Single-mode selection using coherent imaging within a slab waveguide CO[sub 2] laser

Abramski, K.M.; Baker, H.J.
May 1992
Applied Physics Letters;5/18/1992, Vol. 60 Issue 20, p2469
Academic Journal
Describes the single mode selection technique for a slab waveguide carbon dioxide (CO[sub 2]) laser. Magnitude of outpower power produced by an in-cavity grid; Implication of Talbot effect for coherent imaging; Compatibility of waveguide CO[sub 2] lasers with diffusion cooling.


Related Articles

  • Pulsed Q-switched CO2 waveguide laser. Al-Shiraida, Y. S.; Paulson, M.; Rosadiuk, T.; Tulip, J.; Pace, P. // Review of Scientific Instruments;Jul1992, Vol. 63 Issue 7, p3575 

    The performance of an rf-excited CO2 waveguide laser which was synchronously pulsed and electro-optically Q switched is described. Output power of up to 14 kW in 50 ns was achieved which was significantly higher than powers previously obtained from reported Q-switched CO2 waveguide lasers....

  • Measurements of transverse-gain profiles in rf- and dc-excited CO2 gain cavities. Sharp, Richard C. // Journal of Applied Physics;6/1/1987, Vol. 61 Issue 11, p5184 

    Focuses on study which conducted spatially resolved transverse-gain profile measurements in radio frequency- and direct current-excited waveguidelike cavities for carbon dioxide laser gas mixtures. Requirements for spatially resolving the gain profile; Impact of the current density and gas...

  • Life problems of dc and rf-excited low-power cw CO2 waveguide lasers. Hochuli, U. E.; Haldemann, P. R. // Review of Scientific Instruments;Sep86, Vol. 57 Issue 9, p2238 

    A number of different, rf-excited 3-W cw CO2 waveguide lasers have been built. Four of these lasers, after continuously working for 15 000–30 000 h, still yield about 70% of their original power output. The design variations cover N2- and CO-bearing gas mixtures, as well as internal- and...

  • A sealed-off tunable boron nitride waveguide CO2 laser. Xiaoyong, Hu; Fengmei, Liu; Taixun, Zhu; Jingshan, Zhao; Shuqin, Lou // Review of Scientific Instruments;Feb1991, Vol. 62 Issue 2, p546 

    This note first reports the operation and the characteristics of a completely sealed boron nitride (BN) waveguide CO2 laser with an operating time of over 400 h. Up to now it was still operating with an output power of 1.8 W. The original power output was 2.1 W.

  • Phase locking of adjacent channel leaky waveguide CO2 lasers. Youmans, D. G. // Applied Physics Letters;1984, Vol. 44 Issue 4, p365 

    Phase locking has been achieved between two adjacent waveguide CO2 lasers separated by a thin plate of ZnSe. Radiation leakage from one waveguide to the other through the ZnSe causes the phase locking, and stationary interference fringes demonstrate the relative phase stability. Both waveguide...

  • Combining a new CO laser wave guide with transoral robotic surgery: a feasibility study on four patients with malignant tumors. Remacle, Marc; Matar, Nayla; Lawson, Georges; Bachy, Vincent; Delos, Monique; Nollevaux, Marie-Cécile // European Archives of Oto-Rhino-Laryngology;Jul2012, Vol. 269 Issue 7, p1833 

    We present a series of patients treated by transoral robotic surgery (TORS) using a new CO laser wave guide (CO LWG) (Lumenis, Santa Clara, CA). Patients older than 18 years, with malignant pharyngo-laryngeal tumors were enrolled in this prospective study after signing an informed consent. Four...

  • Line-tunable oscillation of a cw NH3 laser from 10.7 to 13.3 μm. Rolland, C.; Reid, J.; Garside, B. K. // Applied Physics Letters;1984, Vol. 44 Issue 4, p380 

    A cw CO2 laser operating on the R(30) 9-μm transition is down shifted by 180 MHz in a pair of acousto-optic modulators, and used to optically pump sR(5,0) transition of NH3 at line center. Vibrational inversion is created in the ν2 mode, and cw oscillation is observed on 20 different NH3...

  • Generation of a uniform high-density microwave plasma for CO2 lasers using orthogonal electric fields. Saito, K.; Kimura, M.; Uchiyama, T. // Applied Physics B: Lasers & Optics;Mar2006, Vol. 82 Issue 4, p621 

    To realize a CO2 laser using a fast-axial-flow high-output-power microwave discharge excitation, we devised a technology for making the microwave discharge uniform by varying the oscillation direction of an electric field with time. We also verified the effectiveness of this technology. As a...

  • Silver halide planar waveguides and grating couplers for middle infrared integrated optics. Dekel, B.; Katzir, A. // Applied Physics Letters;12/13/2010, Vol. 97 Issue 24, p241106 

    We fabricated silver bromide (AgBr) planar waveguides with a thickness of ≈20 μm and designed reflective grating couplers for coupling the radiation of a tunable CO2 laser into these waveguides. We found that the attenuation was 6-9 dB/cm. The waveguides were used as attenuated total...

  • Electromagnetic Simulation of Coupled Silicon and Diamond Microdisks and Slab Waveguides in the Mid-infrared. Chaudhry, Muhammad Rehan; Rashid, Zeeshan; Uysallı, Yiğit; Kurt, Adnan; Gökay, Ulaş Sabahattin; Serpengüzel, Ali // PIERS Proceedings;Jul2015, p95 

    Electromagnetic numerical studies of silicon and diamond microdisks coupled with silicon and diamond slab waveguides are performed in the CO2 laser emission region in the mid-infrared. Microdisk is the 2D analog of the microsphere and the slab waveguide is the 2D analog of the rectangular...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics