TITLE

Harvesting magnetic energy using extensional vibration of laminated magnetoelectric plates

AUTHOR(S)
Zhang, C. L.; Yang, J. S.; Chen, W. Q.
PUB. DATE
July 2009
SOURCE
Applied Physics Letters;7/6/2009, Vol. 95 Issue 1, p013511
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Magnetically forced extensional vibrations of laminated plates with piezoelectric and piezomagnetic layers are analyzed theoretically. It is shown that such a structure can be used to harvest magnetic energy and convert it to electric energy. The output power and the energy conversion efficiency are calculated. The load dependence of the magnetoelectric coupling coefficient is also obtained.
ACCESSION #
43158403

 

Related Articles

  • A wideband magnetic energy harvester. Zhang, C. L.; Chen, W. Q. // Applied Physics Letters;3/22/2010, Vol. 96 Issue 12, p123507 

    A wideband magnetic energy harvester is proposed by using a number of multiferroic composite fibers of different lengths which are connected in parallel or series. The structural theory is employed to characterize the magnetoelectroelastic behavior of the fibers. A global circuit analysis is...

  • The magnetostrictive material effects on magnetic field sensitivity for magnetoelectric sensor. Chen, Lei; Li, Ping; Wen, Yumei; Qiu, Jing // Journal of Applied Physics;Apr2012, Vol. 111 Issue 7, p07E503 

    The magnetic sensitivity to magnetic field for the magnetoelectric (ME) sensor is studied. Theoretical analysis predicts that the ME voltage sensitivity to Hac (i.e., ∂VME/∂Hac under dc bias field) and the ME voltage sensitivity to Hdc (i.e., ∂VME/∂Hdc under ac bias...

  • High-Performance 1-3-Type Relaxor-Ferroelectric-Based Composites. Panich, A. E.; Topolov, V. Yu; Glushanin, S. V. // Proceedings of the International Conference Vibroengineering;2006, p226 

    A novel 1—3-type piezo-active composite is proposed to demonstrate large values of hydrostatic parameters. This composite consists of relaxor-ferroelectric single-crystal rods extended in the poling direction and a 2–2-type matrix that contains layers of two polymers with...

  • On the minimum coupling required for maximum theoretical power capture from vibration energy harvesters. Kim, D.; Hewa-Kasakarage, N. N.; Yoon, S.; Hall, N. A. // Applied Physics Letters;9/3/2012, Vol. 101 Issue 10, p103904 

    The minimum transducer coupling to enable maximum theoretical power capture from vibration energy harvesters is derived, leading to the simple conclusion that the product of the transducer coupling coefficient and resonance quality factor must be greater than two. Maximum theoretical power...

  • Magnetoelectric coupling of [00l]-oriented Pb(Zr0.4Ti0.6)O3–Ni0.8Zn0.2Fe2O4 multilayered thin films. Ryu, Sangwoo; Park, Jung H.; Jang, Hyun M. // Applied Physics Letters;10/1/2007, Vol. 91 Issue 14, p142910 

    Multilayered thin films consisting of alternatively stacking Pb(Zr0.4Ti0.6)O3 (PZT) and Ni0.8Zn0.2Fe2O4 (NZFO) layers were fabricated to exploit a strain-mediated coupling of piezoelectricity and magnetostriction. The 450-nm-thick PZT/NZFO multilayer fabricated by pulsed laser deposition showed...

  • Vibration Monitoring of Rotating Systems. Ede, K. N.; Ogbonnaya, E. A.; Lilly, M. T.; Ogaji, S. O. T.; Probert, S. D. // Engineering;Jan2010, Vol. 2 Issue 1, p46 

    Most energy-conversion machines (e.g. vehicle engines and electric motors) involve rotating components (e.g. roller bearings and gears), which generate vibrations. The behavior of a pump which includes a deliberate fault was chosen to illustrate this assertion. The test bearing at the driven end...

  • Magnetoelectric characteristics of a dual-mode magnetostrictive/piezoelectric bilayered composite. Lei Li; Xiang Ming Chen // Applied Physics Letters;2/18/2008, Vol. 92 Issue 7, p072903 

    The magnetoelectric characteristics of a Terfenol-D/Pb(Zr,Ti)O3 bilayered composite were investigated, and an additional bending vibration mode due to the asymmetrical structure was observed besides the length vibration mode which also acted in the symmetrical trilayered composites. The module...

  • Analysis of Energy Harvester Generation using Vibration. Jambek, Asral Bin Bahari; Jing, TiongGuang; Hashim, Uda // Journal of Applied Sciences Research;Nov2013, Vol. 9 Issue 11, p5572 

    This paper discusses an analysis of harvesting electrical energy from vibration. In this work, two sizes of piezoelectric devices are used as the energy harvester. The piezoelectric devices convert kinetic energy, in the form of vibration, into electrical energy. The electrical energy generated...

  • Self-Powered, Wireless Technology Opens New Applications. Olson, Chris // Buildings;Mar2010, Vol. 104 Issue 3, p20 

    The article features the wireless technology promoted by EnOcean Alliance and its partners which offers controls without the use of batteries. These include energy-harvesting devices that are enabled by radio protocols to transmit signals in brief, energy-conserving bursts. A type of this device...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics