Electro-optic and all-optical phase modulator on an indium tin oxide single-mode waveguide

Chen, R.T.; Robinson, D.
March 1992
Applied Physics Letters;3/30/1992, Vol. 60 Issue 13, p1541
Academic Journal
Performs an electro-optic and all-optical phase modulation on an indium tin oxide single-mode waveguide. Determination of waveguide propagation losses for transverse magnetic and transverse electric guided waves; Modulation of band gap energy; Measurement of modulation depth for current injection modulation.


Related Articles

  • Laser-compatible InGaAs/GaAs strained layer waveguide electroabsorption modulators. Moss, D.; Williams, R.L.; Dion, M.; Landheer, D. // Applied Physics Letters;12/9/1991, Vol. 59 Issue 24, p3139 

    Presents laser-compatible indium gallium arsenide/gallium arsenide waveguide electroabsorption modulators. Determination of the contrast ratios; Exhibition of broad area threshold current densities; Measurement of lasing wavelength versus cavity length.

  • All-optical modulation in crystalline organic semiconductor waveguides. Zang, D.Y.; Forrest, S.R. // Applied Physics Letters;1/13/1992, Vol. 60 Issue 2, p189 

    Demonstrates all-optical modulation in crystalline organic semiconductor waveguides. Use of two light beams as guided and pump light sources; Observation of the refractive index change; Factor attributing the large nonlinear effect; Importance of carrier lifetime for the modulator switching time.

  • Polymeric multimode waveguide based electro-optic modulator with a vertically configured dumping planar waveguide. Lu, Xuejun; Jang, Chiou-hung; An, Dechang; Zhou, Qingjun; Sun, Lin; Zhang, Xuping; Chen, Ray T.; Dawson, Dan // Applied Physics Letters;7/29/2002, Vol. 81 Issue 5, p795 

    An electro-optic modulator based on a polymeric multimode waveguide coupler was developed. A guiding multimode waveguide with a vertically configured dumping planar waveguide was employed in the design to increase the device packing density. A modulation depth of 91% at 1330 nm was...

  • Process technique makes silica waveguide modulators feasible.  // Laser Focus World;May94, Vol. 30 Issue 5, p13 

    Reports on the development of an electro-optic phase modulation technique in fused-silica channel waveguides at Stanford University in California. Creation of buried waveguides in silica by low-energy electron-beam irradiation; Induced index change; Advantages of silica over lithium niobate.

  • Buried modes in combined Ti diffused and Li outdiffused LiNbO[sub 3] slab waveguides. Arad, Eli; Ruschin, Shlomo; Nir, David // Applied Physics Letters;5/3/1993, Vol. 62 Issue 18, p2194 

    Examines buried modes in combined titanium diffused and lithium outdiffused lithium niobate slab waveguides. Excitation of modes by end-fire fiber coupling; Variation of the number of modes; Presentation of a mode-extinction modulator based on buried channel configuration.

  • Transfer-matrix analysis of waveguide phase modulator using the linear electro-optic effect of asymmetric quantum wells. Chen, Y. W.; Li, H. S.; Zhou, Z.; Wang, K. L. // Journal of Applied Physics;10/15/1994, Vol. 76 Issue 8, p4903 

    Presents information on a study that examined the phase modulation of asymmetric quantum-well embedded waveguides. Research method; Results and discussion on the study.

  • Electric field-induced optical waveguide intensity modulators using GaAs/Al[sub x]Ga[sub 1-x]As... Wickman, R.W.; Moretti, A.L.; Stair, K.A.; Bird, T.E. // Applied Physics Letters;2/18/1991, Vol. 58 Issue 7, p690 

    Demonstrates a new waveguide intensity modulator that used the field-dependent refractive index change associated with quantum wells to control the lateral confinement of light in a slab waveguide. Results of operating at photon energies below the zero field electron-heavy hole transition...

  • Passive Ti:LiNbO3 channel waveguide TE-TM mode splitter. Yap, D.; Johnson, L. M.; Pratt, G. W. // Applied Physics Letters;1984, Vol. 44 Issue 6, p583 

    A passive compact TE-TM mode splitter has been demonstrated using Ti:LiNbO3 channel waveguides. Its operation is based on the interference between the two guided modes of a double-mode waveguide segment connecting single-mode input and output guides. A device made using one set of design...

  • DCM-polyimide system for triple-stack poled polymer electro-optic devices. Ermer, S.; Valley, J.F. // Applied Physics Letters;11/9/1992, Vol. 61 Issue 19, p2272 

    Presents an all-polyimide system suitable for fabrication of electro-optic wave guide devices on silicon substrates. Source of cladding layers; Components of the electro-optic material; Fabrication of an all-polyimide Mach-Zehnder modulator.


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics