TITLE

Hard x-ray detector based on microchannel plates

AUTHOR(S)
Shikhaliev, P.M.
PUB. DATE
March 1996
SOURCE
Review of Scientific Instruments;Mar96, Vol. 67 Issue 3, p700
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Reports on an investigation of special microchannel plate (MCP) detectors. Maximum angle of incidence on the convertor plate; Detection efficiency for beams with 2x2 cross section and energies of 662 and 122 keV; Possible applications.
ACCESSION #
4367110

 

Related Articles

  • Versatile microreactor for studies of gas–surface catalytic reactions between 10-7 and 1000 Torr. Vajo, J. J.; Tsai, W.; Weinberg, W. H. // Review of Scientific Instruments;Jul1985, Vol. 56 Issue 7, p1439 

    A microreactor system that is designed for studies of steady-state and batch heterogeneous reactions on a wire, foil, or single-crystal surface at pressures between 10[sup -7] and 1000 Torr is described. The applicability of the continuous stirred tank reactor approximation that facilitates the...

  • Thermal-wave measurement of thin-film thermal diffusivity with different laser beam configurations. Yu, X.Y.; Zhang, L.; Chen, G. // Review of Scientific Instruments;Jun96, Vol. 67 Issue 6, p2312 

    Investigates and compares three laser-based alternating current heating methods for measuring thermal diffusivity of free-standing thin-film structures. Use of a modulated laser beam as the heating source and a miniature thermocouple as the temperature sensor; Laser heating configurations tested.

  • Simple scanner for measuring laser beam size. Shelton, D. P. // Review of Scientific Instruments;Nov85, Vol. 56 Issue 11, p2176 

    A simple and inexpensive device for measuring the spot size of a laser beam is described. The device is constructed from a clock motor and scans wires of various diameter through the beam. It is most useful for beams of about 0.1 to 2 mm diameter.

  • Improved pulsed laser vaporization source for production of intense beams of neutral and ionized clusters. Milani, Paolo; deHeer, Walt A. // Review of Scientific Instruments;Jul1990, Vol. 61 Issue 7, p1835 

    We describe an improved laser vaporization source for production of intense and stable cluster beams. Intensity and stability are notably improved compared with standard sources by the introduction of a cavity in which the vaporization takes place before expansion. This source has been...

  • Optimizing area-backlighter performance in a difficult geometry. Kyrala, George A.; Klare, Ken; Workman, Jonathan // Review of Scientific Instruments;Mar2003, Vol. 74 Issue 3, p2182 

    It is relatively easy to predict backlighter performance when few beams intercept a simple flat target and backlight an optically thin object. However, when faced with a thick target, noncooperating geometry, and multiple objects in the path of the laser beams, it becomes a challenge to find the...

  • An improved optical system for photofield emission. Donders, P. J.; Hadley, K. W.; Lee, M. J. G. // Review of Scientific Instruments;Nov85, Vol. 56 Issue 11, p2074 

    An improved optical system has been designed for use in experimental studies of photofield emission. By increasing the angle of convergence of the focused laser beam onto the field emitter a smaller focal spot is obtained. For a given beam intensity, this results in a substantial increase in the...

  • Integrated development facility for the calibration of low-energy charged particle flight instrumentation. Biddle, Alan P.; Reynolds, John M. // Review of Scientific Instruments;Apr1986, Vol. 57 Issue 4, p572 

    A system has been developed specifically for the calibration and development of thermal ion instrumentation. The system is optimized to provide an extended, approximately 80-cm2 beam, with usable current rates ∼1 pA/cm2 at beam energies as low as 1 eV, with much higher values available with...

  • Laser guides atoms down narrow path.  // R&D Magazine;Jan96, Vol. 38 Issue 1, p9 

    Reports on the use of a laser beam to guide rubidium atoms down the middle of a hollow optical fiber by a team of Boulder, Colorado physicists. Technology use; Use of the laser lights oscillating electric field in drawing atoms into the beam.

  • Operation of the NSTX Thomson scattering system. LeBlanc, B. P.; Bell, R. E.; Johnson, D. W.; Hoffman, D. E.; Long, D. C.; Palladino, R. W. // Review of Scientific Instruments;Mar2003, Vol. 74 Issue 3, p1659 

    The National Spherical Torus Experiment (NSTX) multipoint Thomson scattering system has been in operation for nearly two years and provides routine T[sub e](R, t) and n[sub e](R, t) measurements. The laser beams from two 30 Hz Nd:YAG lasers are imaged by a spherical mirror onto 36 fiber-optic...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics