TITLE

In situ fabrication of superconducting Lu-Ba-Sr-Cu-O films by pulsed-laser deposition

AUTHOR(S)
Schwab, P.; Wang, X.Z.
PUB. DATE
April 1992
SOURCE
Applied Physics Letters;4/20/1992, Vol. 60 Issue 16, p2023
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Analyzes the fabrication of thin superconducting Lu-Ba-Sr-Cu-O films by pulsed-laser deposition. Preparation of single phase, LuBa[sub 2]Cu[sub 3]O[sub 7] films; Chemical compositions of the films; Techniques for synthesizing high-temperature materials.
ACCESSION #
4241198

 

Related Articles

  • Thin-film Bi-Sr-Ca-Cu-O high-temperature superconductors using pulsed laser evaporation from sintered disks. Guarnieri, C. Richard; Roy, R. A.; Saenger, K. L.; Shivashankar, S. A.; Yee, D. S.; Cuomo, J. J. // Applied Physics Letters;8/8/1988, Vol. 53 Issue 6, p532 

    Films of the high-temperature superconductor in the Bi-Sr-Ca-Cu-O system were deposited by pulsed laser evaporation from a ceramic disk. Films deposited onto (100) MgO show x-ray diffraction patterns characteristic of c-axis textured Bi2(Sr,Ca,Bi)3Cu2Ox phase following annealing for 10 min at...

  • In situ laser deposition of Y1Ba2Cu3O7-x high Tc superconducting thin films with SrTiO3 underlayers. Wiener-Avnear, E.; Kerber, G. L.; McFall, J. E.; Spargo, J. W.; Toth, A. G. // Applied Physics Letters;4/30/1990, Vol. 56 Issue 18, p1802 

    Thin films of Y1Ba2Cu3O7-x (YBCO) with and without underlayers of SrTiO3 (STO) were deposited via pulsed laser deposition onto substrates of sapphire and silicon-on-sapphire (SOS) in a single vacuum step. The YBCO films with STO underlayers displayed better superconducting transitions than the...

  • Reactive rapid sequential pulse laser deposition of YBa[sub 2]Cu[sub 3]O[sub 7]: A candidate to.... Watanabe, Yukio // Applied Physics Letters;3/7/1994, Vol. 64 Issue 10, p1295 

    Proposes the rapid sequential pulse laser deposition (PLD) of YBa[sub 2]Cu[sub 3]O[sub 7] films. Use of PLD to form ceramic thin films; Selection of a target material and laser power density; Methods of reducing the particulate density.

  • Pulsed laser etching of high Tc superconducting films. Inam, Arun; Wu, X. D.; Venkatesan, T.; Ogale, S. B.; Chang, C. C.; Dijkkamp, D. // Applied Physics Letters;10/5/1987, Vol. 51 Issue 14, p1112 

    Etching of Y-Ba-Cu-O superconducting thin films has been accomplished using a pulsed excimer laser (248 nm, 30 ns). Etch depth as a function of the number of laser pulses was linear over a wide range of incident laser energy densities. An etch threshold energy density of 0.11 J/cm2 was observed...

  • Substrate effects on the properties of Y-Ba-Cu-O superconducting films prepared by laser deposition. Venkatesan, T.; Chang, C. C.; Dijkkamp, D.; Ogale, S. B.; Chase, E. W.; Farrow, L. A.; Hwang, D. M.; Miceli, P. F.; Schwarz, S. A.; Tarascon, J. M.; Wu, X. D.; Inam, A. // Journal of Applied Physics;5/1/1988, Vol. 63 Issue 9, p4591 

    Discusses the preparation of superconducting thin films of y[sub1]-Ba[sub2]-Cu[sub3]-O[subx] with superconducting temperature and prepared by a laser deposition technique. Method used in film preparation; Effects of thermal stresses in the films; Composition of the film; Result of the x-ray...

  • In-situ patterned laser deposition of high-Tc Y-Ba-Cu-O superconducting thin films. Singh, R. K.; Narayan, J.; Singh, A. K.; Lee, C. B. // Journal of Applied Physics;4/1/1990, Vol. 67 Issue 7, p3448 

    Presents a study that carried out current density measurements on superconducting thin films which were in situ patterned during the laser deposition process. Reason for the viability of pulsed laser ablation for the deposition of superconducting thin films; Methods involved in the transport...

  • Low-temperature preparation of high Tc superconducting thin films. Wu, X. D.; Inam, A.; Venkatesan, T.; Chang, C. C.; Chase, E. W.; Barboux, P.; Tarascon, J. M.; Wilkens, B. // Applied Physics Letters;2/29/1988, Vol. 52 Issue 9, p754 

    Thin superconducting films of Y-Ba-Cu-O were prepared at 650 °C using the pulsed laser deposition technique. The as-deposited films were fully superconducting at low temperature (30 K). After annealing in oxygen at 450 °C for 3 h, the films exhibited superconductivity with zero resistance...

  • Large-area double-side pulsed laser deposition of YBa[sub2]Cu[sub3]O[sub7-x] thin films in 3-in. sapphire wafers. Lorenz, M.; Hochmuth, H.; Natusch, D.; Borner, H.; Lippold, G.; Kreher, K.; Schmitz, W. // Applied Physics Letters;6/3/1996, Vol. 68 Issue 23, p3332 

    Examines the pulsed laser deposition of YBa[sub 2]Cu[sub 3]O[sub 7-x] thin films on sapphire wafers. Formation of microwave C-band strip-line filters; Measurement of the critical current densities; Application of planar high-temperature superconducting strip line filters.

  • Recovery of original superconducting properties in ion-irradiated Y1Ba2Cu3O7-x thin films. Vadlamannati, S.; England, P.; Stoffel, N. G.; Ramesh, R.; Ravi, T. S.; Hwang, D. M.; Findikoglu, A.; Li, Q.; Venkatesan, T.; McLean, W. L. // Applied Physics Letters;11/19/1990, Vol. 57 Issue 21, p2265 

    The changes in the superconducting properties of in situ pulsed laser deposited Y1Ba2Cu3O7-x thin films caused by irradiation with 200 keV He+ ions are due to both oxygen loss as well as oxygen and cationic displacements induced by the irradiation. This is demonstrated by a study of the recovery...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics