TITLE

Generalized breakdown voltage characteristic of the pseudospark

AUTHOR(S)
Rhee, M.J.; Liu, C.J.
PUB. DATE
December 1994
SOURCE
Applied Physics Letters;12/26/1994, Vol. 65 Issue 26, p3314
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Examines the pseudospark breakdown voltage characteristic for argon gas. Applications of pseudospark phenomenon for high power switching; Relationship between the energy spectrum of the electron beam and breakdown voltage; Measurement of the breakdown voltage with cylindrical cavity.
ACCESSION #
4319485

 

Related Articles

  • Early stages of channel formation in a short-gap breakdown. Novak, J. P.; Bartnikas, R. // Journal of Applied Physics;8/15/1988, Vol. 64 Issue 4, p1767 

    Presents a study that examined a description and analysis of the solution of a two-dimensional model for a high voltage breakdown of a short gap. Description of the model used in the study; Results; Discussion.

  • Modeling of self-breakdown voltage statistics in high-energy spark gaps. Donaldson, A. L.; Hagler, M. O.; Kristiansen, M.; Hatfield, L. L.; Ness, R. M. // Journal of Applied Physics;6/1/1985, Vol. 57 Issue 11, p4981 

    Presents a study which described a model that incorporates the influence of electrode surface conditions, gas pressure and charging rate on the voltage stability of high-energy spark gaps. Numerical calculations for the model; Experimental details; Results.

  • A High-Voltage Switching Device Based on Two High-Current Vacuum Gaps Connected in Series. Sidorov, V. A.; Alferov, D. F. // Instruments & Experimental Techniques;Mar/Apr2003, Vol. 46 Issue 2, p181 

    A high-voltage switch that consists of two РВУ-43 triggered vacuum spark gaps connected in series has been manufactured and tested. The switch is intended for use at a voltage of up to 80 kV. The maximum current switched is 200 kA. The breakdown strength of the switch has been...

  • The High-Temperature Effect on the Breakdown Voltage of an Air-Gap at Atmospheric Pressure with Reference to Paschen Curve. Abdel-Fattah, Mohamed F.; Lehtonen, Matti // International Review of Electrical Engineering;Nov/Dec2013, Vol. 8 Issue 6, p1876 

    The breakdown voltage of an air-gap was determined as a function of gap pressure-spacing product as given by Paschen curve at 20 °C. This was followed by experimental research on the effect of temperature on the breakdown voltage. In this paper, a family of Paschen curves is calculated as a...

  • Recovery of gas density in a nitrogen gap after breakdown. Xinjing Cai; Xiaobing Zou; Xinxin Wang; Liming Wang; Zhicheng Guan; Weihua Jiang // Applied Physics Letters;9/6/2010, Vol. 97 Issue 10, p101501 

    The recovery of the gas density and the hold-off voltage of a spark gap after breakdown were investigated with Mach–Zehnder interferometry and two-pulse method, respectively. It was shown that the gas density in a 2.7 mm gap filled with atmospheric nitrogen almost fully recovers at t=50...

  • Study on Relationships between High-frequency High-voltage Pulse Breakdown Voltage of Air-Gaps and Pulse Delay Time. Lili Li; Yulong Wang; Hongda Yang // Advanced Materials Research;2014, Vol. 981, p683 

    In the paper, power frequency and high-frequency high-voltage pulse breakdown voltage of air-gaps were measured by circuits of spark gap switches respectively, and then output waveforms were obtained by sampling circuits, finally a large number of data in experiments were recorded and were drawn...

  • Experimental verification of the capillary plasma triggered long spark gap under the extremely low working coefficient in air. Huang, D.; Yang, L. J.; Huo, P.; Ma, J. B.; Liu, S.; Wang, W.; Ding, W. D.; Li, G.; Yao, S. L. // Physics of Plasmas;2016, Vol. 23 Issue 1, p1 

    The paper has proposed a new triggering method for long spark gap based on capillary plasma ejection and conducted the experimental verification under the extremely low working coefficient, which represents that the ratio of the spark gap charging voltage to the breakdown voltage is particularly...

  • Flip the Switch On Sags and Dips. Cranford, Larry M. // Transmission & Distribution World;Feb99, Vol. 51 Issue 2, p32 

    Provides information on the response of Accuma, a manufacturer in Statesville, North Carolina, to the voltage dip problem it experienced. Sources that were indentified with the sag problem; Details on the combination of the planned system improvements and modifications to the city's service to...

  • Enhanced breakdown voltages in strained InGaAs/GaAs structures. David, J.P.R.; Morley, M.J.; Wolstenholme, A.R.; Grey, R.; Pate, M.A.; Hill, G.; Rees, G.J.; Robson, P.N. // Applied Physics Letters;10/26/1992, Vol. 61 Issue 17, p2042 

    Examines the enhanced breakdown voltages in strained indium gallium arsenide (InGaAs)/gallium arsenide (GaAs) semiconductors. Dependence of impact ionization process on the threshold voltage; Impact of strain on threshold voltage despite decreasing band-gap; Effect of indium composition on...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics