Instrument for the in situ measurement of haze in aircraft windscreens

Gallagher III, Frank W.; Brock, Fred V.
June 1996
Review of Scientific Instruments;Jun96, Vol. 67 Issue 6, p2083
Academic Journal
Reports on the development of a prototype instrument that measures haze in aircraft windscreens. Elimination of ambient light and compensation for the remaining illumination; Need for precise orientation of the collimator and the integrating sphere.


Related Articles

  • Active low frequency vertical vibration isolation. Hensley, Joel M.; Peters, Achim; Chu, Steven // Review of Scientific Instruments;Jun99, Vol. 70 Issue 6, p2735 

    Describes the construction of a system that isolates a key element of an experimental setup from vertical motions of the ground and the surrounding apparatus. Theory; Mechanical system; Electronic feedback; Alignment.

  • A newly developed low drift fast response salinity meter. Bidokhti, A. A.; Bidokhti, A.A.; Peacock, A. // Review of Scientific Instruments;Sep2000, Vol. 71 Issue 9 

    Here a new conductivity probe, which is basically a stainless steel tube with a plastic plug with a hole, plugged in one end, is described. The tube is externally insulated and the other electrode is (usually earthed) a metallic slab fixed in the fluid. The electronic used is of a conventional...

  • Three-in-one functionality. whitel // MWP (Online Edition);10/ 4/2012, p207 

    The article evaluates Talyrond 500 instruments for roundness, form and surface finish measurements.

  • Feasibility and applicability of integrated metrology using spectroscopic ellipsometry in a cluster tool. Piel, J. Ph.; Boher, P.; Stehle´, J. L.; Pickering, C. // AIP Conference Proceedings;2001, Vol. 550 Issue 1, p538 

    For any industrial integrated metrology application three key issues must be addressed - feasibility, applicability and cost-effectiveness. This paper reports progress on the integration of spectroscopic ellipsometry (SE) in the cool-down chamber. SE is capable of providing rapid information on...

  • Absolute calibration of nuclear activation diagnostics for intense pulsed ion beams. Young, F.C.; Boller, J.R.; Stephanakis, S.J. // Review of Scientific Instruments;Jun96, Vol. 67 Issue 6, p2182 

    Describes absolute calibration of an annihilation-radiation sodium iodide (NaI) coincidence detection system for short-lived ion-induced radioactivity. Incident proton intensity; Comparison of absolute fluences of pulsed proton beams with ion beam fluences measured by carbon calorimetry.

  • Apparatus for the rapid measurement of electrical transport properties for both "needle-like" and bulk materials. Pope, A. L.; Littleton, R. T.; Tritt, Terry M. // Review of Scientific Instruments;Jul2001, Vol. 72 Issue 7, p3129 

    Described in this article is an apparatus in which thermopower and resistivity can be measured almost simultaneously from 10 to 300 K in a closed cycle refrigerator system. A distinction of this system is that the samples are mounted on integrated circuit (IC) chips for rapid introduction of the...

  • A calibration standard for laser-Doppler perfusion measurements. Liebert, A.; Leahy, M.; Maniewski, R. // Review of Scientific Instruments;Nov95, Vol. 66 Issue 11, p5169 

    Describes the development of a calibration standard for the laser-Doppler perfusion monitors. Inadequacies of the common method of calibration that relies on the Brownian motion of latex microspheres in water solution; Power spectral density of laser-Doppler signals; Introduction of a static...

  • NEW MATERIALS AND COMPONENTS. Mandelis, Andreas // Review of Scientific Instruments;Jun99, Vol. 70 Issue 6, p2886 

    Features materials and components for a variety of scientific instruments. Portable gas meter; Single and multiport solar simulators; Miniature calibration ultraviolet lamps; Miniaturized instruments for high-speed bridge measurements; Product literature and software.

  • Simple and reliable system for gas flow regulation and measurement. Sanders, William A.; Bogan, Denis J.; Hand, Clifford W. // Review of Scientific Instruments;Dec1986, Vol. 57 Issue 12, p3059 

    An automatic regulation and measurement system for the delivery of gases at flow rates from about 0.01 to 1 cm³ (STP)/s is described. Flow measurement is based on the familiar direct method of determining pressure drop per unit time in a calibrated volume. The regulation and measurement...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics