TITLE

Molecular beam epitaxy growth of vertical cavity optical devices with in situ corrections

AUTHOR(S)
Bacher, K.; Pezeshki, B.
PUB. DATE
September 1992
SOURCE
Applied Physics Letters;9/21/1992, Vol. 61 Issue 12, p1387
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Demonstrates the molecular beam epitaxy growth of vertical cavity optical devices. Effects of the mismatch in mirror reflectivities on the Fabry-Perot dip; Measurement of the structure for epitaxial growth layers; Use of measurements for the wavelength of the cavity resonance.
ACCESSION #
4254993

 

Related Articles

  • Midinfrared, optically pumped, unstable resonator lasers. Ongstad, A. P.; Kaspi, R.; Dente, G. C.; Tilton, M. L.; Chavez, J. // Applied Physics Letters;5/7/2007, Vol. 90 Issue 19, p191107 

    The authors describe high-brightness, broad area midinfrared semiconductor lasers. These devices were fabricated in the authors’ laboratory using a commercial solid-source molecular beam epitaxial system. The laser structures incorporated 14 type-II quantum wells embedded in thick...

  • Dynamic properties of InAs/InP (311)B quantum dot Fabry–Perot lasers emitting at 1.52 μm. Martinez, A.; Merghem, K.; Bouchoule, S.; Moreau, G.; Ramdane, A.; Provost, J.-G.; Alexandre, F.; Grillot, F.; Dehaese, O.; Piron, R.; Loualiche, S. // Applied Physics Letters;7/14/2008, Vol. 93 Issue 2, p021101 

    Dynamic properties of truly three-dimensional-confined InAs/InP quantum dot (QD) lasers obtained by molecular beam epitaxy growth on a (311)B oriented substrate are reported. The relative intensity noise and small signal modulation bandwidth experiments evidence maximum relaxation frequency of...

  • Multi-wavelength fiber laser based on a fiber Fabry-Perot interferometer. Estudillo-Ayala, J.; Jauregui-Vazquez, D.; Haus, J.; Perez-Maciel, M.; Sierra-Hernandez, J.; Avila-Garcia, M.; Rojas-Laguna, R.; Lopez-Dieguez, Y.; Hernandez-Garcia, J. // Applied Physics B: Lasers & Optics;Dec2015, Vol. 121 Issue 4, p407 

    In this work we report experimental studies of an erbium-doped fiber laser design that simultaneously emits up to three wavelengths. The laser cavity configuration has an all-fiber, Fabry-Perot interferometer, based on the insertion of air cavities in the fiber, near one end of a conventional...

  • Diffractive laser resonator is easily adjusted.  // Laser Focus World;Dec2005, Vol. 41 Issue 12, p26 

    The article reports that researchers from Germany have created two resonator mirrors as diffractive structures on a common flat substrate. A plane third reflective mirror is to be adjusted only like a plane mirror in an ordinary Fabry-Perot interferometer. A diffractive structure is seen when...

  • Characteristics of absorption Fabry–Pérot modulators due to the influence of coupled cavities. Law, Kwok-Keung // Journal of Applied Physics;3/1/1995, Vol. 77 Issue 5, p1864 

    Examines the influence of optical feedback from coupled cavities on the reflective responses of absorption-tunable Fabry–Peérot resonators. Merits and improvements in performance of optical modulators utilizing the designs of coupled Fabry–Peérot resonators; Function of the...

  • High-finesse (Al,Ga)As interference filters grown by molecular beam epitaxy. Jewell, J. L.; Lee, Y. H.; McCall, S. L.; Harbison, J. P.; Florez, L. T. // Applied Physics Letters;8/22/1988, Vol. 53 Issue 8, p640 

    We have measured finesse values of at least 160 in (Al,Ga)As Fabry–Perot interference filters grown by molecular beam epitaxy. Losses are low and the finesses are close to predicted values, suggesting that with additional mirror layers much higher finesse should be achievable. This has...

  • Integrated-mirror étalons for 1.3-μm operation grown by molecular-beam epitaxy. Khitrova, G.; Iwabuchi, T.; Chuang, C. L.; Yoon, T. // Journal of Applied Physics;5/1/1991, Vol. 69 Issue 9, p6704 

    Presents a study that described the design and growth of a Fabry-Pérot étalon for operation at 1.3 µm. Approach to demultiplexing a several-GHz data stream; Calculated response of integrated mirrors; General features of the étalon grown by molecular-beam epitaxy.

  • Temperature invariant lasing and gain spectra in self-assembled GaInAs quantum wire Fabry-Perot lasers. Wohlert, D. E.; Cheng, K. Y.; Chou, S. T. // Applied Physics Letters;2/19/2001, Vol. 78 Issue 8, p1047 

    GaInAs quantum wire (QWR) heterostructures have been grown by molecular beam epitaxy using the strain-induced lateral-layer ordering (SILO) process. Broad-area Fabry-Perot QWR lasers have been fabricated from this material. The lasing wavelength from the QWR laser shifts at a rate of 0.9...

  • Molecular beam epitaxy growth method for vertical-cavity surface-emitting laser resonators based.... Talghader, J.J.; Hadley, M.A. // Applied Physics Letters;12/18/1995, Vol. 67 Issue 25, p3774 

    Develops a molecular beam epitaxy growth monitoring method for distributed Bragg reflectors and vertical-cavity surface-emitting laser resonators. Basis of the method on the substrate thermal emission; Use of a monochromator to select cavity resonant wavelength; Theoretical modeling of the...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics