TITLE

Measurement of position and orientation of optical elements in interferometric gravity wave

AUTHOR(S)
Heitmann, Henrich; Drezen, Christine
PUB. DATE
August 1997
SOURCE
Review of Scientific Instruments;Aug1997, Vol. 68 Issue 8, p3197
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Describes the measurement of position and orientation of optical elements in interferometric gravity wave detectors. Description of the VIRGO interferometer; Fine and coarse measurement scheme; Imaging system; Calculation of the mass coordinates.
ACCESSION #
4358628

 

Related Articles

  • About the Detection of Gravitational Wave Bursts. Pradier, T.; Arnaud, N.; Bizouard, M.-A.; Cavalier, F.; Davier, M.; Hello, P. // International Journal of Modern Physics D: Gravitation, Astrophy;Jun2000, Vol. 9 Issue 3, p309 

    Several filtering methods for the detection of gravitational wave bursts in interferometric detectors are presented. These are simple and fast methods which can act as online triggers. All methods are compared to matched filtering with the help of a figure of merit based on the detection of...

  • TAMA Status Report. Kanda, Nobuyuki // International Journal of Modern Physics D: Gravitation, Astrophy;Jun2000, Vol. 9 Issue 3, p233 

    TAMA 300 m laser interferometric gravitational wave detector operated in August and September 1999. We had total four night operation with best strain sensitivity of 3 × 10[sub -20]. The longest continuous locking is over 7 hours. The calibration of the interferometer sensitivity was...

  • Gravitational wave detectors on the ground and in space. Danzmann, Karsten // AIP Conference Proceedings;2001, Vol. 551 Issue 1, p293 

    Small prototypes of gravitational wave detectors have been under development for over 30 years. But it is only now that we have the necessary technology available to build large instruments with good sensitivity. After several years of construction, the first ground-based interferometers will go...

  • Optimization of Parameters and the Ultimate Sensitivity of Interferometric Detectors of Gravitational Waves. Troitskiı, Yu. V. // Optics & Spectroscopy;Feb2001, Vol. 90 Issue 2, p250 

    The signal-to-shot-noise ratio is calculated for three types of laser interferometers used in gravitational wave detectors: for two types of Fabry-Perot interferometers (with direct reading of the output signal and with the modulation technique used for outcoupling the signal) and for the...

  • Response of Virgo Detectors to Pre-Big-Bang Gravitons. Babusci, D.; Giovannini, M.; Ahluwalia, D. V. // International Journal of Modern Physics D: Gravitation, Astrophy;Aug2001, Vol. 10 Issue 4, p477 

    The sensitivity achievable by a pair of VIRGO detectors to stochastic and isotropic gravitational wave backgrounds produced in pre-big-bang models is discussed in view of the development of a second VIRGO interferometer. We describe a semi-analytical technique allowing to compute the...

  • Laser Interferometer Gravitational Wave Detectors—the Challenges. Ju, L.; Zhao, C. // AIP Conference Proceedings;2005, Vol. 782 Issue 1, p264 

    The detection of gravitational waves is one of the greatest challenges of modern physics. A range of noise sources limit the sensitivity of all gravitational wave detectors. To improve sensitivity and create advanced detectors that will enable gravitational wave astronomy to begin requires all...

  • Active control of a balanced two-stage pendulum vibration isolation system and its application to laser interferometric gravity wave detectors. Veitch, P. J.; Robertson, N. A.; Cantley, C. A.; Hough, J. // Review of Scientific Instruments;May93, Vol. 64 Issue 5, p1330 

    The investigation of the servo control of the position of the bottom mass in a balanced two-stage pendulum vibration isolation system is reported. Experimental results for a simple prototype system and predictions based on a model presented in this paper are in good agreement. The application of...

  • Ultrahigh Q pendulum suspensions for gravitational wave detectors. Blair, D. G.; Ju, L.; Notcutt, M. // Review of Scientific Instruments;Jul1993, Vol. 64 Issue 7, p1899 

    Pendulum suspensions for laser interferometer gravitational wave detectors need to have an extremely high Q factor to minimize Brownian motion noise. In this paper we analyze the limits to the Q factor of the compound pendulum. We show that the observed acoustic loss of niobium can allow...

  • Gravitational wave detectors: Squeezing up the sensitivity. Schnabel, Roman // Nature Physics;Jun2008, Vol. 4 Issue 6, p440 

    The article highlights the study of K. Goda and colleagues regarding the successful completion of the real test in 40-meter practical gravitational wave detectors using suspended mirrors. According to the author, the detectors are based on Michelson interferometers whose mirrors are suspended...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics