Externally deposited phase-compensating dielectric mirrors for asymmetric Fabry-Perot cavity tuning

Karim, Z.; Kyriakakis, C.
May 1994
Applied Physics Letters;5/30/1994, Vol. 64 Issue 22, p2913
Academic Journal
Examines externally deposited phase-compensating dielectric mirrors for asymmetric Fabry-Perot cavity tuning. Demonstration of a post-growth ability to fine-tune the location of the Fabry-Perot minima; Composition of the dielectric multilayer mirrors; Exhibition of a pi radian phase difference in the inverted and noninverted configurations.


Related Articles

  • A miniature tunable coupled-cavity laser constructed by micromachining technology. Cai, H.; Liu, A. Q.; Zhang, X. M.; Tamil, J.; Tang, D. Y.; Zhang, Q. X.; Lu, C. // Applied Physics Letters;1/21/2008, Vol. 92 Issue 3, p031105 

    This letter presents a miniature tunable coupled-cavity laser by integrating a Fabry-Pérot chip, a gain chip and a deep-etched parabolic mirror using micromachining technology. The mirror is to actively adjust the gap between chips, enabling the optimal mode selection. Single-mode operation...

  • Integrated-mirror étalons for 1.3-μm operation grown by molecular-beam epitaxy. Khitrova, G.; Iwabuchi, T.; Chuang, C. L.; Yoon, T. // Journal of Applied Physics;5/1/1991, Vol. 69 Issue 9, p6704 

    Presents a study that described the design and growth of a Fabry-Pérot étalon for operation at 1.3 µm. Approach to demultiplexing a several-GHz data stream; Calculated response of integrated mirrors; General features of the étalon grown by molecular-beam epitaxy.

  • Experimental demonstration of the use of a Fabry–Perot cavity as a mirror of variable reflectivity. Strain, K. A.; Hough, J. // Review of Scientific Instruments;Apr94, Vol. 65 Issue 4, p799 

    The use of a spherical mirror Fabry-Perot cavity as a mirror of variable reflectivity for near monochromatic light is demonstrated herein. The results of an experimental test of two control systems for the variable mirror are presented. It is shown that the reflectivity of our mirror can be...

  • Vibration Free Interferometer Mirror. Yaltkaya, S. // AIP Conference Proceedings;2007, Vol. 899 Issue 1, p689 

    Optic tables may be an obstacle for the interferometric studies when they are exposed to mechanical vibrations in the particular frequency range. To reduce the mechanical noise, a moveable mirror of the FTIR spectrometer was used as an interferometer mirror. The vibration response of this mirror...

  • Anti-reflection resonance in distributed Bragg reflectors-based ultrathin highly absorbing dielectric and its application in solar cells. Zhang, Xu-Lin; Song, Jun-Feng; Li, Xian-Bin; Feng, Jing; Sun, Hong-Bo // Applied Physics Letters;3/11/2013, Vol. 102 Issue 10, p103901 

    We present a design of anti-reflection resonance in distributed Bragg reflectors (DBRs) based ultrathin highly absorbing dielectric. In such structure, anti-reflection resonance can be supported at wavelengths much longer than those achieved by the previous metal-based structure due to the...

  • New automatic system for multipass Fabry-Pérot alignment and stabilization. Salvato, G.; Ponterio, R. C.; Aliotta, F. // Review of Scientific Instruments;Nov2006, Vol. 77 Issue 11, p113104 

    We present a new automatic system for Brillouin scattering experiments employing a double pass Fabry-Pérot interferometer. The main characteristics of the system are a new procedure for reaching and maintaining mirror parallelism over time and the complete automation of most of the tasks...

  • A fabry-perot resonator with periodic structures used as reflecting mirrors: A novel basis for observation of gravitational waves. Pustovoĭt, V. // Doklady Physics;Apr2006, Vol. 51 Issue 4, p165 

    The article presents information on a fabry-perot interferometer with periodic structures which is used as reflecting mirrors to detect gravitational waves. The fabry-perot resonator is also used to develop methods of small-displacement measurement, small-size Fourier spectrometers with a rather...

  • Femtosecond laser fabrication of high reflectivity micromirrors. Brodoceanu, D.; Cole, G. D.; Kiesel, N.; Aspelmeyer, M.; Bäuerle, D. // Applied Physics Letters;7/26/2010, Vol. 97 Issue 4, p041104 

    High-quality freestanding micromirrors consisting of 40 dielectric layers on silicon have been fabricated by ultrashort-pulse laser ablation in combination with laser-assisted wet chemical etching. Backside material removal enables direct access to both faces of the dielectric coating. The...

  • Diffractive laser resonator is easily adjusted.  // Laser Focus World;Dec2005, Vol. 41 Issue 12, p26 

    The article reports that researchers from Germany have created two resonator mirrors as diffractive structures on a common flat substrate. A plane third reflective mirror is to be adjusted only like a plane mirror in an ordinary Fabry-Perot interferometer. A diffractive structure is seen when...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics