TITLE

Pulsed-laser printing of organic thin-film transistors

AUTHOR(S)
Rapp, Ludovic; Diallo, Abdou Karim; Alloncle, Anne Patricia; Videlot-Ackermann, Christine; Fages, Frédéric; Delaporte, Philippe
PUB. DATE
October 2009
SOURCE
Applied Physics Letters;10/26/2009, Vol. 95 Issue 17, p171109
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Organic thin-film transistors have been fabricated using laser-induced forward transfer as spatially resolved laser-printing method. Using this technique, source and drain electrodes were deposited from silver nanoparticle ink and the copper phthalocyanine (CuPc) was used to form the active layer. Both kinds of materials were transferred from a donor substrate onto a receiver substrate upon irradiation with laser pulses in the picosecond regime. The latter substrate formed the gate and the dielectric of the transistor. Electrical characterizations showed that the transistors are fully operative, showing well-defined linear and saturation regimes in the I-V curves.
ACCESSION #
44909833

 

Related Articles

  • Organic thin-film transistors in sandwich configuration. Jian Zhang; Wang, Jun; Wang, Haibo; Yan, Donghang // Applied Physics Letters;1/5/2004, Vol. 84 Issue 1, p142 

    Organic thin-film transistors (OTFTs) having source/drain electrodes sandwiched between copper phthalocyanine (CuPc) and cobalt phthalocyanine (CoPc) layers, CuPc/CoPc SC OTFTs, are investigated. Comparing their properties with that of CuPc-based top-contact OTFT, field-effect mobility increases...

  • Copper phthalocyanine buffer layer to enhance the charge injection in organic thin-film transistors. Chen, Fang-Chung; Kung, Li-Jen; Chen, Tung-Hsien; Lin, Yung-Sheng // Applied Physics Letters;2/12/2007, Vol. 90 Issue 7, p073504 

    Copper phthalocyanine (CuPC) has been used as the buffer layer for source and drain electrodes to improve the performance of organic thin-film transistors. The mobility was improved by almost onefold after the modification. By incorporating with CuPC, the contact resistance was reduced, deduced...

  • Ambipolar copper phthalocyanine transistors with carbon nanotube array electrodes. Cicoira, Fabio; Coppedé, Nicola; Iannotta, Salvatore; Martel, Richard // Applied Physics Letters;5/2/2011, Vol. 98 Issue 18, p183303 

    We report on organic thin film transistors (OTFTs) based on copper phthalocyanine (CuPc) having electrodes consisting of isolated carbon nanotube (CNT) arrays embedded in the organic layer. CuPc OTFT with CNT array electrodes show p-type behavior with Ohmic hole injection, high hole mobility,...

  • Laser imprint reduction with a short shaping laser pulse incident upon a foam-plastic target. Metzler, Nathan; Velikovich, Alexander L.; Schmitt, Andrew J.; Gardner, John H. // Physics of Plasmas;Dec2002, Vol. 9 Issue 12, p5050 

    In the previous work [Metzler et al., Phys. Plasmas 6, 3283 (1999)] it was shown that a tailored density profile could be very effective in smoothing out the laser beam nonuniformities imprinted into a laser-accelerated target. However, a target with a smoothly graded density is difficult to...

  • Bilayer processing for an enhanced organic-electrode contact in ultrathin bottom contact organic transistors. Jeongwon Park; Yang, Richard D.; Colesniuc, Corneliu N.; Sharoni, Amos; Sungho Jin; Schuller, Ivan K.; Trogler, William C.; Kummel, Andrew C. // Applied Physics Letters;5/12/2008, Vol. 92 Issue 19, p192904 

    A bilayer lift-off process has been employed to fabricate optimal electrode contact geometry for statistical characterization of ultrathin organic thin-film transistors (OTFTs). For over 100 p-channel ultrathin (12 ML) copper phthalocyanine (CuPc) OTFTs, the bilayer photoresist lift-off process...

  • Thin-film transistors based on nickel phthalocyanine. Guillaud, G.; Madru, R.; Sadoun, M. Al; Maitrot, M. // Journal of Applied Physics;11/1/1989, Vol. 66 Issue 9, p4554 

    Develops thin-film transistors using nickel phthalocyanine as active component. Characteristics of drain current versus drain voltage; Thickness of phthalocyanine; Parameters obtained with several phthalocyanine thicknesses on oxidized wafers.

  • Temperature-enhanced electron detachment from C6F6- negative ions. Datskos, P. G.; Christophorou, L. G.; Carter, J. G. // Journal of Chemical Physics;5/15/1993, Vol. 98 Issue 10, p7875 

    A method is described whereby photoelectrons generated by a short laser pulse at the cathode of a parallel-plate electrode arrangement are depleted by attachment to C6F6 molecules mixed with N2 in the interelectrode space as they drift to the anode under an externally applied electric field. The...

  • Enhanced adhesion and performance of the source/drain electrode using a single-layered Ag(Cu) film for an amorphous silicon thin-film transistor. Hong, S.J.; Lee, S.; Park, J.B.; Yang, H.J.; Ko, Y.K.; Lee, J.G.; Cho, B.S.; Jeong, C.O.; Chung, K.H. // Applied Physics Letters;10/20/2003, Vol. 83 Issue 16, p3419 

    The feasibility of using a Ag(Cu) alloy film as a source/drain electrode for thin-film transistor (TFT) liquid-crystal displays has been investigated. The annealing of a Ag(Cu)/Si structure, for 30 min at 200 °C, produced a uniform Cu[sub 3]Si layer at the Ag(Cu)–Si interface, as a...

  • Model of mechanical effect of nanosecond laser radiation upon monolithic glassy carbon on formation of an emitting structure. Chebotarevsky, Yu.; Surmenko, E.; Popov, I.; Pavlov, D.; Sokolova, T.; Shesterkin, V. // Journal of Communications Technology & Electronics;Jan2016, Vol. 61 Issue 1, p66 

    A mathematical model of the mechanical effect of nanosecond laser pulse radiation on brittle materials is suggested. An analytic technique is developed for estimating the strength of monolithic glassy carbon on formation on its surface of an emitting structure by a series of nanosecond laser...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics