Evaluation of niobium transmission lines up to the superconducting gap frequency

Dierichs, M.M.T.M.; Feenstra, B.J.
July 1993
Applied Physics Letters;7/12/1993, Vol. 63 Issue 2, p249
Academic Journal
Evaluates the transmission lines of niobium for frequencies up to the superconducting gap frequency. Integration of superconducting microstrips in planar antennas; Measurement of spectral response by Fourier transform spectrometer; Observation of microstrip resonances at 650 gigahertz.


Related Articles

  • Superconducting resonator circuits at frequencies above the gap frequency. de Lange, G.; Kuipers, J. J.; Klapwijk, T. M.; Panhuyzen, R. A.; van de Stadt, H.; de Graauw, M. W. M. // Journal of Applied Physics;2/15/1995, Vol. 77 Issue 4, p1795 

    Analyzes the frequency response of three superconductive niobium (Nb) resonating circuits, formed by an Nb microstrip and an Nb tunnel junction. Information on superconductive striplines; Analysis of the use of materials for striplines as tuning circuits for heterodyne superconducting tunnel...

  • Electron heating by photon-assisted tunneling in niobium terahertz mixers with integrated niobium titanium nitride striplines. Leone, B.; Gao, J. R.; Klapwijk, T. M.; Jackson, B. D.; Laauwen, W. M.; de Lange, G. // Applied Physics Letters;3/12/2001, Vol. 78 Issue 11, p1616 

    We describe the gap voltage depression and current-voltage (I-V) characteristics in pumped niobium superconductor-insulator-superconductor junction with niobium titanium nitride tuning stripline by introducing an electron heating power contribution resulting from the photon-assisted tunneling...

  • Niobium titanium nitride-based superconductor-insulator-superconductor mixers for low-noise terahertz receivers. Jackson, B. D.; de Lange, G.; Zijlstra, T.; Kroug, M.; Klapwijk, T. M.; Stern, J. A. // Journal of Applied Physics;6/1/2005, Vol. 97 Issue 11, p113904 

    Integrating NbTiN-based microstrip tuning circuits with traditional Nb superconductor-insulator-superconductor (SIS) junctions enables the low-noise operation regime of SIS mixers to be extended from below 0.7 to 1.15 THz. In particular, mixers incorporating a NbTiN/SiO2/NbTiN microstrip tuning...

  • High speed data link between digital superconductor chips. Herr, Quentin P.; Smith, Andrew D.; Wire, Michael S. // Applied Physics Letters;4/29/2002, Vol. 80 Issue 17, p3210 

    Superconductor digital devices using single-flux-quantum (SFQ) data encoding offer higher speed at lower power than any other integrated circuit technology. For this very reason, interconnect is challenging. We report SFQ data transfer between chips flip chip mounted on a passive microstrip...

  • Simple computer aided design formula and network interpretation for loss evaluation in.... Ladret, D.; Migliaccio, C. // Applied Physics Letters;11/20/1995, Vol. 67 Issue 21, p3192 

    Presents a simple computer aided design formula and network interpretation for loss evaluation in microstrip superconductor-conductor bilayer structure. Influence of the thickness ratio of the two layers on bilayer losses; Requirements for the design of superconducting structures; Steps in the...

  • Light detection using high-Tc microstrip transmission lines as a probe of film homogeneity. Culbertson, J. C.; Newman, H. S.; Strom, U.; Pond, J. M.; Chrisey, D. B.; Horwitz, J. S.; Wolf, S. A. // Journal of Applied Physics;11/1/1991, Vol. 70 Issue 9, p4995 

    Examines the effects of light on high-temperature superconductor microstrip transmission lines under conditions for which a bolometric photoresponse is expected. Illustration of sample geometry and experimental setup; Schematic of a microstrip line composed of several segments.

  • High quality factor and coupling adjustment on a microstrip-line hairpin filter by using YBa[sub 2]Cu[sub 3]O[sub 7] and BaTiO[sub 3] patterned patches. Socorregut, R.; Hankey, J.; Hijazi, Y.; Vlasov, Yu. A.; Larkins, G. L. // AIP Conference Proceedings;2002, Vol. 614 Issue 1, p437 

    We have fabricated a microstrip hairpin bandpass filter. In order to maximize the quality factor of the filter, the microstrip lines were made of superconducting YBa[sub 2]Cu[sub 3]O[sub 7]. A thin layer of BaTiO[sub 3], patterned into patches, was deposited between the LaAlO[sub 3] and the...

  • Propagation of picosecond electrical pulses on a silicon-based microstrip line with buried cobalt... Roskos, Hartmut; Nuss, Martin C.; Goossen, Keith W.; Kisker, David W.; White, Alice E.; Short, Ken T.; Jacobson, Dale C.; Poate, John M. // Applied Physics Letters;6/10/1991, Vol. 58 Issue 23, p2604 

    Discusses the propagation of picosecond electrical pulses on a silicon-based microstrip line with buried cobalt silicide ground plane. Reduced dispersion shown by the transmission line; Comparison with a conventional microstrip line with the ground plane on the back of the substrate.

  • Microstrip resonators for electron-spin resonance. Wallace, W. J.; Silsbee, R. H. // Review of Scientific Instruments;Jul1991, Vol. 62 Issue 7, p1754 

    Direct detection of thin-film and interfacial electron-spin resonance (ESR) pushes conventional techniques to the noise limit for those techniques and requires use of large-area samples. Several microstrip resonator structures are compared here to conventional techniques and experimental results...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics