TITLE

The resonant behavior of segmented piezoceramic tubes

AUTHOR(S)
Tapson, J.; Greene, J.R.
PUB. DATE
July 1997
SOURCE
Review of Scientific Instruments;Jul97, Vol. 68 Issue 7, p2797
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Focuses on the resonant behavior of segmented piezoceramic tubes widely used as scanning actuators in scanning probe microscopes. Measurements of off-axis resonant response; Dependence of the resonant behavior on the mounting of the tube base.
ACCESSION #
4272753

 

Related Articles

  • PIEZO Precision. Lowe, Mary // Appliance Design;Jan2006, Vol. 54 Issue 1, p34 

    The article focuses on Elliptecmotor, the piezoelectric motor and actuator from Elliptec of Dormund, Germany. It discusses piezoelectric effect. The advantages of the Elliptec motor and actuator over other piezoelectric motors are explored. It describes the impact of piezo ceramic on the...

  • Analysis of a Partially Debonded Conducting Rigid Elliptical Inclusion in a Piezoelectric Matrix. Xu Wang; Ya-peng Shen // Applied Mathematics & Mechanics;Jan2001, Vol. 22 Issue 1, p35 

    A closed-form full-field solution for the problem of a partially debonded conducting rigid elliptical inclusion embedded in a piezoelectric matrix is obtained by employing the eight-dimensional Stroh formula in conjunction with the techniques of conformal mapping, analytical continuation and...

  • Design, identification, and control of piezoactuated positioning mechanism based on adaptive inverse method. Ru, C.; Shao, B.; Chen, L.; Rong, W.; Sun, L. // Proceedings of the Institution of Mechanical Engineers -- Part I;Sep2008, Vol. 222 Issue 6, p501 

    Precision positioning mechanisms using piezoelectric stack actuators have a very wide range of applications. However, loss of tracking positioning precision in piezoelectric actuators occurs as a result of hysteresis during long-range applications and creep effects. This paper proposes two...

  • Morphotropic phase boundary and high temperature dielectric, piezoelectric, and ferroelectric properties of (1-x)Bi(Sc3/4In1/4)O3-xPbTiO3 ceramics. Hu, Zhongqiang; Chen, Jianguo; Li, Meiya; Li, Xiaotian; Liu, Guoxi; Dong, Shuxiang // Journal of Applied Physics;Sep2011, Vol. 110 Issue 6, p064102 

    Piezoelectric ceramic (1 - x)Bi(Sc3/4In1/4)O3-xPbTiO3 (BSIPT) (0.45 ≤ x ≤ 0.70) solid solutions near the morphotropic phase boundary (MPB) were developed for high temperature piezoelectric transducer and actuator applications. It was found that the MPB composition of BSIPT ceramics...

  • Shear response of lead zirconate titanate piezoceramics. Mueller, V.; Zhang, Q. M. // Journal of Applied Physics;4/1/1998, Vol. 83 Issue 7, p3754 

    Presents information on the evaluation of the piezoelectric shear strain S5 of several commerical lead zirconate titanate (PZT) piezoceramics. Findings on both the piezoelectric and dielectric coefficients of PZT; Details on the experiment; Results of experiment.

  • Distortion-free, calibrated LiNbO3 piezoscanner for probe microscopes with atomic resolution. Heider, U.; Weis, O. // Review of Scientific Instruments;Dec1993, Vol. 64 Issue 12, p3534 

    We developed a piezoelectric scanner for probe microscopes that uses only single-domain LiNbO3 crystals as a piezoelectric transducer material in order to avoid nonlinearity, hysteresis, and creep that is always present in piezoelectric ceramics. A raster area of about 50×50 nm2 is within...

  • A piezoelectric pseudoshear multilayer actuator. Wang, Qing-Ming; Cross, L. E. // Applied Physics Letters;5/4/1998, Vol. 72 Issue 18 

    A type of high strain piezoelectric ceramic actuator, namely, pseudoshear multilayer actuator, is described. In this structure, a stack of prepoled rectangular piezoelectric transducer ceramic sheets are conductively bonded at alternate ends, while the bottom layer bonded on a fixed base. When...

  • Dynamic Preisach modelling of hysteresis for the piezoceramic actuator system. Yu, Y; Xiao, Z; Naganathan, N G; Dukkipati, R V // Proceedings of the Institution of Mechanical Engineers -- Part C;2001, Vol. 215 Issue 5, p511 

    A rate-dependent hysteresis property is a common phenomenon in various hysteretic systems including the piezoceramic material system. The dynamic Preisach model is needed to describe the rate-dependent hysteresis. This paper proposes a new dynamic Preisach model by introducing the dependence of...

  • Nondestructive characterization of PZT materials for sensor and actuator applications. Scherer, V.; Hirsekorn, S.; Rabe, U.; Arnold, W. // AIP Conference Proceedings;2000, Vol. 509 Issue 1, p1493 

    Ceramic materials with heterogeneous phase content and internal boundaries are unique in their electromechanical properties. Due to the interaction between those properties, these so-called multifunctional materials are suited for the realization of parts that have to yield complex functions in...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics