Interaction of amorphous fluoropolymer with metal

Wu, P.K.; Yang, G.-R.; Ma, X.F.; Lu, T.-M.
July 1994
Applied Physics Letters;7/25/1994, Vol. 65 Issue 4, p508
Academic Journal
Examines the bonding structure of an amorphous fluoropolymer AF 1600 with aluminum, gold, silver and copper. Use of x-ray photoelectron spectroscopy; Formation of AlF[sub 3] with the detachment of fluorine; Absence of chemical reaction in the spin-on AF 1600 film on gold, silver and copper.


Related Articles

  • Amorphous fluoropolymers as insulators for reversible low-voltage electrowetting. Seyrat, Emilie; Hayes, Robert A. // Journal of Applied Physics;8/1/2001, Vol. 90 Issue 3 

    Amorphous fluoropolymers have been used as a hydrophobic “top coat” of insulating materials for electrowetting, to confer the reversibility required for practical applications. The electrical properties of such fluoropolymers (in particular breakdown voltages of less than 20 V/μm)...

  • Porous organic molecules. Holst, James R.; Trewin, Abbie; Cooper, Andrew I. // Nature Chemistry;Nov2010, Vol. 2 Issue 11, p915 

    Most synthetic materials that show molecular-scale porosity consist of one-, two- or three-dimensional networks. Porous metal-organic frameworks in particular have attracted a lot of recent attention. By contrast, discrete molecules tend to pack efficiently in the solid state, leaving as little...

  • Laser with guided pump and free-propagating resonator mode using diffusion-bonded rectangular channel waveguides. Griebner, U.; Grunwald, R.; Scho¨nnagel, H.; Huschke, J.; Erbert, G. // Applied Physics Letters;11/27/2000, Vol. 77 Issue 22 

    We report the laser performance of a short diffusion-bonded diode-pumped Yb:YAG rectangular channel waveguide of 100 μm cross section. Using an end-pumped configuration guiding only the slow axis, a high overlap of the pump mode and the nonguided resonator mode is achieved. With 4 W of pump...

  • "LÖT 2013" - Conference on brazing, high temperature brazing and diffusion bonding.  // Welding & Cutting;2013, Vol. 2013 Issue 3, p146 

    The article offers information on the LÖT 2013, the 10th international conference on brazing, high temperature brazing and diffusion bonding, to be held in Aachen, Germany from June 18-20, 2013.

  • Bond contraction and lone pair interaction at nitride surfaces. Sun, C. Q.; Tay, B. K.; Lau, S. P.; Sun, X. W.; Zeng, X. T.; Li, S.; Bai, H. L.; Liu, H.; Liu, Z. H.; Jiang, E. Y. // Journal of Applied Physics;9/1/2001, Vol. 90 Issue 5 

    It is shown that bond contraction and nonbonding lone-pair interaction dominate at nitride surfaces. The maximum elastic recovery of a nitride surface was found to be 100% under a relatively lower nanoindentation load (<1.0 mN) and the hardness of the surface was found to be 100% higher than the...

  • A Study of Diffusion- and Interface-Controlled Migration of the Austenite/Ferrite Front during Austenitization of a Case-Hardenable Alloy Steel. Schmidt, Eric D.; Damm, E. Buddy; Sridhar, Seetharaman // Metallurgical & Materials Transactions. Part A;Apr2007, Vol. 38 Issue 4, p698 

    A correction to the article "A Study of Diffusion- and Interface-Controlled Migration of the Austenite/Ferrite Front during Austenitization of a Case-Hardenable Alloy Steel" that was published in the February 2007 issue is presented.

  • Supercritical Hydrogen Adsorptivity of Amorphous Carbon Mesotubes. Kawase, Yusuke; Ohmori, Takumi; Niimura, Subaru; Fujimori, Toshihiko; Itoh, Tsutomu; Sakamoto, Hirotoshi; Miyamoto, Junichi; Noguchi, Hiroshi; Tanaka, Hideki; Kanoh, Hirofumi; Nishino, Hitoshi; Nishida, Ryoichi; Kaneko, Katsumi // Adsorption Science & Technology;Aug2011, Vol. 29 Issue 8, p819 

    High-pressure adsorption isotherms of hydrogen onto amorphous carbon mesotubes (ACMs) prepared from fluorine polymer and onto activated carbon fibres (ACFs) were measured at temperatures of 77, 196 and 303 K, respectively, at pressures up to 10 MPa. The adsorption isotherms for ACMs and ACFs at...

  • Fast through-bond diffusion of nitrogen in silicon. Schultz, Peter A.; Nelson, Jeffrey S. // Applied Physics Letters;2/5/2001, Vol. 78 Issue 6, p736 

    We report first-principles total energy calculations of interaction of nitrogen in silicon with silicon self-interstitials. Substitutional nitrogen captures a silicon interstitial with 3.5 eV binding energy forming a <100> split interstitial ground-state geometry, with the nitrogen forming three...

  • Selective field evaporation in field-ion microscopy for ordered alloys. Ge, Xi-jin; Chen, Nan-xian // Journal of Applied Physics;4/1/1999, Vol. 85 Issue 7, p3488 

    Assesses the bonding energies of surface atoms of intermetallic compounds. Use of semiempirical pair potentials in the investigation; Provision of a calculational model of selective field evaporation; Presentation of a qualitative interpretation of image contrast for several alloys.


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics