Inversion of complex V(z) at high frequencies for acoustic microscopy

Duquesne, J.Y.
July 1996
Review of Scientific Instruments;Jul96, Vol. 67 Issue 7, p2656
Academic Journal
Describes a phase-measuring acoustic microscope operating at high frequency. Phase and amplitude of the acoustic reflectance; Attenuation in the coupling fluid.


Related Articles

  • Grazing incidence reflectivity and total electron yield effects in soft x-ray absorption... Alders, D.; Hibma, T. // Journal of Applied Physics;9/15/1997, Vol. 82 Issue 6, p3120 

    Reports on a study on the grazing incidence absorption and reflection spectra of NiO in the region of Ni2p edge. Distortion of the near edge spectrum by the critical angle behavior; Enhancement of the weight line shapes like charge transfer satellites; Physical origin for the improved separation...

  • Modification of the scanning laser acoustic microscope for holographic and tomographic imaging. Lee, Hua; Ricci, Carlos // Applied Physics Letters;11/17/1986, Vol. 49 Issue 20, p1336 

    In this letter, we report the modification of the scanning laser acoustic microscope for the purpose of holographic and tomographic imaging. A very simple quadrature receiver is utilized to perform holographic recording of the resultant acoustic wave field. This quadrature detector mainly...

  • Microscopic imaging of residual stress using a scanning phase-measuring acoustic microscope. Meeks, Steven W.; Peter, D.; Horne, D.; Young, K.; Novotny, V. // Applied Physics Letters;10/30/1989, Vol. 55 Issue 18, p1835 

    A high-resolution scanning phase-measuring acoustic microscope (SPAM) has been developed and used to image the near-surface residual stress field around features etched in sputtered alumina via the acoustoelastic effect. This microscope operates at 670 MHz and has a resolution of 5–10...

  • Scanning electron acoustic microscopy of indentation-induced cracks and residual stresses in ceramics. Cantrell, John H.; Qian, Menglu; Ravichandran, M. V.; Knowles, K. M. // Applied Physics Letters;10/29/1990, Vol. 57 Issue 18, p1870 

    The ability of scanning electron acoustic microscopy (SEAM) to characterize ceramic materials is assessed. SEAM images of Vickers indentations in SiC whisker-reinforced alumina clearly reveal not only the radial cracks, the length of which can be used to estimate the fracture toughness of the...

  • Acoustically Mapping IGBT Module Solder Thickness. Adams, Tom // Power Electronics Technology Exclusive Insight;11/5/2012, p1 

    The article features the Time Difference Mode in the C-SAM$#174; acoustic microscopes from Sonoscan.

  • High-performance acoustic microscope. Atalar, Abdullah; Hoppe, Martin // Review of Scientific Instruments;Oct86, Vol. 57 Issue 10, p2568 

    A commercial scanning acoustic microscope operating in the frequency range of 50-2000 MHz is described. It has a stable scan mechanism suitable for the high-frequency end to give highresolution images and modes to allow for material characterization at the low-frequency end. The high-frequency...

  • Precision phase measurement with short tone burst signals in acoustic microscopy. Liang, K. K.; Bennett, S. D.; Kino, G. S. // Review of Scientific Instruments;Mar86, Vol. 57 Issue 3, p446 

    A new phase measurement system based on a sychronous detection scheme is described. It is capable of yielding high precision phase data with very short tone bursts. A theoretical analysis of the system is given and system performance characteristics are also discussed. This phase measurement...

  • Characterizing mechanical resonators by means of a scanning acoustic force microscope. Sthal, F.; Bourquin, R. // Applied Physics Letters;9/18/2000, Vol. 77 Issue 12 

    A method of characterizing resonators is presented. This method is based on scanning acoustic force microscopy. Data on the topography and the vibration amplitude of the resonator are obtained simultaneously, by means of atomic force interaction. The normal component of the surface vibration of...

  • Differential amplitude contrast in acoustic microscopy. Nikoonahad, M. // Applied Physics Letters;11/23/1987, Vol. 51 Issue 21, p1687 

    A differential amplitude contrast scanning acoustic microscope is described. The operation of this system resides on a two-beam acoustic lens which produces two adjacent spots at its focal plane. The signals received from these two foci are first amplitude demodulated and then electronically...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics