TITLE

Far-infrared Fabry-Perot resonator with high T[sub c] YBa[sub 2]Cu[sub 3]O[sub 7-delta] films on

AUTHOR(S)
Pechen, E.V.; Vent, S.
PUB. DATE
October 1992
SOURCE
Applied Physics Letters;10/19/1992, Vol. 61 Issue 16, p1980
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Demonstrates the operation of far-infrared Fabry-Perot resonator with YBa[sub 2]Cu[sub 3]O[sub 3]O[sub 7-delta] thin films on silicon (Si) plates. Use of pulsed laser deposition to prepare the epitaxial films on the silicon plates; Analysis of the resonator transmissivity and reflectivity; Removal of the silicon oxide layer from the Si surface.
ACCESSION #
4240778

 

Related Articles

  • c-axis oriented ferroelectric thin films of Si-substituted PbTiO[sub 3] on Si(100) by pulsed laser deposition: Boost for nonvolatile memory application. Purandare, S. C.; Palkar, V. R.; John, J.; Multani, M. S.; Pinto, R. // Applied Physics Letters;3/9/1998, Vol. 72 Issue 10 

    It has been demonstrated that Si substitution in a PbTiO[sub 3] target helps to avoid the formation of a pyrochlore phase, which otherwise occurs during fabrication of the films directly on Si(100) by the pulsed laser deposition technique. The films are perfectly c-axis oriented. Moreover, the...

  • Effect of SiO2 buffer layers on the structure of SrTiO3 films grown on silicon by pulsed laser deposition. Tejedor, P.; Fuenzalida, V. M.; Briones, F. // Journal of Applied Physics;9/1/1996, Vol. 80 Issue 5, p2799 

    Presents a study that examined the effect of silicon oxide buffer layers on the structure of SrTiO[sub3] films grown on silicon by pulsed laser deposition. Experimental procedure; Results and discussion; Conclusion.

  • Preparation of SrTiO[sub 3] thin films on Si(100) substrates by laser ablation: Application as.... Sanchez, F.; Varela, M. // Applied Physics Letters;11/2/1992, Vol. 61 Issue 18, p2228 

    Examines the deposition of SrTiO[sub 3] thin films on silicon(100) by pulsed laser ablation. Characterization of the films; Exhibition of (h00) or (hh0) preferential orientations; Growth of the films without reaction with the substrates; Preparation of the silicon(100) substrates for removal of...

  • Laser Beam Epitaxy of HgCdTe/Si Heterostructures. Plyatsko, S. V.; Bergush, N. N. // Semiconductors;Apr2001, Vol. 35 Issue 4, p374 

    Laser-induced deposition was employed to grow HgCdTe thin films on Si substrate at a temperature of ... 190°C. Auger spectroscopy and optical and electrical measurements demonstrate that the quality of films obtained is strongly dependent on the type of source and quality of the Si substrates.

  • Room-temperature epitaxial growth of CeO[sub 2] (001) films on YSZ buffered Si(001) substrates. Trtík, V.; Sánchez, F.; Aguiar, R.; Maniette, Y.; Ferrater, C.; Varela, M. // Applied Physics A: Materials Science & Processing;1998, Vol. 67 Issue 4, p455 

    Abstract. CEO[sub 2](001) epitaxial thin films deposited on Si(001) with yttria-stabilized zirconia buffers have been obtained tot the first time at room temperature by pulsed-laser deposition. The influence of oxygen pressure on the crystal quality of CeO[sub 2] was studied for the films...

  • Linear dependence of both the hardness and the elastic modulus of pulsed laser deposited a-SiC... El Khakani, M.A.; Chaker, M.; O'Hern, M. E.; Oliver, W. C. // Journal of Applied Physics;11/1/1997, Vol. 82 Issue 9, p4310 

    Discusses the pulsed laser deposition of amorphous a-silicon carbide (SC) films onto either Si(100) or fused quart substrates. Determination of hardness and elastic modulus mechanical properties by nanoindentation; Formation of Si-C bonds by increasing the substrate deposition temperature;...

  • Pulsed laser ablation deposition of thin films on large substrates. Acquaviva, S.; Fernández, M.; Leggieri, G.; Luches, A.; Martino, M.; Perrone, A. // Applied Physics A: Materials Science & Processing;1999, Vol. 69 Issue 7, pS471 

    Abstract. We have designed and built an ultra-high vacuum chamber which allows thin film deposition on large area (up to 100 mm diameter) flat substrates and on three-dimensional substrates (e.g. 100 mm long, 50 mm diameter cylinders) by the pulsed laser deposition and reactive pulsed laser...

  • Surface Plasmon Resonance-Coupled Photoluminescence and Resistive Switching Behavior of Pulsed Laser-Deposited Ag:SiC Nanocermet Thin Films. Kamakshi, Koppole; Sekhar, K.; Almeida, A.; Moreira, J.; Gomes, M. // Plasmonics;Oct2015, Vol. 10 Issue 5, p1211 

    In this study, Ag:SiC nanocermets were prepared via rapid thermal annealing (RTA) of pulsed laser-deposited SiC/Ag/SiC trilayers grown on Si substrate. Atomic force microscope images show that silver nanoparticles (Ag NPs) are formed after RTA, and the size of NPs increases with increasing Ag...

  • Pulsed laser deposition of tantalum pentoxide film. Zhang, J.-Y.; Boyd, I.W. // Applied Physics A: Materials Science & Processing;2000, Vol. 70 Issue 6, p657 

    Abstract. We report thin tantalum pentoxide (Ta[sub 2]O[sub 5]) films grown on quartz and silicon substrates by the pulsed laser deposition (PLD) technique employing a Nd:YAG laser (wavelength lambda = 532 nm) in various O[sub 2] gas environments. The effect of oxygen pressure, substrate...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics