TITLE

Characterization and comparison of nanoscale domain boundary in congruent and stoichiometric LiTaO3 with scanning nonlinear dielectric microscopy

AUTHOR(S)
Dae-Yong Jeong; Yasuo Cho
PUB. DATE
July 2009
SOURCE
Applied Physics Letters;7/13/2009, Vol. 95 Issue 2, p022908
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
The domain boundary of congruent LiTaO3 (CLT) and stoichiometric LiTaO3 (SLT) were characterized on the nanoscale using scanning nonlinear dielectric microscopy. SLT exhibited a smooth domain boundary but CLT showed an irregular domain boundary. The nonlinear dielectric constant [variant_greek_epsilon]333 in the domain boundary of SLT changed abruptly from the domain but there was a gradual change in [variant_greek_epsilon]333 in the boundary of CLT. The linear dielectric constant in the domain boundary of SLT was slightly higher than that in the domain itself. In addition, the topography showed that only SLT had <1 nm dimensional deformation in the domain boundary.
ACCESSION #
43277324

 

Related Articles

  • THEORETICAL AND EXPERIMENTAL EVALUATION OF SUPERSTRATE EFFECT ON RECTANGULAR PATCH RESONATOR PARAMETERS. Aouabdia, N.; Belhadj-Tahar, N. E.; Alquie, G.; Benabdelaziz, F. // Progress in Electromagnetics Research B;Oct2011, Vol. 32, p129 

    In this paper, modeling and experimentation of a Rectangular Patch Resonator (RPR) covered with a dielectric superstrate are investigated. The RPR criteria are established theoretically and experimentally, to be used in future prospects as an electromagnetic (EM) sensor for the characterization...

  • Pulsed deposition of metal–oxide thin films using dual metal precursors. Conley Jr., J. F.; Ono, Y.; Tweet, D. J.; Solanki, R. // Applied Physics Letters;1/19/2004, Vol. 84 Issue 3, p398 

    A technique for depositing high-dielectric-constant metal–oxide thin films is demonstrated that consists of alternating pulses of metal–chloride precursors and Hf(NO[sub 3])[sub 4] in which Hf(NO[sub 3])[sub 4] is used as an oxidizing agent as well as a metal source. The use of...

  • PCB Dielectric Materials for HIGH-SPEED APPLICATIONS. GALI, RAVINDRA // Printed Circuit Design & Manufacture;Dec2008, Vol. 25 Issue 12, p40 

    The article discusses the effect of glass weave in a laminate on propagation velocity and loss profile in a printed circuit board (PCB). It is noted that proper dielectric material selection enables the PCB designer to minimize the dielectric loss. Designers are advised to carefully evaluate the...

  • Dielectric and shear mechanical relaxations in glass-forming liquids: A test of the Gemant-DiMarzio-Bishop model. Niss, Kristine; Jakobsen, Bo; Olsen, Niels Boye // Journal of Chemical Physics;12/15/2005, Vol. 123 Issue 23, p234510 

    The Gemant-DiMarzio-Bishop model, which connects the frequency-dependent shear modulus to the frequency-dependent dielectric constant, is reviewed and a new consistent macroscopic formulation is derived. It is moreover shown that this version of the model can be tested without fitting...

  • Dielectric Properties of Ba2Bi4Ti5O18 by Co-precipitation and Citrate Gel Methods. Kalaiselvi, B. J. // International Journal of Nanotechnology & Applications;2010, Vol. 4 Issue 2, p103 

    The aim of the present work is to prepare single-phase Ba2Bi4Ti5O18 fine powders from simple salts by chemical methods, namely co-precipitation and citrate gel techniques. The XRD pattern for both the materials and the particle size measurement using Scherrer equation on the pure single or...

  • Electrical Properties and Phase Transition Behaviors of Sn Doped 0.45PZT-0.55PNN Ceramics. Sutjarittangtham, K.; Tawichai, N.; Intatha, U.; Eitssayeam, S.; Pengpat, K.; Rujijanagul, G.; Tunkasiri, T. // AIP Conference Proceedings;7/23/2009, Vol. 1151 Issue 1, p174 

    Dielectric properties, and phase transition behaviors of Sn doped 0.45PbZr1/2Ti1/2O3—0.55PbNi1/3Nb2/3O3 ceramics has been investigated. The ceramics were prepared by a normal solid-state method and were characterized, using a variety of techniques. For undoped samples, high relative...

  • Dielectric dispersion of CaCu3Ti4O12 ceramics at high temperatures. Zhang, J. L.; Zheng, P.; Wang, C. L.; Zhao, M. L.; Li, J. C.; Wang, J. F. // Applied Physics Letters;10/3/2005, Vol. 87 Issue 14, p142901 

    CaCu3Ti4O12 ceramics has been prepared by the conventional solid-state reaction method under different sintering conditions. Dielectric properties have been investigated in the temperature range of 25–350 °C within the frequency range of 40 Hz–10 MHz. It has been found that both...

  • CVD? Spin-on? Why Not Both? Chappell, Jeff // Electronic News;6/9/2003, Vol. 49 Issue 23, pN.PAG 

    Focuses on the different approaches which are recommended for producing a copper interconnect dielectric. Challenges brought about by copper and low k; Description of the hybrid approach; Examples of companies that are involved in developing approaches.

  • Response to “Comment on ‘On the negative value of dielectric permittivity of the water surface layer’ ” [ Appl. Phys. Lett. 85, 1301 (2004) ]. Cherpak, N. T.; Barannik, A. A.; Prokopenko, Yu. V. // Applied Physics Letters;8/16/2004, Vol. 85 Issue 7, p1302 

    It is informed that there is no need for the introduction of a negative dielectric constant for an explanation of positive shift of the resonance frequency of the dielectric resonator with water. It is further informed that similarity of experimental results on the frequency shift of resonator...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics