Third-harmonic generation in GeO[sub 2]-doped silica single-mode optical fibers

Nicacio, D.L.; Gouveia, E.A.; Borges, N.M.; Gouveia-Neto, A.S.
May 1993
Applied Physics Letters;5/3/1993, Vol. 62 Issue 18, p2179
Academic Journal
Investigates the third-harmonic generation in GeO[sub 2]-doped silica single-mode optical fibers. Width of the generated blue-violet light; Dependence of intensity on doping concentrations; Onset of the frequency tripling process.


Related Articles

  • Response to ‘‘Comment on ‘Residual stress effects on refractive indices in undoped silica-core single-mode fibers’ ’’ [Appl. Phys. Lett. 52, 413 (1988)]. Hibino, Yoshinori; Hanawa, Fumiaki; Shibata, Shuichi; Abe, Tetsuji // Applied Physics Letters;2/1/1988, Vol. 52 Issue 5, p413 

    Responds to comments made by H. Hack about the authors' article 'Residual stress effects on refractive indices in undoped silica-core single-mode fibers.' Drawing induced stress in depressed clad fibers; Role of residual stress in the decrease of the refractive index in optical fibers.

  • Suspended-care fibers show high nonlinearity.  // Laser Focus World;Jan2009, Vol. 45 Issue 1, p13 

    The article focuses on the suspended-core fibers (SCFs) which is considered as an alternative for photonic-crystal fibers. It mentions that SCFs consist of a simpler, easier-to-fabricate design with potentially higher numerical aperture, smaller mode-filled diameters, and shorter zero-dispersion...

  • Drawing-induced residual stress effects on optical characteristics in pure-silica-core single-mode fibers. Hibino, Yoshinori; Hanawa, Fumiaki; Horiguchi, Masaharu // Journal of Applied Physics;1/1/1989, Vol. 65 Issue 1, p30 

    Presents a study that investigated the residual stress and its influence on optical characteristics for pure-silica-core/fluorine-doped-silica-clad single-mode fibers. Level of residual stress; Reduction of the refractive index in the core; Cause of the decrease of the refractive index in the core.

  • Effect of optical losses irregularity on wideband fiber Raman amplification for total telecom window in silica fibers. Felinskyi, G. S.; Dyriv, M. Y.; Korotkov, P. A. // Semiconductor Physics, Quantum Electronics & Optoelectronics;2013, Vol. 16 Issue 2, p117 

    Raman threshold pump power and optical amplification band calculations adjusted for attenuation dispersion in the range of total S+C+L telecom window of silica fibers (roughly from 1.46 to 1.62 µm) are presented. It has been shown that wavelength nonuniformity of signal attenuation...

  • An All Fiber Intrinsic Fabry-Perot Interferometer Based on an Air-Microcavity. Jáuregui-Vázquez, Daniel; Estudillo-Ayala, Julián M.; Rojas-Laguna, Roberto; Vargas-Rodríguez, Everardo; Sierra-Hernández, Juan M.; Hernández-García, Juan C.; Mata-Chávez, Ruth I. // Sensors (14248220);May2013, Vol. 13 Issue 5, p6355 

    In this work an Intrinsic Fabry-Perot Interferometer (IFPI) based on an air-microcavity is presented. Here the air microcavity, with silica walls, is formed at a segment of a hollow core photonic crystal fiber (HCPCF), which is fusion spliced with a single mode fiber (SMF). Moreover, the...

  • Long wavelength infrared (λ&bartil;11 μm) quantum cascade lasers. Sirtori, C.; Faist, J.; Capasso, F.; Sivco, D. L.; Hutchinson, A. L.; Cho, A. Y. // Applied Physics Letters;11/4/1996, Vol. 69 Issue 19, p2810 

    AlInAs/GaInAs quantum cascade (QC) lasers operating at λ=11.2 μm wavelength are reported. In pulsed operation the peak power is in excess of 50 mW at 110 K heat sink temperature and the devices have been operated at temperatures as high as 200 K. Continuous wave single-mode operation with...

  • Vertically tapered InGaAsP/InP waveguides for highly efficient coupling to flat-end single-mode.... Brenner, T.; Bachmann, M. // Applied Physics Letters;8/15/1994, Vol. 65 Issue 7, p798 

    Examines the coupling of indium (In) gallium arsenide/In phosphide optical waveguides with flat-end single-mode fibers. Use of the optoelectronic integrated circuit-diffusion limited etch process; Observation of radiation losses on vertical tapers; Ratio of polarization insensitive fiber to...

  • Mode identification in spherical microcavities doped with quantum dots. Mo¨ller, B.; Artemyev, M. V.; Woggon, U.; Wannemacher, R. // Applied Physics Letters;5/6/2002, Vol. 80 Issue 18, p3253 

    Using imaging spectroscopy at the diffraction limit, a polarization-sensitive mode mapping allows the experimental identification of transverse electric and transverse magnetic modes for spherical microcavities. The method is applied to microspheres surface covered by CdSe quantum dots. A...

  • Single-mode waveguide microlenses and microlens arrays fabrication in LiNbO3 using titanium indiffused proton exchange technique. Zang, D. Y.; Tsai, C. S. // Applied Physics Letters;4/15/1985, Vol. 46 Issue 8, p703 

    Single-mode planar waveguide microlenses and microlens arrays in LiNbO3 have been fabricated using a combination of titanium diffusion and proton exchange processes. The lenses have demonstrated properties such as very short focal length, micron focal spot size, and large angular field of view...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics