TITLE

Generation and manipulation of droplets in an optoelectrofluidic device integrated with microfluidic channels

AUTHOR(S)
Do-Hyun Lee; Hyundoo Hwang; Je-Kyun Park
PUB. DATE
October 2009
SOURCE
Applied Physics Letters;10/19/2009, Vol. 95 Issue 16, p164102
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
This letter describes an optoelectrofluidic platform integrated with microfluidic channels for continuous generation and programmable manipulation of water-in-oil droplet emulsions. A microchannel was integrated into a film-based optoelectrofluidic device by selective perforation of poly(dimethylsiloxane) layer for simultaneously performing microfluidic generation and optoelectrofluidic manipulation of droplets in a single device. By using this device, we could continuously generate, interactively transport, and merge multiple droplets using optically induced virtual electrodes.
ACCESSION #
44837249

 

Related Articles

  • Achieving a Low Ground Resistance using Critical Resistance Area Concept. Eduful, George; Cole, Joseph Ekow; Okyere, Philip Yaw // AIP Conference Proceedings;6/17/2010, Vol. 1247 Issue 1, p145 

    Based on response curves derived from field measurements, optimum number of vertical ground electrodes for grounding electrical installation is determined. On sites where the optimum number of the electrodes cannot reach a target ground resistance, a ‘critical resistance area...

  • Enhancement of film-forming reactions for microcrystalline Si growth in atmospheric-pressure plasma using porous carbon electrode. Kakiuchi, Hiroaki; Ohmi, Hiromasa; Inudzuka, Ryohei; Ouchi, Kentaro; Yasutake, Kiyoshi // Journal of Applied Physics;Sep2008, Vol. 104 Issue 5, p053522 

    We have investigated the structural and electrical properties of microcrystalline silicon (μc-Si:H) films deposited with high rates (≥5 nm/s) at 220 °C in atmospheric-pressure He/H2/SiH4 plasma excited by a 150 MHz, very high-frequency (VHF) power. For this purpose, Si films are...

  • Colossal electroresistance effect at metal electrode/La1-xSr1+xMnO4 interfaces. Tokunaga, Y.; Kaneko, Y.; He, J. P.; Arima, T.; Sawa, A.; Fujii, T.; Kawasaki, M.; Tokura, Y. // Applied Physics Letters;5/29/2006, Vol. 88 Issue 22, p223507 

    We have studied the current-voltage (I-V) characteristics and resistance switching at the interface between metal electrodes M (=Pt, Au, Ag, Al, Ti, and Mg) and atomically flat cleaved (001) surfaces of La1-xSr1+xMnO4 (x=0–1.0) single crystals by using a three-probe method. Hysteretic I-V...

  • Two-dimensional electrostatic force field measurements with simultaneous topography measurement on embedded interdigitated nanoelectrodes using a force distance curve based method. Jenke, Martin Günter; Santschi, Christian; Hoffmann, Patrik // Applied Physics Letters;2/11/2008, Vol. 92 Issue 6, p063113 

    Accurate simultaneous measurements on the topography and electrostatic force field of 500 nm pitch interdigitated electrodes embedded in a thin SiO2 layer in a plane perpendicular to the orientation of the electrodes are shown for the first time. A static force distance curve (FDC) based method...

  • Electrons line up to be counted.  // New Scientist;3/19/2005, Vol. 185 Issue 2491, p19 

    The article reports that individual electrons have been observed in a flowing current for the first time. Current is usually measured indirectly, for example by detecting the drop in voltage across a resistor. Now, a team from Chalmers University of Technology in Gothenburg, Sweden, has...

  • Tape casting of nickel manganite NTC ceramics for chip thermistors. Prasanth, N. P.; Varghese, Justin M.; Prasad, K.; Krishnan, Bindu; Seema, A.; Dayas, K. R. // Journal of Materials Science: Materials in Electronics;Nov2008, Vol. 19 Issue 11, p1100 

    Tape casting is a reliable route for mass production of precise miniature NTC chip sensors. The present paper describes the development work in tape casting of nickel manganite based NTC formulations. The most suitable dispersion condition of the powder in MEK�ethanol solvent system was...

  • Power Resistors. Kainoskas, Aimee // ECN: Electronic Component News;Mar2004, Vol. 48 Issue 3, p75 

    Evaluates various brands of power resistors. Model MHP Thick Film Power Resistor from BI Technologies; Model WSE0805 resistor from Vishay Technology; Comparison of features and functions; Dimensions.

  • Excitation of the l=2 diocotron mode with a resistive load. Bettega, G.; Cavaliere, F.; Paroli, B.; Pozzoli, R.; Romé, M.; Cavenago, M. // Physics of Plasmas;Mar2008, Vol. 15 Issue 3, p032102 

    The resistive wall instability of the l=2 diocotron mode in a pure electron plasma has been investigated with a systematic variation of the parameters of the external impedance connected to a pair of sectored electrodes. The measured growth rate is well described by a linear perturbation theory...

  • 5ppm thin film chip resistor.  // Electronics Weekly;9/8/2004, Issue 2161, p36 

    This article focuses on the extension of precision of its RN37 thin film resistors to 5ppm by the company KOA. The firm has used improvements to established thin film resistor technology, allowing lowest TCR's to be reduced from 10ppm to 5ppm. Resistance tolerances as tight as 0.05 percent are...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics