in energy harvesting applied to low-power portable electronics and wireless sensors.
ACCESSION #
48352138

 

Related Articles

  • Face shear piezoelectric properties of relaxor-PbTiO3 single crystals. Shujun Zhang; Fei Li; Wenhua Jiang; Jun Luo; Meyer, Richard J.; Wenwu Cao; Shrout, Thomas R. // Applied Physics Letters;5/2/2011, Vol. 98 Issue 18, p182903 

    Poling relaxor-PbTiO3 single crystals along pseudocubic [011] results in a macroscopic symmetry of mm2, enabling a large face shear d36 in Zt±45° cut crystals. In order to allow the determination of electrical properties by the resonance method, square samples are required. Using...

  • LAMB WAVE TUNING FOR PIEZOELECTRIC WAFER ACTIVE SENSOR APPLICATIONS IN IN-SITU STRUCTURAL HEALTH MONITORING. Giurgiutiu, V.; Yu, L.; Santoni, G. B.; Xu, B. // AIP Conference Proceedings;2/28/2008, Vol. 975 Issue 1, p896 

    An analytical and experimental investigation of the Lamb wave mode tuning with piezoelectric wafer active sensors (PWAS) is presented. The analytical investigation assumes shear lag transfer of tractions and strains. Analytical solution using the space-wise Fourier transform is reviewed and...

  • Piezoelectric Water Drop Energy Harvesting. Al Ahmad, Mahmoud // Journal of Electronic Materials;Feb2014, Vol. 43 Issue 2, p452 

    Piezoelectric materials convert mechanical deformation directly into electrical charges, which can be harvested and used to drive micropower electronic devices. The low power consumption of such systems on the scale of microwatts leads to the possibility of using harvested vibrational energy due...

  • Right-angle piezoelectric cantilever with improved energy harvesting efficiency. Jia Wen Xu; Wei Wei Shao; Fan Rang Kong; Zhi Hua Feng // Applied Physics Letters;4/12/2010, Vol. 96 Issue 15, p152904 

    This paper reports a piezoelectric device based on a cantilever with an extended auxiliary part that forms a right angle with the basic part. Theoretical analyses and experiments support that, by using such a device, uniform strain distribution in piezoelectric element surfaces can be obtained,...

  • Problem of thermoelectromagnetoelasticity for a piezoelectric/piezomagnetic bimaterial with interface crack. Loboda, V. V.; Khodanen, T. V. // Journal of Mathematical Sciences;Mar2010, Vol. 165 Issue 3, p301 

    We consider a plane strain problem for a piezoelectric/piezomagnetic bimaterial space with a crack in the region of the interface of the materials. At infinity, tensile and shear stresses and heat, electric, and magnetic flows are set. Using representations for all mechanical, thermal, and...

  • Interfacial fracture analysis of a piezoelectric-polythene composite cylindrical shell patch under axial shear. Li, Yong-Dong; Xiong, Tao; Zhao, Hao // Acta Mechanica;Feb2014, Vol. 225 Issue 2, p543 

    The present work studies the interfacial fracture in a piezoelectric cylindrical shell patch. The problem is solved by the methods of infinite trigonometric series and Cauchy singular integral equation, and the numerical results of the stress intensity factor (SIF) are obtained. The effects of...

  • Development of a Low Frequency Shear Horizontal Piezoelectric Transducer for the Generation of Plane SH Waves. Boivin, Guillaume; Viens, Martin; Belanger, Pierre // AIP Conference Proceedings;2016, Vol. 1706 Issue 1, p1 

    The shear horizontal guided wave fundamental mode (SH0) has the particularity of being the only nondispersive plate guided wave mode. This characteristic makes this ultrasonic guided wave mode very attractive in nondestructive testing, facilitating signal processing for long range inspections....

  • The roles of shear and cross-correlations on the fluctuation levels in simple stochastic models. Krommes, John A. // Physics of Plasmas;Apr2000, Vol. 7 Issue 4 

    Highly simplified models of random flows interacting with background microturbulence are analyzed. In the limit of very rapid velocity fluctuations, it is shown rigorously that the fluctuation level of a passively advected scalar is not controlled by the rms shear. In a model with random...

  • Quasi-static stress fields for a crack inclined to the property gradation in functionally graded materials. Chalivendra, V. B.; Shukla, A.; Parameswaran, V. // Acta Mechanica;2003, Vol. 162 Issue 1/4, p167 

    Quasi-static stress fields for a crack inclined to the direction of property gradation in functionally graded materials (FGMs) are obtained through an asymptotic analysis coupled with Wester-gaard's stress function approach. The elastic modulus of the FGM is assumed to vary exponentially along...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics