Microwave propagation in graphene

Deligeorgis, G.; Dragoman, M.; Neculoiu, D.; Dragoman, D.; Konstantinidis, G.; Cismaru, A.; Plana, R.
August 2009
Applied Physics Letters;8/17/2009, Vol. 95 Issue 7, p073107
Academic Journal
We report on measurements and modeling of microwave propagation in graphene. In deep contrast with carbon nanotubes, which display very high impedances in the microwave range, planar waveguides patterned directly on graphene display a 50 Ω impedance, which is tuned slightly by an applied dc. The high values of kinetic impedance in carbon nanotubes were not observed in graphene.


Related Articles

  • Double window configuration as a low cost microwave weveguide window for plasma applications. Baskaran, R. // Review of Scientific Instruments;Dec1997, Vol. 68 Issue 12, p4424 

    Discusses double window configuration as a low cost microwave waveguide window for plasma applications. Function of the waveguide window; Use of a flat flange as a waveguide window; Minimum power reflection; Advantages of using radial microwave coupling than axial coupling.

  • INTRODUCTION. Robinson, Joshua A.; Terrones, Mauricio; Golberger, Joshua; Boeckl, John J.; Varanasi, Chakrapani // Journal of Materials Research;Feb2014, Vol. 29 Issue 3, p297 

    An introduction is presented in which the editors discuss various reports within the issue on topics including studies on graphene and carbon nanotubes, isolation of graphene, and the development of innovative arrays of ribbon.

  • Graphene enhances substrates for CNT growth.  // Advanced Materials & Processes;Aug2013, Vol. 171 Issue 8, p18 

    The article focuses on research by scientists at Rice University and Honda Research Institute which revealed that graphene enhances the growth of carbon nanotube (CNT).

  • Full-wave verification of the fundamental properties of left-handed materials in waveguide configurations. Caloz, C.; Chang, C.-C.; Itoh, T. // Journal of Applied Physics;Dec2001, Vol. 90 Issue 11, p5483 

    The fundamental electromagnetic properties of left-handed materials (LHMs) are reviewed and verified by finite-element method full-wave analysis using rectangular waveguide structures loaded by a LHM and adopting an effective medium approach. The negative phase velocity, positive intrinsic...

  • Four probe architecture using high spatial resolution single multi-walled carbon nanotube electrodes for electrophysiology and bioimpedance monitoring of whole tissue. de Asis Jr., Edward D.; Leung, Joseph; Wood, Sally; Nguyen, Cattien V. // Applied Physics Letters;3/1/2010, Vol. 96 Issue 9, p093701 

    We report the application of a sensor with a multielectrode architecture consisting of four single multiwalled carbon nanotube electrodes (sMWNT electrodes) with nanotube tip diameters of approximately 30 nm to stimulation, recording, and bioimpedance characterization of whole muscle. Parallel...

  • Transmission line impedance of carbon nanotube thin films for chemical sensing. Esen, G.; Fuhrer, M. S.; Ishigami, M.; Williams, E. D. // Applied Physics Letters;3/19/2007, Vol. 90 Issue 12, p123510 

    The authors measure the resistance and frequency-dependent gate capacitance of carbon nanotube (CNT) thin films in ambient, vacuum, and under low pressure (10-6 Torr) analyte environments. They model the CNT film as a RC transmission line and show that changes in the measured capacitance as a...

  • Soft limiting circuit implementable with a single multi-walled carbon nanotube. Ming-Huei Chen; Jyh-Hua Ting; Bo-Zhi Yang; Sheng-Ying Yang; Tsung-Lung Li // Applied Physics A: Materials Science & Processing;Jul2010, Vol. 100 Issue 1, p193 

    Dispersed growth techniques are applied to grow carbon nanotubes between metal pads on silicon wafers. Process conditions are tuned to yield nanotube devices having only one multi-walled carbon nanotube connecting the metal pads. The nonlinear transfer characteristics of these devices are often...

  • Study of the Effect of Damage on the Electrical Impedance of Carbon Nanotube Reinforced Epoxy Nanocomposites. Bekas, Dimitrios G.; Paipetis, Alkiviadis S. // Journal of Sensors;4/27/2015, Vol. 2015, p1 

    Within the scope of this work is the study of the effect of damage on the electrical hysteretic behaviour of carbon nanotube (CNT) reinforced epoxy nanocomposites. For that purpose CNT reinforced epoxy nanocomposites were subjected to different levels of damage and their response to an AC...

  • Switching Considerations for Microwave Test Systems. Semancik, Jon // EE: Evaluation Engineering;Apr2004, Vol. 43 Issue 4, p32 

    Presents information on microwave test systems in the electronics industry. Equation for the voltage standing wave ratio; Sources that cause impedance mismatches; Use of multiplexers in the system.


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics